3. In Figure, the battery voltage is V=10 volts, and the values of the resistances, in ohms, are 100, 220,and Kas shown. Find: V= (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, (c) Power output of the battery, (d) Power input to each resistor. V 10002 220Q 13 1ΚΩ

3. In Figure, the battery voltage is V=10 volts, and the values of the resistances, in ohms, are 100, 220,and Kas shown. Find: V= (a) Total resistance seen by the battery, (b) Current measured by the ammeters shown in the figure, (c) Power output of the battery, (d) Power input to each resistor. V 10002 220Q 13 1ΚΩ

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter7: Parallel Circuits

Section: Chapter Questions

Problem 3PP: Using the rules for parallel circuits and Ohmslaw, solve for the missing values....

See similar textbooks

Similar questions

An inductance of 1 henry and a resistance of 2 ohms are connected in series with battery of 6 e-0.0001 volt. . No current is flowing initially. When will the current measure 0.5 ampere?
A direct current of 12.5 A flows in a 25-ohm resistance. Determine the maximum value of an alternating current that will produce heat at the same rate in this resistance. Expresss answer to the nearest hundredths.
Using Kirchhoff’s rules, a) find the current in each resistor shown in the figure and b) find the potential difference between points c and f.
In the figure the ideal batteries have emfs ɛ1 = 20.4 V, ɛ2 = 9.05 V, and ɛ3 = 5.40 V, and the resistances are each 2.40 Q. What are the (a) size and (b) direction (left or right) of current i,? (c) Does battery 1 supply or absorb energy, and (d) what is its power? (e) Does battery 2 supply or absorb energy, and (f) what is its power? (g) Does battery 3 supply or absorb energy, and (h) what is its power? (a) Number i Units (b) (c) (d) Number i Units (e) (f) Number i Units (g) (h) Number i Units
Question: A battery is charged from a constant dc source of 220 V through a chopper. The dc battery is to be charged from its internal emf of 90 V to 122 v. The battery has an internal resistance of 1 ohm for a constant charging current of 10 A. What is the range of duty сycle? Option 1: 0.55 to 0.7 Option 2: 0.2 to 0.4 Option 3: 0.45 to 0.6 Option 4: 0.3 to 0.5
Four cells each of 2.10 volt internal emf are parallel connected together to make a battery. The internal resistances are 0.004, 0.005, 0.003 and 0.0025 ohm. Calculate for parallel connections: (a) internal emf and resistance of the single equivalent cell (b) current for a terminal voltage of 1.95 volts, (c)current in each cell
1) Find the current through the ammeter A. 2) What are the polarity and emf of the battery E E , assuming it has negligible internal resistance? Express your answer with the appropriate units. Enter positive value if the polarity of the battery is the same as shown the figure and negative value in another case.
20. The resistance R and a 2 μF capacitor are connected in series across 200-V dc supply. Across the capacitor is a neon lamp that strikes at 120 volts. Calculate the value of R to make the lamp strikes 5 seconds after the switch has been closed. A. 4.89 kΩ B. 4.89 MΩ C. 2.73 MΩ D. 2.94 MΩ
4. All batteries in the infinite chain shown in the figure have emf E and internal resistance r (see figure). Find the resultant emf and internal resistance across A and B
1.1Solve the total resistance, total current, individual currents, and individual voltages of the following dc circuits.
In the figure R₁-3.41R, the ammeter resistance is zero, and the battery is ideal. What multiple of e/R gives the current in the ammeter? EH Number Units *E/R
From the figure below, determine the value of current I.