please type your solutions and or diagram them so that they are easy to read i have bad eyesight and if needed please also show all calculations these would need to be typed as well so that i can read them thank you please do not write 20) An ideal transformer has 60 turns on its primary coil and 300 turns on its secondary coil.If 120 V at 2.0 A is applied to the primary,(a) what voltage is present in the secondary?(b) what current is present in the secondary?

No. of turns in primary coil Np = 60 No. of turns in secondary coil Ns = 300 Voltage in primary…

20) An ideal transformer has 60 turns on its primary coil and 300 turns on its secondary coil. If 120 V at 2.0 A is applied to the primary, (a) what voltage is present in the secondary? (b) what current is present in the secondary?

20) An ideal transformer has 60 turns on its primary coil and 300 turns on its secondary coil. If 120 V at 2.0 A is applied to the primary, (a) what voltage is present in the secondary? (b) what current is present in the secondary?

Glencoe Physics: Principles and Problems, Student Edition

1st Edition

ISBN:9780078807213

Author:Paul W. Zitzewitz

Publisher:Paul W. Zitzewitz

Chapter25: Electromagnetic Induction

Section: Chapter Questions

Problem 60A

See similar textbooks

Related questions

Q: Consider the motion of a particle of mass say m. Using Cartesian coordinates as generalized…

A: This is a classical mechanics problem. Here we deduce the Lagrange's equation of motion from the…

Q: Two point charges with charges q₁ = 6.7 x 10-6 C and q2 = 6.3 x 10-6 C are initially very far apart.…

A: The potential energy between the two point charges which are separated by a distance r is given by…

Q: An electron with a horizontal speed of 2300000 m/s and no vertical component of velocity passes…

Q: A car is moving to the left at 25 m/s while a truck is moving to the right at s 20m/s. If the truck…

Q: A high-powered spring cannon discharges its ball at 16.6 m/s. If the cannon is fired at an elevation…

A: The initial velocity of the canon is v=16.6 m/s The cannon is fired at an angle θ=77° Assume the…

Q: 14 (a) For 1.0 mol of a monatomic ideal gas taken through the cycle in Fig. 20-24, where V₁ = 4.00V,…

Q: A gold and silver rod, of equal length and cross sectional area, are joined as shown in Figure 2.…

Q: A natural gas storage tank is a cylinder with a moveable top whose volume can change only as its…

A: Given:- Initial Temperature= T1 = 22°C = 295 K Initial height= y1 = 22.6 m Final height= y2 = 23 m

Q: 49. The switch in Figure P23.49 has been in position a for a long time. It is changed to position b…

Q: The Doppler effect can be used to measure flow rates in blood. A sound wave is transmitted into a…

Q: You are running north at 5.90ms. Let’s call you Jogger A. Jogger B is currently ahead of you and is…

A: Given velocity of jogger A (VA)=5.90 ms-1 Velocity of jogger B (VB)=1.88 ms-1 Required Velocity…

Q: football player kicked the ball at the speed of 27.0 m/s as shown in the figure. Determine the range…

Q: ve lens of focal length 144 cm and an eye-piece of focal length 6.0 cm. Wha is the magnifying power…

A: Magnifying power of telescope is the ratio of the angle subtended at the eye by the image to the…

Q: A Cadillac Escalade has a mass of 2569.6 kg, if it accelerates at 4.65 m/s^2 what is the net force…

A: Part (1): Given: The mass of the object is 2569.6 kg. The acceleration of the object is 4.65 m/s2.

Q: 12) A bar magnet is oriented above a copper ring, as shown in the figure. The magnet is dropped and…

A: According to lenz's law Induced emf always opposes the cause by which it is produced.

Q: The following directly affects the conductivity of a material except one. Which is it? the…

Q: A 50 kg bicyclist on a 10 kg bicycle speeds up from 5.0 m/s to 10 m/s. How much work was done to…

A: Ques 1 : Given : Mass of bicyclist = 50 kg Mass of cycle = 10 kg Total mass (M) = 50 +10 = 60 kg…

Q: The current in a conductor is found to be moving from (4.18, 3.79, 4.20) meters to (7.99, 9.11,…

Q: A charge Q is uniformly distributed over a long rod AB of length L. a) Evaluate the electric field…

A: An electric field is the force exerted on a unit positive test charge that is kept at a distance.…

Q: 2. You are given the following charge distribution: 75nC T 16cm 14 cm 86nC 20cm Find the total…

Q: Determine the x-and y-coordinates of the trapezoidal shape. 2.0 b Answers: b 1.3 b A FHE )b

Q: An object is 4cm from diverging lens whose focal length is 12cm, where will be the image? 3 6 -6 -3

Q: Your neighbor has circular steel lid for his well. The lid has an outer diameter of 0.909 m. The…

A: The expansion in area with temperature is given by ∆A=Aiα∆TWhere α is linear expansion, ∆T is change…

Q: [Write true on the blank if the statement is TRUE. If FALSE, write false and supply the correct…

A: (3) False , Diffuse reflection When parallel light ray stike an uneven surface then light ray…

Q: certain radioactive imple at any instant is 4750 disintegrations per minute. Five inutes later the…

A: The decay constant of a radioactive nuclide is its probability of decay per unit time. Here, we…

Q: Magnetic field lines A) can easily be drawn within the subatomic structure of a magnetic…

A: Solution:- Given that, Magnetic field lines (A) can easily be drawn within the subatomic structure…

Q: Problem 2: A person makes a quantity of iced tea by mixing 500 g of hot tea (essentially water) with…

Q: 8.0 N 25 cm 75 cm F If the bar is to be in rotational equilibrium, what Force, F must be applied on…

A: When the bar is in rotational equilibrium, the torque about the dotted point for both forces will be…

Q: From her bedroom window a girl drops a water-filled balloon to the ground, 6.0 m below. If the…

A: initial velocity (u) = 0 m/s height (h) = 6 m let the time for which the balloon is in air = t

Q: 29. ssm A jetliner, traveling northward, is landing with a speed of 69 m/s. Once the jet touches…

Q: A truck is carrying a steel beam of length 16.0 m on a freeway. An accident causes the beam to be…

A: Given data: Length of the steel, l=16 m Speed with which the steel slide, v=29 m/s Earth's magnetic…

Q: Question 2: # 55 The wings of some beetles have closely spaced parallel lines of…

A: Write Bragg’s diffraction equation. Here, n is the order, λ is the wavelength, d is the separation,…

Q: •7 ILW A 50.0 g block of copper whose temperature is 400 K is placed in an insulating box with a 100…

Q: 1. A toy falls from a table. The toy hits the floor 0.60s after it falls off. How tall is the…

A: Given Time taken by the toy to hit the floor is t=0.60 s As the toy falls from the table its initial…

Q: An electronics hobbyist is building a radio set to receive the AM band, with frequencies from 520…

Q: A horizontally launched projectile lands 79.29m below the launch point and a horizontal distance of…

Q: D

A: Solutions

Q: The velocity of a diver just before hitting the water is -10.1 m/s , where the minus sign indicates…

Q: A harpsichord string of length 1.50 m and linear mass density 25.0 mg/m vibrates at a fundamental…

Q: Determine the direction of the magnetic field lines produced by the following current-carrying…

A: As per guidelines only first question is solved. Direction of magnetic field lines determined using…

Q: A short bar magnet has a magnetic moment magnet magnetic field produced by the distance of 10 cm…

A: A magnetic field refers to a vector field in the neighbourhood of a magnet, electric current or…

Q: Compute for the potential difference, in volts, in moving a charge radially away from the center…

Q: own write-up. Problem 1: At 20°C, a rod is exactly 20.05 cm long on a steel ruler. Both are placed…

A: Given:- Ti= 20°C Tf= 270°C ∆T= Tf -Ti = 250 °C αs = coefficient of expansion= 11×10-8 /°C

Q: A crate that has a mass of m = 5 kg slides down a smooth surface through vertical distance h=85 cm…

A: a) Apply the energy conservation equation between the top and the bottom of the surface to determine…

Q: Determine whether each of the following vector fields Fis path independent (conservative) or not. If…

A: There are mathematical condition which can be used to test whether the force is conservative or not.…

Q: A projectile is fired from the edge of a 180-m cliff with an initial velocity of 150 m/s at an angle…

Q: A 2.50-kg mass is attached to a vertical spring with spring constant, k=96.0 N/m and allowed to…

A: Given: The mass of the object is 2.5 kg. The spring constant is 96 N/m. The amplitude of the system…

Q: how can I write it without the units?

Q: A person kicks a ball with an initial velocity 15m/s at an angle 37° above the horizontal (neglect…

Q: Use Newton's Second Law () to solve for the mass of the apple. Explain how you used Newton's Second…

A: Given:- M= mass of disk= 2.776 kg Let m= mass of the apple

Concept explainers

Magnetic Field Of Coaxial Cable

The word coaxial means same axis. So for a long straight cable to be coaxial, it must have concentric cylindrical shaped conductor around it. Coaxial cable (popularly called ‘coax’) has various applications ranging from current conductors to radiofrequency signal transmitters. This cable has lower emission losses and provides protection from electromagnetic interference which allows signals with less power to transmit over longer distances.For example, currents produced in the pickup of a stereo turntable generally travel to the amplifier through a coaxial cable.The self-inductance of a coaxial cable is another important characteristic, because it influences the propagation of electrical signals in the cable.

Question

100%

please type your solutions and or diagram them so that they are easy to read i have bad eyesight and if needed please also show all calculations these would need to be typed as well so that i can read them thank you please do not write

20) An ideal transformer has 60 turns on its primary coil and 300 turns on its secondary coil.
If 120 V at 2.0 A is applied to the primary,
(a) what voltage is present in the secondary?
(b) what current is present in the secondary?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

At what angular velocity in rpm will the peak voltage of a generator be 480 V. if its 500-turn, 8.00 cm diameter coil rotates in a 0.250 T field?
Review. A novel method of storing energy has been proposed. A huge underground superconducting coil, 1.00 kin in diameter, would be fabricated. It would carry a maximum current of 50.0 kA through each winding of a 150-turn Nb3Sn solenoid. (a) If the inductance of this huge coil were 50.0 H. what would be the total energy stored? (b) What would be the compressive force per unit length acting between two adjacent windings 0.250 in apart?
A toroidal coil has a mean radius of 16 cm and a cross-sectional area of 0.25 cm2; it is wound uniformly with 1000 turns. A second toroidal coil of 750 turns is wound uniformly over the first coil. Ignoring the variation of the magnetic field within a toroid, determine the mutual inductance of the two coils.
(a) The plug-in transformer for a laptop computer puts out 7.50 V and can supply a maximum current of 2.00 A. What is the maximum input current if the input voltage is 240 V? Assume 100% ef?ciency. (b) If the actual efficiency is less man 100%, would the input current need to be greater or smaller? Explain.
(a) What is the voltage output of a transformer used for rechargeable flashlight batteries, if its primary has 500 turns, its secondary 4 turns, and the input voltage is 120 V? (b) What input current is required to produce a 4.00 A output? (c) What is the power input?
Does the induced emf always act to decrease the magnetic flux through a circuit?
Construct Your Own Problem Consider a double transformer to be used to create very large voltages. The device consists of two stages. The first is a transformer that produces a much larger output voltage than its input. The Output of the first transformer is used as input to a second transformer that further increases the voltage. Construct a problem in which you calculate the output voltage of the final stage based on the input voltage of the first Stage and the number of turns or loops in bath parts of both transformers (four coils in all). Also calculate the maximum output current of the final stage based on the input current. Discuss the possibility of power losses in the devices and the effect on the output current and power.
A 120-V, series-wound dc motor draws 0.50 A from its power source when operating at full speed, and it draws 2.0 A when it starts. The resistance of the armature coils is 10 , (a) What is the resistance of the field coils? (b) What is tire back emf of the motor when it is running at full speed? (c) The motor operates at a different speed and draws 1.0 A from the source. What is the back emf in this case?
Can there be an induced emf in a circuit at an instant when the magnetic flux through the circuit is zero?
How fast can the 150 A current through a 0.250 H inductor be shut off if the induced emf cannot exceed 75.0 V?