2. Meter readings for a three-phase wye-connected alternator supplying power to a motor indicate that the line voltages are 208 V, the line currents are 10 A, and the total line power is 5 kW. Find: (a) the load in VA (b) the load pf (c) the phase current (d) the phase voltage

2. Meter readings for a three-phase wye-connected alternator supplying power to a motor indicate that the line voltages are 208 V, the line currents are 10 A, and the total line power is 5 kW. Find: (a) the load in VA (b) the load pf (c) the phase current (d) the phase voltage

Electricity for Refrigeration, Heating, and Air Conditioning (MindTap Course List)

10th Edition

ISBN:9781337399128

Author:Russell E. Smith

Publisher:Russell E. Smith

Chapter7: Alternating Current, Power Distribution, And Voltage Systems

Section: Chapter Questions

Problem 8RQ

See similar textbooks

Related questions

Q: and

Q: A 480V, 60 Hz, 6-pole, three-phase, delta-connected induction motor has the following parameters:…

A: Dear student, Since you have posted a question with multiple sub parts(8 subparts are there in this…

Q: A transmission line has a span of 150 m between level supports. The conductor has a cross-sectional…

Q: 2. For the following circuit, find E1. 20 30 www 81 30 V 82 | 6A

A: We need to find out unknown voltage for given circuit.

Q: mesh-current equations fo cuit in Figure P3-13. Formulate node-voltage equations for the c Figure…

Q: Determine and draw eppra approximately the magnitude and phase $#42-03-11- #sl for the following…

Q: What are the range of voltages can the Logo SIEMENS work within? Which model DC and which one AC…

A: We need to tell about the range of voltages can the Logo SIEMENS work .

Q: Problem 6 A 0.5-hp, 120-V, 2-pole, single-phase, 70% efficient PM motor utilizes samarium-based…

A: given , Single phase permanent magnet motor Efficiency n=70% Terminal voltage vt=120v Pole =2…

Q: voltages V₁ and V₂

Q: . Problem 2 The voltage and current at the terminals of a circuit element are shown. a) Is this…

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Design an (n. k)=(5,2) linear block code. i) Choose the codewords to be in systematic form and…

A: Given: For (n,k) = (5, 2), We have to design a Linear block code.

Q: . The current flowing through a 2 H inductance is shown below. Sketch the voltage, power, and stored…

A: Given data The waveform for the flow of current through the inductor is given in the problem. The…

Q: 2-29 Find the equivalent resistance REQ in Figure P2-29. REQ Μ 25 Ω 300 Ω Σ FIGURE P2-29 100 Ω

Q: A 495 V, 50-Hz, A connected 6 pole synchronous generator, its synchronous resistance is equal 0.2…

Q: Problem 8 Find values of Vc, Vo at t= (a) 0- (b) 0+ (c) 1.3ms 250 Ω 600 Ω 4 μF 카 + VC - 1250 Ω t=0 2…

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: We need to find out induced emf for given flux and time .

Q: 2-37 Find the equivalent circuit at terminals A-B for each of S the circuits shown in Figure P2-37.…

A: Given (a)

Q: Problem 2 For the following second-order circuits, find the range of Ao for which the circuit is…

Q: A voltmeter that reads 0.100 volts has a 200-division scale that can read up to half a division.…

A: Given,Range of the voltmeter is 0-100 Volts.Divison on the scale is 200.The voltmeter can read up…

Q: With a jog circult seal-in circuitry is required. True False Question 26 Multiple start buttons are…

Q: A synchronous generator is connected to an infinite bus with excitation voltage Ef = 1.3 pu. The…

Q: Problem 2. 1V + 10 + VC 1 F HH Ic 21c 1Q 4₁ 2H 1 A t=0 S1 In the above circuit, the switch has been…

Q: Find this system's response y(t) for x(t) = e-2t.u(t) h(t) = [2e-3t-e-2t].u(t) y(t) = ???

Q: Problem 4.10 Figure 3400 8011201 1 of 1 Y Use the node-voltage method to find in the circuit(Egure…

A: Given data i1=5.7 A i2=1.4 A To find out Using the Nodal voltage method, we have to determine the…

Q: Exercise 4: Let x[n] be the complex exponential x[n] = 11ej (0.3лn+0.5x) If we define a new signal…

A: I have written this solution as handwritten solution. Hope you find the solution clear.

Q: A coil having an area 2m² is placed in a magnetic field which changes from 1Wb/m² to 4Wb/m² in an…

A: Given data, Cross sectional area A=2 m2. Change in magnetic field △B=4-1=3 Wb/m2. Time interval dt=2…

Q: V=1.2V 10k Assuming an ideal opamp, determine output voltage Vo 202V 5k * 5k www.

A: Let the non inverting terminal voltage be "V+". Let the inverting terminal voltage be "V-". Since…

Q: 1= M 3 00Ka 1.60 г мл M Find V₁ 160 ка ви

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

Q: Three identical coils connected in star, take a total power of 1.5 kW at a pf of 0.2 lagging from a…

Q: Vo + R₁ M R₂ M R3 M V₁ M R5 M RA

Q: For each of the circuits find the mesh equations and put them in matrix form. Label your circuit…

Q: Sketch the asymptotic magnitude and phase Bode plots to scale for the transfer function? H(jω) =…

Q: The maximum power transfer in AC circuit occurs when the load impedance equals to the Thevenin's…

A: In these questions, We need to choose the correct options We are solving this problem using the…

Q: What is the maximum value of the variable ALPHA that will allow the channel 2 produce its maximum…

A: Given: All the lamps from Lamp 1 to Lamp 7 are designed to work with a nominal Voltage Vlamp=120…

Q: The design of an embedded system has a design operation cost of 20000£ and a 3-member team labour…

A: Given: Design Operation Cost=20,000 Euros. Labour Cost =30,000 Euros. Unit Cost=20 Euros. Assume…

Q: In the circuit shown in the figure, VA = V = 14.0 V and R₁ = R₁₂ = R₁ = R₁ = Rs = 125.0 2. Current…

Q: 2.4 The sensor of problem 2.1 has a first-order time response with a time constant of2.3 seconds.…

A: Given data Final temperature; Tf=94°C Initial temperature; Ti=43°C Time constant; T=2.3 s To find…

Q: Ex: 2 Find the reactive power of an ideal 0.5 H inductor that draws 0.5 A from a 60 Hz /source.

Q: Considering terminals a and b: a) Use any method to solve for the Thevenin equivalent voltage. b)…

A: The thevenin's equivalent circuit can be obtained by calculating the open circuit voltage and…

Q: Which of the block diagrams below is correct for the following equation: Should correct

A: It is given that:

Q: A strain gauge has a standard resistance of 120 ohms and GF of 4 has been subject to a strain of…

Q: In this class demo, the current: Olighted up an LED. broadcast to a radio. ooo Oturned the motor.…

A: The given figure is shown below. We need to tell in the given demo what is the role of current.

Q: 3-31 Use the superposition principle to find vo in Figure P3-31. 200 Ω 15 V + VO 200 Ω 200 Ω 5V

Q: 4 t 1 of 5 5 $1 PL1 is on PL2 is off PL3 is on PL4 is off TD1-1 (5 s) TD1-2 T(55) (5 s) TD2-1 T15 (5…

A: Given the logic diagram To find what happens to the PL1, PL2, PL3, and PL4 when switch Power is…

Q: 1. LED flashlights use "white" LEDs which have a diode voltage drop of 4.0V. An LED flashlight has…

Q: For the following circuit, values of QO, Q1 are only observed at select time indicated by the dashed…

A: The given circuit contains a D flipflop and the output of the flipflop is the same as the input…

Q: Given the following circuit, determine the the current running through the 18 [2] resistor (a), the…

Q: A 3-phase, 240 V balanced system supplies power to purely resistive impedances of 11.52 Ω per phase…

Q: 1. Determine I and Vab. 30V (+ 322 lov + + Vab 52 W ↓ +1 8v

Concept explainers

Synchronous Generator

In comparison to an asynchronous generator, it is a machine where the rotor speed is equal to the rotating magnetic field produced by the stator, i.e., mechanical speed is equal to the electrical speed, thus called synchronous, and not asynchronous.

Salient Pole Rotor

Salient pole rotor includes a large number of exposed poles mounted on a magnetic wheel. The construction of a bright pole is as shown in the image on the left. The proposed poles are made of metal laminations. The rotor winding is provided on these poles and is supported by pole shoes.

Question

2. Meter readings for a three-phase wye-connected alternator supplying power to a
motor indicate that the line voltages are 208 V, the line currents are 10 A, and the total
line power is 5 kW. Find:
(a) the load in VA (b) the load pf (c) the phase current (d) the phase voltage

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

1. A 3-phase, 16-pole alternator has a wye connected armature winding with 144 slots, 10 conductors per slot and runs at 450 rpm. The flux per pole is 40 mWb and the distribution factor is 0.966. What is the value of the line to line voltage? A. 3.45 C. 4.28 B. 2.47 D. 4.57
A three phase star connected alternator has a resistance of 0.5 ohms per phase and a synchronous reactance of 5 ohms per phase. It is exited to give 6600 V (line) on open circuit. Determine the terminal voltage and voltage regulation on full load current of 130 A when the load pf is (i) 0.8 lagging (ii) 0.6 leading pf
When a generator fails, its power output is lost, and the result is an imbalance between total load plus losses and total generation. Thus the frequency will: Select one: a. Remain the same b. None of these O c. Increase O d. Drop
1. Calculate the voltage regulation of a 230V, three phase alternator supplying the following loads connected in wye:a. R = 10 ohmsb. R = 3 ohms, XL = 4 ohmsc. R = 4 ohms, XC = 3 ohmsd. XL = 5 ohmse. XC = 5 ohms2. Calculate the value of each capacitor connected in WYE in part b of number 1 to have zero voltage regulation.
1. A single phase AC circuit consists of a 25 2 pure resistance. It is connected to an AC supply of 230 V at a frequency of 500 Hz. Determine the following: a. current b. power consumed and c. equation for the voltage d. equation for the current
A three-phase generator is connected to three 90 Q load resistors. Each coil generates 120 V ac. A common neutral line exists. How much current flows through the common neutral line? Select one: O a. 2.66A O b. 1.33A C. 3.99A d. 0 A
3.The voltage generated across one inductor of an alternator is 8.11V. There are 120 slots and 4 turns in every coil. The conductors are all in series and connected in double layer lap windings distributed sinusoidally in several slots. The coil pitch is 10 slots, frequency is 60 Hz and synchronous speed is 720 rpm. Calculate the line-to-line generated voltage if the alternator windings are connected wye. a. 2400Vb. 4160Vc. 4800Vd. 856V
What is the KW rating of a three phase 975 KVA generator at A) unity power factor B) 80% power factor C) 50% power factor
Two 800kW alternators A and B operating in parallel. The speed regulation of A is 100% to 103% from full load to no-load and that of B is 100% to 104%. Determine the kW share of A if the total load is 1200kW.
A 5 kVA, 208 V, three-phase AC is connected in wye. Determine: the voltage of each coil of the phase windings. the coil current at full load. the line voltage and current values at full load if the phase windings of the alternator are reconnected in delta
A star connected three phase alternator supplies power to a delta connected resistive load. The alternator has a line voltage of 480V. Each resistor of delta load has 8 ohm of resistance. Find the following values. Line voltage of the load (VL(load)) Phase voltage of the load (VP(load)) Phase current of the load (IP(load)) Line current delivered by the alternator (IL(alt)) Phase current of the alternator (IP(Alt)) Phase voltage of the alternator (VP(Alt)) True power
1. Which of the following applies to the instantaneous power in a single-phase ac circuit? A. Constant component B. Time varying component O C. Frequency of time varying component is twice the voltage or current D. All of these