3. For a second-order system that yields a 15% overshoot and a settling time of 0.7 seconds, determinethe following: Damping Ratio, Natural Frequency, Rise Time, Peak time and the General 2nd OrderTransfer Function of the system.

Answered: Image /qna-images/answer/ad725155-f2c2-4872-9e27-30e9de957a9d.jpg

Answered: 3. For a second-order system that…

Power System Analysis and Design (MindTap Course List)

6th Edition

ISBN:9781305632134

Author:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Chapter12: Power System Controls

Section: Chapter Questions

Problem 12.4P

See similar textbooks

Similar questions

For a system if the value of peak overshoot is 26 %, then the value of damping ratio is .......
A thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small a relatively small surge limiting inductance B. A fixed capacitance and a relatively large surge limiting inducatance C. A variable capacitance and a relatively small surge limiting inductance D. A Variable capacitance and a relatively large surge limiting inducatnce
Q-3 A Cockcroft-Walton type voltage multiplier has ten stages with capacitances, all equal to 0.1 µF. The supply transformer secondary voltage is 100 kV at a frequency of 60 Hz. If the load current to be supplied is 5 mA, find (a) the percentage ripple, (b) the regulation, and (c) the optimum number of stages for minimum regulation or voltage drop.
(c)[ device needs to connect to a Diesel generator which generates sinusoidal AC power at 16.67 Hz. The amplitude or RMS value of the generator output voltage is adjustable. The area of cross-section of the core is 0.035 m². What constraints, if any, must be imposed on the The magnetic device of the figure is designed to operate with 240 V(rms) at 50HZ. For operation in a remote mining site, the use of this device, or the generator, if the device must be connected to the generator. You may assume that the peak B field in the core must be limited to 1.1 T to prevent magnetic saturation.
Q1)Fill in the following blanks : 1.lonization coefficients a .y are functions of ....... 2.Time lag for breakdown is ...... 3.Streamer mechanism of breakdown explains the phenomena of electrical breakdown of ....... 4.Paschen's law states that ....... 5. Minimum sparking potential of air is about ....... 6.At standard temperature and pressure the electric field at which breakdown occur in air with a small gap d (cm) is given by .....
Verify the following property of the twiddle factor:
١-The PMSM used in the industry due to: a- Their low noise. b- Their easy control arrangement. c- Their efficiency. 2- The BLDCM used in the industry due a- Their low noise. b- Their easy control arrangement. - Their efficiency. 3- The (PMSM) supplied by: a- DC voltage. b- AC voltage of sinusoidal waveform. C- AC voltage of trapezoidal waveform. Choices
a) It is applied direct current to RC circuit. Which figure does belong to power supply, which figure does belong to capacitor (explain answer precisely)? V Vc b) Define the 'time constant' relating with physical meaning. And write it down for RC circuits. c) What is the function of a capacitor in a circuit?
A Thyristor switched capacitor consists of: A. A fixed capacitance and a relatively small surge limiting inductance B. A fixed capacitance and relatively large surge limiting inductance C. A variable capacitance and a relatively smal surge limiting inductance D. A variable capacitance and a relatively large surge limiting inductance
For a second-order system that yields a 15% overshoot and a settling time of 0.7 seconds, determine the following: Damping Ratio, Natural Frequency, Rise Time, Peak time and the General 2nd Order
The effect/effects of increasing the damping ratio 5 of a second-order system is/are O a. The maximum overshoot decreases and the damped frequency decreases O b. The settling time decreases and the peak time increases O c. The maximum overshoot increases and the damped frequency decreases O d. The settling time decreases and the peak time decreases
4_ For the system shown in figure N°4, find the percentage overshoot, the settling time, the peak time and the rising time for a unit step input if the response is underdamped. Is it muffled? Say why? Construct the graph of the answer c(t).

SEE MORE QUESTIONS

Recommended textbooks for you

Power System Analysis and Design (MindTap Course …

Electrical Engineering

ISBN:

9781305632134

Author:

J. Duncan Glover, Thomas Overbye, Mulukutla S. Sarma

Publisher:

Cengage Learning