2/59 SS Each propeller of the twin-screw ship develops a full-speed thrust of 300 kN. In maneuvering the ship, one propeller is turning full speed ahead and the other full speed in reverse. What thrust P must each tug exert on the ship to counteract the effect of the ship's propellers? - 50 m F #F 1³ F 120 m PROBLEM 2/59 12 m

2/59 SS Each propeller of the twin-screw ship develops a full-speed thrust of 300 kN. In maneuvering the ship, one propeller is turning full speed ahead and the other full speed in reverse. What thrust P must each tug exert on the ship to counteract the effect of the ship's propellers? - 50 m F #F 1³ F 120 m PROBLEM 2/59 12 m

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A simple turbomachine is constructed from a disk with twointernal ducts that exit tangentially through square holes, asin Fig. P3.156. Water at 20 ° C enters normal to the disk atthe center, as shown. The disk must drive, at 250 r/min, asmall device whose retarding torque is 1.5 N ? m. What isthe proper mass fl ow of water, in kg/s?
The bridge shown in Figure consists of two end sections, each weighing 20 tons with center of gravity at G, hinged to a uniform center span weighing 12 tons. Compute the Reaction at B. * 6 tons -40m- 20m 40m -30m20m-20m- -60m- -20m20m30m- None of the above 26 tons O 4.8 tons O 4 tons O 23.2 tons B.
Compute the reactions and the end moments for the frame shown below. 4.9 kN/m 6 kN B 4 m, El 3 m, 2EI FEMA -4 H Good luck Dr. Ali Sadeghpour L 4 m, El D FEM 3 m, 2El 4 m, El E **
The bridge shown in Figure consists of two end sections, each weighing 20 tons with center of gravity at G, hinged to a uniform center span weighing 12 tons. Compute the Reaction at E. * 6 tons -40m- -20m 40m -30m 20m-20m- -60m- -20m20m 30m- O 23.2 tons O 4.8 tons O None of the above O 4 tons O 26 tons
The flywheel A rotates clockwise under the action of a700 N-m couple. A band break is to be used to stop therotation of A. The coefficient of friction between the beltand the flywheel is 0.40.a.) What is the minimum force applied at the end ofrod B that will stop the flywheel?b.) If the 700 N-m couple acts counterclockwise onA, what is the minimum braking force P?
1. DETERMINE THE RESULTANT OF THE PARAUEL FORCE SY STEM ON THE BAR AB SHOWN IN FIGURE l001b 50016 30016
The five forces acting at the end of the boom satisfy the condition of equilibrium. Determine the values of T1 and T2. 4 m_C 6m T2 iB T1 30°f A 58 kN y T3 D 25 kN 8 m
Q5/ An open belt connects two flat pulleys. The puley diameters are 300 mm and 450 mm and the corresponding angles of lap are 160° and 210°. The smaller pulley runs at 200 r.p.m. The coefficient of friction between the belt and pulley is 0.25. It is found that the belt is on the point of slipping when 3 kW is transmitted. To increase the power transmitted two alternatives are suggested, namely (i) increasing the initial tension by 10%, and (i) increasing the coefficient of friction by 10% by the application of a suitable dressing to the beit. Which of these wo methods would be more effective? Find the percentage increase in power possible in each case.
Q5:- A vertical turbine shaft carries a load of 356 kN on a thrust bearing consisting of 16 flat rocker plates, 75 by 225 mm, arranged with their long dimensions radial from the shaft and their centers-on a circle of radius 45 cm. The shaft turns at 120 rpm; μ= 0.1 Pa.s. If the plates take the angle for maximum load, neglecting effects of curvature of path and radial lubricant flow, find (a) the clearance between rocker plate and fixed plate; (b) the torque loss due to the bearing.
2. The 50 kg uniform crate initially rests on the inclined surface. If a force (F-40t +200 N) as shown in the figure below starts to pull the crate, determine the power output develop by the force at t-6 s. The coefficients of static and kinetic friction between the crate and the surface are s-0.20 and Hk-0.15. F-40t+200 N F (r in second) 30°
Find the horizontal thrust at support? H A 1 WR - w/m R اخره B WR H
Find the Reaction at suport A and B 20 kN 40 kN/m A 150 kN m -8 m -3m