200 kN/m Turbine 3 0.3 m /s'0.4 m
Q: 3.5 DISCUSSION 1- Where the velocity of water increases in the throat area or in the entrance area…
A: The venturi meter is used the measure the flow rate (discharge) of flowing fluid. In venturi meter…
Q: Q3: calculate the total residual flow using the following data Static pressure: 55 psi Residual…
A: Write the measured residual pressure. Pr=41 psi Write the desired residual pressure. Pd=20 psi Write…
Q: what is flow rate of the sy stem below and what is the power t input of the pump if it is and the…
A:
Q: 9.25. Compute the discharge from the tank shown in Fig. 9.42. Air, 2 psi 3 in, diam Oil, sp gr 0.92…
A: Given: air pressure, P1=2 Psi or 13789.5 Pascal jet diameter, d=3 inch or 0.0762 m height, h= 4 ft…
Q: Discuss with neat diagram the pump flow characteristics if pumps are used in : (i) Parallel (ii)…
A: When pumps are connected in parallel, the total discharge is equal to the sum of the flow from each…
Q: QUESTION 02 Consider a single acting triplex pump having 7-in. liners and 12-in. stroke length…
A:
Q: List any four advantages of the Horizontal Axis Wind Turbine.
A:
Q: Len is asked to design a small water pump for an aquarium. The pump should deliver 18.0 Lpm of water…
A: The specific speed of the pump is written as,
Q: regular exit 90" elbow 20 n Sharp entrance Half-open gate valve 12-in bend radius Pump Onen elobe
A: Solution :- Given data :- ρ = 2 slugs/ft3 = 1030.76 kg/m3ν= 0.000012 ft2/sec = 1.1148×10-6 m2/secQ =…
Q: Effect of vane angle of a pump head against discharge,using equation and diagram 12:16
A: following is the answer to above question-
Q: Water is to be pumped from a lake to a ranger station on the side of a mountain (see figure). The…
A: Given that, Flow rate of water, q=95 gal/minq=0.0066 m3/sec=0.2339 ft3/sec,Inner diameter of pipe,…
Q: Write any four advantages of Vertical Axis wind turbine.
A: A vertical axis wind turbine is a type of wind turbine in which the main rotor shaft is transverse…
Q: onical flow meter d of 0.3 kg/s, as show
A:
Q: Pump charecterishics Curve halm), esyetem curve Q (mi/s) Q Pz # Show the location of operating point…
A: Location of operating point of the pump arrangement system-
Q: 14.43 An axial-flow pump is to be used to lift water against a head (friction and static) of 15 ft.…
A:
Q: Q6. A dru of (1m) is one end of other end i drum. Hov the siphon tube of fric
A: GivenD=0.6mz1=1mz2=-0.5md=15mmL=3.5mf'=4f=0.001cc=0.55
Q: Convert 50 GPM to ft/s in a 4" Sch 40 pipe
A: Given data: V˙=50 GPMPipe=4'' schedule 40 pipe Need to Convert 50 GPM to ft/s.
Q: A turbine develops 10 MW under a head of 25 m at 135 rpm. a) What is the specific speed? b) What…
A: Data given- P = 10 MW = 10 × 103 kW H = 25 m N = 135 rpm For b) & c) H2 = 20 m
Q: What is the performance of pump (in %, whole number) that supplies 80 gpm of water (80°F) with…
A: Solution is attached below:
Q: Determine the pump head (unit: meter or kPa), using the following parameters
A:
Q: Francis and Kaplan turbines are often provided with drafttubes, which lead the exit fl ow into the…
A: A draft tube can be defined as a pipe of gradually increasing area that connects the outlet of the…
Q: Subject: Fluid mechanics Give me right solution according to the question.. Compute the power…
A:
Q: Drive Velocity Triangle For Axial Mixed Flow For Francis Turbine.
A: Francis turbine is a hydraulic turbine that extracts energy from fluid. In this, working fluid is…
Q: Design a Francis Turbine by assum suitable dimensions and Draw its velocity triangles
A:
Q: adicular component is 400 N, comp he horizontal and vertical compon
A: As per bartleby policy I am supposed to answer only first question. Please ask remaining question as…
Q: ind the following problem by showing the steps A . net head B. water horse power ( power) c.…
A: Given data,1-Pump head= CalculationQ=0.579 m3/secA=π40.52=0.1963m2V=0.573π40.52=2.919m/sec
Q: Required: Pump efficiency
A: efficiency = power delivered by pump / power input to pump
Q: otal head pressure 1 m2 and m2. n.
A: Write the expression of the head of the water flow from the nozzle.
Q: (a) The specific speed at which a small hydropower turbine would run under unit head to produce unit…
A: Classification of Hydro Turbine.
Q: Water flow rate is 8.7 gpm (gallons per minute) What is the static head? What is the overall…
A: Static pressure head is the pressure resulting from a column of liquid acting under gravity, and…
Q: i. The flow capacity of the fan in litres/min ii. What the height of the residential building should…
A: We are to get the lpm of duct flow then determine the height of building
Q: of 300 mm running at a speed of 2950 rev/min delivering 45 similar spare pump running at a speed of…
A:
Q: Determine the pump head required to pump water between the two ta figure. Water flowrate is 5.6x103…
A:
Q: compare between HHP criteria (hydraulic horse power) and IF criteria (Impact force) and which of…
A: Hydraulic horsepower (hhp) gpm x psi / 1715 = hydraulic horsepower HHP is the horsepower…
Q: For flow nate 28 Lis rale Sind pump Power
A:
Q: 1. Design a system to pump water at 140°F from a sump below a heat exchanger to the top of a cooling…
A:
Q: 115 m turbine
A: Givenhead of water H=115mturbine produce power P=4.6MWlosses in the system L=10m head of water…
Q: What diameter of new cast-iron pipe, 1 mile long is required to discharge 4.5 cu. ft. per second…
A: L=1 mile Q=4.5 ft3/secH=50 ftg=32.2 ft/sec2Since Q=π4×D2×VV=2gH
Q: What is the time is taken by the system to fill a tank of capacity 315 liters and flow rate 25 x…
A: Given data tank of capacity (v) = 315 liters = 0.315 m3 flow rate = 25 x 10 3 m³ per hour = 6.944…
Q: What is Total Head of submersible pump
A:
Q: in fully developed laminar flow (1-4r2/D²), whereris the radi
A:
Q: Mention the advantages of Vertical Axis wind turbine.
A:
Q: The impeller of a radial pump with diameter of 34.2 in trimmed such that its head is reduced by…
A: Given data Initial Diameter of Pump = D1 = 34.2 inFinal Head = Initial Head2H2 = H12We have to…
Q: EX1- It is required to pump water out of deep well under a total head of 90 m. A number of identical…
A: Total head, H= 90 m Design speed, N= 1000 rpm Specific speed, NS= 30 Rated capacity, Q= 0.15 m3/s…
Q: Calculate the following: 1.Head at the discharge side,m 2. Velocity Head, m 3. Total Head of the…
A:
Q: Q:/ Discuss the relation between the head pressure and flow rate for the benefits of connecting the…
A: For solution refer below images.
Q: Discuss the relation between the head pressure and flow rate for the benefits of connecting the…
A: When the two pumps are connected in series, their resultant pump performance curve is given by…
Q: The depth of water in U/S is 3 m, If the discharge under regulator gate is 2 cubic meter per day.…
A:
Q: The discharge in m3/s for laminar flow
A: Given data; ac. to question;The discharge in m3/s for a laminar flow…
Step by step
Solved in 2 steps
- A petrol engine has mechanical efficiency 0.8 and lower calorific value of 44.2 MJ / kg. The engine bore 0.06 m and stroke of 0.08 m. The engine speed of 2000 rpm. The consumption of fuel about 8 liter / h and the brake weight is 200 N. Take the density of fuel as 750 kg / m3 and torque arm of 400 mm.Find the specific fuel consumption. *Question. A boiler unit has forced draught fan maintaining draught of 90 mm of water column while discharging 38 m/s through outlet section of 1.9m² area. Ambient temperature is 300 K and assume mass of 1 m³ of air at NTP as 1.293 kg to find out power of motor of forced draught fan if for efficiency is 80%. Determine the power consumption if FD fan is substituted by ID fan of similar efficiency considering flue gas temperature of 450 KSiven Quation 2 According to figure 1, Given data as (COP)HP =3.5, QH= 90000 KJ/h (rate) and 1KW = KJ/S (rate) a) Calculate W net in KJ/h ? b) Calculate Wnet in kilo watt (Kw) %3D Quation 3 Given data as Wnet = 98000.0 KJ/h (rate) and QH= 75000.0KJ/h(rate) a) Calculate Q in KJ/h ? b) Calculate QL in Kilo watt(KW) Quation 4 Given data QL=400.0 KJ/min (rate) and Wnet =3KW(rate) Calculat (COP)R?
- Maximizing the wind velocity of 92 m/s and 25 units of wind turbine was installed at the seaside shore. What is the total power if the area of turbine blade equal to 42 sq.m. with air density of 1.2041 Kg/cu.m. A 1.969 MW 1,968,998 Watts 4,923 watts D 49.23 MWB) The air flow to a four cylinder four-stroke engine is 2.15 m³/min. During a test on the engine the following data were recorded: Bore 10.5cm; stroke 12.5cm; engine speed 1200 rpm, torque 150 N.m, fuel consumption 5.5 kg/hr, calorific value of fuel, 43124 kJ/kg, ambient temperature 1-The brake thermal efficiency. and pressure are 20°C and 1.03 barş. Calculate: 2-The brakes mean effective pressure. 3-The volumetric efficiency.a. Water flowing at 2.6 KL/s is taken from a river and delivered to a turbine 100m lower than the source. If the turbine/generator has an efficiency of 45%, calculate the electrical power that would be delivered over one year. b. Explain, with the aid of suitable graphs, the charge and discharge cycle of a deep cycle lead acid battery. c. In a thermal power plant, 1500 MWh of energy is to be produced in a day, half from oil and half from natural gas, Calculate, for a one year period: the number of barrels of oil required if the fuel oil plant is 40% efficient. the total amount of natural gas required if the efficiency of the gas plant is 48% If a coal plant of 45% was used to supply the full load for a week, how much coal would be required? Use the following conversions in your calculations. Fuel & Energy Conversion & Equivalence Chart (reduced) http://www.cogeneration.net/FuelAndEnergyConversionandEquivalence.htm 1. Fuel Oil: 1 Gal of #4 Fuel Oil - 145,000 Bou's 1 Barrel of Oil -42…
- Consider a light fixture A "efficacy=40" to be replaced by light fixture B "efficacy=88" where there are 20 fixtures are used in a 16 m x 18 m x 3 m room with resulting illuminance of 454 Lu/m for both types, lights are used for 5400 hours per year and the grid efficiency is 35%. What is the annual amount of fuel reduction "Liters", if the power plant uses fuel with heating value = 25.56 MJ/Liters? Select one: A. 210.58 B. 178.81 C. 193.72 D. 227.24 E. 163.121. The wind turbine gives the following data: Blade length, I-52 m, Wind speed, v= 12 m/s, Air density, p=1.23 kg/m, Power Coefficient, C,- 0.4, CalculateWhat is the turbine output of 100m head and delivering 1 cu. m/ sec in a hydro electric power plant if turbine efficiency is 88%?
- The efficiency of wind turbine is equal to Moving 1000 J/s Wind 360 J/s Electrical 324 J/s air turbine generator NT = 40% b. а. NT = 90% NT = 32.4% d. C. NI = 36%a steam 2. A constant load (-120 MW) supplied by a hydro and unit. Find the generation schedule for 7 days (168 hours). Assume that water consumption in hydro unit is restricted 3 to 3 000 000 m². Hydro unit: 9=2000+200P (m³)Q1/B: Discuss, the unavailable, available, and actual wind energy according to the (Betez law). (SEE MORE QUESTIONS