11. What is the concentration of losartan in this suspension, in mg/mL? 12. An infant is prescribed the above medication with the directions: "15 mg PO Q 24 h for 30 days." What volume of losartan suspension should be dispensed? 13. What volume of the suspension can be produced if you only have 40 mL of Ora-Plus in stock? 14. Ora-Plus liquid contains carboxymethylcellulose sodium at a 1% (w/v) concentration. After mixing the ingredients, what will the final concentration of carboxymethylcellulose be, expressed as a percent concentration (w/v)?

11. What is the concentration of losartan in this suspension, in mg/mL? 12. An infant is prescribed the above medication with the directions: "15 mg PO Q 24 h for 30 days." What volume of losartan suspension should be dispensed? 13. What volume of the suspension can be produced if you only have 40 mL of Ora-Plus in stock? 14. Ora-Plus liquid contains carboxymethylcellulose sodium at a 1% (w/v) concentration. After mixing the ingredients, what will the final concentration of carboxymethylcellulose be, expressed as a percent concentration (w/v)?

Chemistry

10th Edition

ISBN:9781305957404

Author:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Publisher:Steven S. Zumdahl, Susan A. Zumdahl, Donald J. DeCoste

Chapter11: Properties Of Solutions

Section: Chapter Questions

Problem 138CP: Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as...

See similar textbooks

Similar questions

6-41 A teardrop with a volume of 0.5 mL contains 5.0 mg NaCI. What is the molarity of the NaCI in the teardrop?
Rubbing alcohol contains 585 g isopropanol (C3H7OH) per liter (aqueous solution). Calculate the molarity.
6-99 A concentrated nitric acid solution contains 35% HNO3. How would we prepare 300. mL of 4.5% solution?
6-22 Answer true or false. (a) Water is a good solvent for ionic compounds because water is a polar liquid. (b) Small covalent compounds dissolve in water if they can form hydrogen bonds with water molecules. (c) The solubility of ionic compounds in water generally increases as temperature increases. (d) The solubility of gases in liquids generally increases as temperature increases. (e) Pressure has little effect on the solubility of liquids in liquids. (f) Pressure has a major effect on the solubility of gases in liquids. (g) In general, the greater the pressure of a gas over water, the greater the solubility of the gas in water. (h) Oxygen, O2, is insoluble in water.
Graph Table 14.10 shows solubility data that was collectedin an experiment. Plot a graph of the molarity ofKI versus temperature. What is the solubility of KI at55°C?
If one is very careful, it is possible to float a needle on the surface of water. (If the needle is magnetized, it will turn to point north and south and become a makeshift compass.) What would happen to the needle if a drop of liquid soap is added to the solution? Explain the observation.
Specifications for lactated Ringers solution, which is used for intravenous (IV) injections, are as follows to reach 100. mL of solution: 285315 mg Na+ 14.117.3 mg K+ 4.9Q.O mg Ca2+ 368408 mg Cl 231261 mg lactate, C3H5O3 a. Specify the amount of NaCl, KCl, CaCl2 2H2O, and NaC3H5O3 needed to prepare 100. mL lactated Ringers solution. b. What is the range of the osmotic pressure of the solution at 37C, given the preceding specifications?