3. By considering the convex meniscus of mercury of density, r in a capillary glass tube of radius, r deduce with explanation and equations that the height, d is given by - 2y cose rpg where other symbols have their usual meanings. What is the significance of the minus sign.

3. By considering the convex meniscus of mercury of density, r in a capillary glass tube of radius, r deduce with explanation and equations that the height, d is given by - 2y cose rpg where other symbols have their usual meanings. What is the significance of the minus sign.

College Physics

1st Edition

ISBN:9781938168000

Author:Paul Peter Urone, Roger Hinrichs

Publisher:Paul Peter Urone, Roger Hinrichs

Chapter11: Fluid Statics

Section: Chapter Questions

Problem 27CQ: Considering the magnitude of typical arterial blood pressures, why are mercury rather than water...

See similar textbooks

Related questions

Q: What is Bernoulli's equation when there is no flow (V1 = v2 = 0)? %3D O AP=0 O AP=VP9AY O AP= pgAy O…

A: The speed of the flow at the inlet and outlet are given by v1=0v2=0

Q: In determining the volume of an irregular shaped object with a graduated cylinder, any air bubbles…

A: Density is defined as mass of the object divided by its volume. In measuring the volume of an…

Q: Water flowing out of a 15 mm diameter faucet fills a 1.7 L bottle in 13 s. (a) At what distance…

A: Determine the flow rate of the water through the faucet as follows. Q=Vt=1.7 L13 s=1.7×10-3 m313…

Q: 4) How much time does it take for the bucket to completely drain? Rudins ofbucket A、S iこ li1gm 不…

Q: A cowboy at a dude ranch fills a horse trough that is 1.53 m long, 61 cm wide, and 42 cm deep. He…

A: The expression for volume rate flow is, Vt=Av…

Q: A garden hose has an inside diameter of 16 mm, and water ﬂows through it at 3.0 m/s. At what rate…

Q: Figure P9.85 shows a water tank with a valve. If the valve is opened, what is the maximum height…

A: Given:Height of water in inlet tank above valve (h) = 10.0 m.Total length of outlet pipe (L) = 2.0…

Q: Derive an expression for capillary rise (or depression) between two vertical parallel plates. Then,…

Q: if a tube of 0.56 mm radius is introduced in water and it rises 18.9 mm by the capillary tube,…

Q: 7. A large container, 122 cm deep is filled with water. If a small hole is punched in its side 79.0…

Q: 14) A capillary tube in water has 6.0cm of the tube above water. If the capillary rise of the tube…

A: As it is given, The height of the tube is 7 cm. Water in the tube is 6 cm. As water is filled in the…

Q: The height h that a fluid will rise in a capillary tube decreases as the diameter Dof the tube…

A: The variable and its dimension are given below, h L D L w ML-2T-2 σ MLT-2

Q: Suppose you find a large animal bone in the woods, toolarge to fit in a beaker or flask. How might…

A: Introduction: When some object is submerged in water it experiences a buoyant force which is the…

Q: For the fiqure below, find the speed at which the water emerges af the bottom opening (A,). Give the…

A: Let v1 and v2 be the speeds of the liquid at A1 and A2 respectively. Let Pa be the atmospheric…

Q: 8. A large container, 108 cm deep is filled with water. If a small hole is punched in its side 81.0…

A: Answer:- Given Acceleration due to gravity (g) = 9.8 m/s2 Height of small hole punched in its…

Q: how to calculate volume of the fluid displaced from a partially submerged object?

A: As per the Archimedes principle, when an object is submerged either partially or fully in a fluid,…

Q: A glass capillary tube has a diameter of 2.00 mm and contains a small amount of liquid that forms a…

Q: A cube of wood whose edge is 12 mm is floating in a liquid in a glass with one of its faces parallel…

A: A) h = 12mm dw= 791 kg/m3 dl= 1296 kg/m3

Q: 51. . The blood flow speed through an aorta with a radius of 1.00 cm is 0.265 m/s. If hardening of…

A: The answer is below

Q: our answer in pascals. Pa Request Answer pur answer in atmospheres. ? atm

A: The pressure is given by Stevino law:P = ?*g*h with:P = pressure i Pascal [Pa]? = density of water…

Q: Human blood vessels can slightly change their radius (dilate/expand), adjusting the volume flow rate…

A: Blood is a viscous liquid that flows in our body through the blood vessels. This is a laminar flow…

Q: Oil is filled to a height of 10.0 cm in a small cylinder. If a hole is made 6.0 cm from the bottom…

Q: What is the pressure inside an alveolus having a radius of 2.50 X 10 m if the surface tension of the…

A: radius, r = 25 m surface tension, T = 0.025 N/m

Q: What must be the radius of the nozzle

A: Rate of liquid flow from a pipe remains same at all cross section for ideal flow in pipe.

Q: Water flows through a 15cm diameter pipe at 5m/s. The pipe is then restricted to a diameter of 7cm.…

A: The expression for the speed of the water in the smaller pipe is, A1v1=A2v2πr12v1=πr22v2v2=r12v1r22…

Q: What is the height difference reading on the U-Tube? * 1. Consider a low speed subronic wind tunnel…

Q: 11. How would yona determine ther density of an irregularly shaped rock?

Q: 2. A cylindrical tank with a diameter of 1.5 meters contains a fluid with specific gravity of 9.0.…

Q: Calculate the ratio of the heights to which water andmercury are raised by capillary action in the…

Q: olve the A spherical balloon is being filled with air at the rate of 100 cm/min. At what rate is the…

Q: 2. A pipe with a radius of 2 cm is connected to another pipe with a radius of1 cm. If the velocity…

Q: When physicians diagnose arterial blockages, they quote the reduction in flow rate. If the flow rate…

A: Write the expression for the flow rate. Here, Δp is the pressure difference, r is the radius, and l…

Q: Is it possible for a fluid in a tube to flow in the direction from low pressure to high pressure? If…

A: Yes it is possible.

Q: What is the pressure inside an alveolus having a radius of2.50×10−4 m if the surface tension of the…

Q: An incompressible fluied is flouing threugh a cicular conduit as shown in the below the veleaty…

A: Given: The velocity profile in an 8 cm diameter pipe is vz=0.11-r216 cm/s. Calculate the radius…

Q: Compute for the surface tension of a force of 3.65 x 10⁷ dyne acting on 7 m². (all answers in MKS…

A: Force, F = 3.65 x 10⁷ dyne Area, A = 7 m² 1. Force exerted, F = ? 2. Surface tension, T = ? 3.…

Q: When there is no atmospheric pressure, the pressure doubles when thr density of the fluid doubles.…

Q: One arm of a tube (open at both ends) containswater, and the other alcohol. If the two fluids meet…

Q: Water is dripping out of a conical funnel at a uniform rate of 2cm³/sec. The funnel has height of 15…

Q: What would be the behavior of an object that was immersed in a fluid if the object and the fluid had…

A: Answer:- If an object that was immersed in a fluid if the object and the fluid had the same…

Q: A largest tank open to the atmosphere at the top and filled with water develops a small hole in its…

Concept explainers

Variation of pressure

From the equation of pressure, pressure is directly proportional to the applied force.

Question

100%

3. By considering the convex meniscus of mercury of
density, r in a capillary glass tube of radius, r deduce with
explanation and equations that the height, d is given
by
- 2y cose
rpg
where other symbols have their usual meanings. What is
the significance of the minus sign.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 4 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

A straightforward method of finding the density of an object is to measure its mass and then measure its volume by submerging it in a graduated cylinder. What is the density of a 240-g rock 89.0 cm3 of water? (Note that the accuracy and practical applications of this technique are more limited than a variety of others that are based on Archimedes' principle.)
A certain hydraulic system is designed to exert a force 100 times as large as the put into it. (a) What must be the ratio of the area of the cylinder that is being controlled to area of the master cylinder? (b) What must be the ratio of their diameters? (c) By what factor is the distance through which the output force moves reduced relative to the distance through which input force moves? Assume no losses due to friction.
Suppose you have a coffee with a circular cross-section and vertical sides (uniform radius). What is its inside radius if it holds 375 g of coffee filled to a depth of 7.50 cm? Assume coffee has the same density as water.
A container of water has a cross-sectional area of A=0.1m2 . A piston sits top of the water (see be following figure). There is a spout located 0.15 m from the bottom of tank, open to the atmosphere, and a stream of water exits the spout. The cross sectional area of the spat is As=7.0104m2 . (a) What is the velocity of the water as it leaves the spout? (b) If the opening of the spout is located 1.5 m above the grand, how far from be pout does water hit the floor? Ignore friction and dissipative forces.
A large tanker truck can carry 20 tons (40.000 lb) of liquid (a) What volume of water can it carry? (b) What volume of gasoline can it carry?
In an immersion measurement of a woman's density, she is found to have a mass of 62.0 kg in air an apparent mass of 0.0850 kg completely submerged with lungs empty. (a) What of water does she displace? (b) What is her volume? (c) Calculate her density. (d) If her lung capacity is 1.7S L, is she able to that without treading water with her lungs filled air?
A 75.0-kg floats in freshwater 3.00% of his volume above water when his are empty, and 5.00% of his volume above water when his lungs are full. Calculate the volume of air inhales—called his lung capacity—in liters. (b) Does lung volume seem reasonable?
Blood is pumped from the heart at a rate of 5.0 L/min into the aorta (of radius 1.0 cm). Determine the speed of blood through the aorta.
Mercury is commonly supplied in flasks containing 34.5 kg (about 76 Ib.). What is the volume in liters of this much mercury?
The average density of the Sun is on the order 103kg/m3 . (a) Estimate the diameter of the Sun. (b) Given that the Sun subtends at an angle of about half a degree in the sky, estimate its distance from Earth.
Show that the Reynolds number NRis unitless by substituting units for all the quantities in its definition and cancelling.
(a) Using Bernoulli's equation, show that be measured fluid speed v for a pitot tube, like the one in figure 14.32(b), is given by v=( 2gh)1/h , where h is be height of be manometer fluid, p' is the density of the manometer fluid, p is the density of the moving fluid, and g is be acceleration due to gravity. (Note that v is indeed proportional to the square root of h, as stated in text) (b) Calculate v for moving air if a mercury manometer's h is 0.200 m. Figure 14.32 Measurement of fluid speed on Bernoulli’s principle. (a) A manometer is connected to two tubes close together and small enough not to disturb the flow. Tube 1 is open at the end facing the flow. A dead spot having zero speed is created there. Tube 2 has an opening on the side, so the fluid has a speed v across; thus, pressure there drops. The difference in pressure at the manometer is 12v22 , so h is proportional to . 12v22 (b) This type of velocity measuring device is a Prandtl tube, also known as a pitot tube.