Answered: 2.a) 50 hz induction motor has 2 poles…

Engineering

Electrical Engineering

2.a) 50 hz induction motor has 2 poles and run at 2,850 rpm. What is the percent slip?

Electric Motor Control

10th Edition

ISBN:9781133702818

Author:Herman

Publisher:Herman

Chapter51: Electric And Electronic Braking

Section: Chapter Questions

Problem 2SQ: Differentiate between the AC and DC magnetic fields applied to an induction motor stator.

See similar textbooks

Related questions

Q: An armature has a resistance of 0.2 ohm at 15 degrees Celsius and the armature copper loss is to be ...

Q: Determine the value of emitter voltage VE, when VCC=19V, R4=1396 ohms, R3=392 ohms, VC=8 V and R2=6...

A: Given VCC=19V, R4=1396 ohms, R3=392 ohms, VC=8 V and R2=6025ohm R5=448 ohm

Q: At 110 volts, a lagging power factor load in single-phase consumes 500 Watts and 8 Amperes. Determin...

Q: A circuit having a resistance of 12Ω, an inductance of 0.15 H and a capacitance of 100μf in series i...

Q: Electrical Engineering From the following circuit, analyze the power consumption of the loads and in...

Q: 3. Solve the following: 4500 turns 300 turns 2k2 ) 50 VẠC Calculate all voltages and all currents in...

Q: 70 60 50 40 20 10 25 20 15 10 200 400 600 800 time (un) y

A: Given a graph representing flowrate vs time.webneed to obtain k,tau and thetaT transfer function.

Q: Which of the following statements are not true for an ideal op-amp? You may have more than one answe...

Q: Consider the circuit shown, use an ideal op amp model to get the vo expression for the gain, =f(R, A...

A: Brief description : Operational amplifier is an active device which can be used as follows Invertin...

Q: Part A Find the curent ig flowing through the resistor Express your answer to three significant figu...

Q: Find Rab 10 2 12 10 d w- a o-w- ww- Rab 303 50 12 2 bo

A: Calculation of equivalence Resistance of the given circuit : We know, Let us two resistances R1 and...

Q: Q. An IGBT switch has a 10 ohms resistive load across 100V supply at a frequency of 10kHz. If the sw...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: The curl of the vector A = yz ax + 4xy ay + y az а. ax + yay + (4y - z)az b. ax + ay + (4y – z)az С....

Q: Vc R1 RC Q1 NPN +88 8 R2 RE Volts VC

Q: Find Rab 20 2 ww- 50 a www ww 18Ω 20 Ω Rab 12 9Ω www ww

Q: Find the output voltage across RL VL output current through RL

Q: Derive the voltage division law between series resistors.

Q: The terminal voltage of a motor is 118 V, and the armature current is 38 A. If the armature resistan...

Q: 10- x2(t) 4 10- (b) x2(1)

Q: 0 Find Zah in the circuit shown in Fig. P9.50 when the circuit is operating at a frequency of 100 kr...

Q: D4.2. Calculate the work done in moving a 4-C charge from B(1,0, 0) to A(0, 2, 0) along the path y =...

A: The solution is given below

Q: Consider the circuit shown, use an ideal op amp model to get the vo expression for the gain, =f(R, A...

A: We need to find voltage ratio for given circuit .

Q: 2. A silicon diode has a saturation current of 5nA at 27'C. Estimate the Is at 100'C? ANS. 784.03 nA...

Q: It is the voltage supply that limits the AC voltage level. a. Square wave input b. Bias c. ...

A: Square wave and capacitor voltages are not supply voltages

Q: 2. Solve the following: Rjoad 150 Ω 48 VẠC (^ 13000 turns 4000 turns Vp = ? Vs = ? Ip = ? Is = ? Wha...

A: The solution is given below

Q: Consider the circuit shown, use an ideal op amp model to get the = f(R, Ar) vo expression for the ga...

A: Kirchoff's voltage and current law is very important to analyze the electrical circuits. According t...

Q: !: 1-Design Measurement System Signal Processing circuit, having an input signal e (t), output signa...

A: We need to design the circuit for given expression .

Q: Calculate the IL current using the superposition method. 2.In the circuit, the phasors of the cap...

A: The given figure is shown below:

Q: Find Xc Z, I, VR.Vc and don't forget to put their units. Source voltage 250z50° 12.5 kQ 3.5 kQ 140 µ...

A: The solution is given below.

Q: 9.44 The sinusoidal voltage source in the circuit in Fig. P9.44 is developing a voltage equal to 247...

A: This question belongs to circuit theory . It is based on the concept of Thevenin's theorem . Theveni...

Q: R2 Q1 VCC R1

Q: When the diode is reversed biased, the terminal that is connected to the lower potential of the sour...

A: Diode is said to be reverse biased when cathode voltage is greater than anode voltage.

Q: The 2 phenomenons that describe the sudden increase of the current in a Reverse bias diode are: and ...

A: In this question, Fill the blank. Both question are releted to the characteristic of the reverse b...

Q: The transition matrix of a channel is given by: 0.3 0.6 p(Y/X) = 10.1 0.2 0.25 0.55 Q2 If p(x,) = 0....

A: The given transition matrix is shown below: pYX=0.10.30.60.20.250.55 a) The noise entropy of the ch...

Q: Find the value of Rf that will produce the closed loop gain of -244 Ri Vin oW 10 kN oVout

A: Given circuit: Here, A=-244Ri=10 kΩ

Q: 40 k2 8 kQ 10 k2 20 kN +Vcc 3 -Vc RL= 20 kN +

Q: 100 60 ww 0.2 H i, 0.1 F

Q: 3) Determine the voltages at the nodes ww 2 ww ww 3 2ix ЗА ww

A: In this question we have to determine the node voltages

Q: Given the potential 10 sin 0 cos o, %3D Calculate the work done in moving a 10-µC charge from point ...

Q: Three unequal single-phase loads are connected across the lines of a balanced, 3-phase, 230 volts (l...

Q: Find the currents and voltages in the circuit iz -ww- 30 V 3Ω ww-

Q: 5 Find the inverse Laplace transform of the given function: F (s) %3D 5s-46 f (t) = %3D

A: In this answer we will find the inverse Laplace transform as explained below using the standard form...

Q: Problem 1. A closed-loop control system transfer function T(s) has two dominant complex conjugate po...

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for y...

Q: 1. With a neat sketch briefly explain how an alternating voltage is produced when a coil is rotated ...

A: “Since you have asked multiple question, we will solve the first question for you. If you want any s...

Q: G: Amf CA= 6Mf te G: 3mf G: Suf HE Gr: 240 volts FIC.# 2

Q: R6 e2 R, Rg R4 V. 2 R, V, 1 R5

A: Given, We have a network. We have to solve for e1 and e2. Please find the below attachments for the ...

Q: From the following figure, find the voltages at each of the nodes, A, B, C, D, E and F. Assume, Vdd...

Q: Refer to the given circuit below. Determine the equivalent resistance across terminals a and b if R1...

Q: find the current of loop 1 * R6 · 150 R1 R3 18Ω 200 R8 140 R5 loop1 -25V O 0.757

Q: Find V and E at point.(I, pi/3, * pi/2) no one of these answers O 2.35 V, 0.9ar + 1.7794a,, V/m. 0.4...

Concept explainers

Three Phase Induction Motor

The induction motor is an electric motor that runs on AC (alternating current) and it is of two type single phase motor that work on single-phase power supply and three-phase motor that work on three-phase power supply.

Question

2.a) 50 hz induction motor has 2 poles and run at 2,850 rpm. What is the
percent slip?

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Name three factors that determine the torque produced by an induction motor.
1. The operation of Commutator in DC Motor is * O a) to convert dc to ac O b) to convert ac to dc O c) to convert fixed dc to variable dc O reverse the current direction in the rotating windings each half turn
8. A 3-phase induction motor is running at 2% slip. If the input to rotor is 1000 W, then mechanical power developed by the motor is ............ (i) 20 W (iii) 500 W (ii) 980 W (iv) 200 W
What are the following statements are true for a three-phase induction motor? I. Three-phase induction motor stator winding is fed from a single-phase supply II. Stator carries a three-phase winding III. Rotor carries a short circuited winding a. I,II and III b. I only c. I and II only d. II and III
The frequency of rotor current in an induction motor is slip times the frequency of stator current. slip times the frequency of supply, One by slip times the frequency of stator current. One by slip times the frequency of supply
A four-pole induction motor drives a load at 2478 rpm. This is to be accomplished by using an electronic converter to convert a 400-V dc source into a set of three-phase ac voltages. Part A Find the frequency required for the ac voltages assuming that the slip is 4 percent. The load requires 2 hp. Express your answer to three significant figures and include the appropriate units. f= Submit Part B Value I = HA Request Answer Submit If the dc-to-ac converter has a power efficiency of 90 percent and the motor has a power efficiency of 80 percent, estimate the current taken from the dc source. Express your answer to three significant figures and include the appropriate units. HÅ Value Units Request Answer ? Units ?
3.4 The rotor power output of 3-phase induction motor is 15 k. The rotor copper losses at a slip of 4% will be (a) 600 W (c) 650 W (b) 625 W (d) 700 W
3.8 An induction motor having 8 poles runs at 727.5 rpm. If the supply frequency is 50 Hz, the emf in the rotor will have a frequency of (a) 1.5 Hz (b) 48.5 Hz (c) 51.5 Hz (d) 75 Hz
Do you What is Induction motor?
A three phase induction motor 2 points operates with a rotor speed of 1440 rpm and develops a torque of 66.32NM at full load. The full load power output is * 11 kW 8 kW O 10 kW 9 kW
A 3-phase 440 V, 50 Hz induction motor has 4% slip. The frequency of rotor current a. 48 Hz b. 2 Hz c. 50 Hz d. 100
6- Which of the following supply is given to the rotor winding of 3-Phase Induction Motor: a) DC Supply b) AC Supply c) No Supply d) Pulsating Supply 7- 3-Phase Induction Motor will have Starting Torque and Starting Current a) High, High b) Low, Low. c) High, Low d) Low, High 8- Which of the following method is used for controlling the speed of an induction motor: a) Changing number of stator poles b) Supply voltage control c) Frequency control d) All the options are correct 9- Which of the following method cannot be used for starting of 3-Phase Squirrel Induction Motor: a) Star-Delta Starting b) Line resistor startling c) transformer Starter d) Rotor Resistance Starting 10- The rotor of a stepper motor has no: a) windings b) commutator c) brushes d) all of the above