10) In carrier current protection the purpose of the wave trap is for trapping power frequency waves trapping high frequency waves entering into generators/ transformer unit both (a) and (b) none of the above

Q: e) Explain the most harmful harmonics for power transformers.

A: Need to find most harmful harmonics for power transformer

Q: Explain the construction, operation of single phase Induction type energy meter with necessary…

A: Construction of  Single phase induction type Energy Meter The basic working of Single phase…

Q: Define and draw unit circle. What is the significance of unit circle for system analysis?

A: to draw and define unit circle significance of unit circle for system analysis

Q: symmetric slab waveguide,

A: Here at cutoff, the mode propagating in a slab at a critical angle gives that the phase velocity…

Q: Sketch the figure and explain in detail about the HVDC circuit breakers

A: Given: The objective is to give an explanation about the HVDC circuit breaker with the figure

Q: Draw state diagram for sequence 11011 of non overlapping condition.

A: To draw state diagram each state is represented by a circle. The transition from one state to…

Q: Work Breakdown Structure for electrical bus

A: It is asked to show the Work Breakdown Structure of Electrical Bus system.

Q: circuit breaker

A: Duty cycle- The first cycle of circuit breaker in which circuit breaker completes one cycle is it's…

Q: 1.a. To create usable voltages for 120-volt loads, _______ are usually installed. A. photovoltaic…

A: Answer 1.a) To create usable voltages for 120-volt loads, Transformer are usually installed.…

Q: What is the difference between modules and ways ? and how many ways we need to construct a…

A: The Electrical distribution system consists of some standardized terminologies in which the…

Q: Distribution transformers are generally protected from damage due to excessive internal…

A: Ans: Option C is correct. Distribution transformers are  generally protected from damage due to…

Q: Define percentage line and load regulation

A: Line regulation-Line regulation refers to a power supply's capacity to maintain a constant output…

Q: Calculate the initial symmetrical short circuit current that will occur when a 3 phase short circuit…

A: We can re draw the given system as Let the base MVA of the system i.e SB 500MVA and base Voltage…

Q: What is the edge of using Phase Locked Loop Demodulator rather than other FSK demodulator circuits?

A: Lock section lock, PLL is a very useful RF building block. PLL uses the concept of minimizing the…

Q: Two generators rated 15 MVA, 30% reactance and 20 MVA, 50% reactance are connected to a common 12-kV…

A: In this question we will find fault current for symmetrical 3 phase fault occurs at bus bar...

Q: Explain all components

A: The functioning and purpose of each of the components can be explained as: The bias for the base of…

Q: OLTC and transformers

A: On-Load Tap Changing Transformer (OLTC)- For the purpose of voltage regulation in large transformer…

Q: In an AC LVDT system, measuring the output voltage alone gives an indication of the displacement…

A: Electrical devices are used for measuring electrical parameters, like current, voltage, and power.…

Q: the slip-rings replaced by separated segments In order to generate a bidirectional Voltage true /…

A: This statement is true or false?  "the slip-rings replaced by separated segments In order to…

Q: Give examples of three phase Im and single phase im

A: In this question we will write example of three phase induction motor and single phase induction…

Q: The X/R circuit ratio of an automatic reclosure is inversely proportional to the asymmetrical factor…

A: Automatic recloser: It a type of switchgear that is used in overhead electrical distribution system.…

Q: suppose we have micro wave link connect city A and city B, where the distance between them around…

A: Given, The distance between city A and City B, which are connected by micro wave link is 240 miles.…

Q: sequence components o

A: For PU system- PU value=Actual value/Base value

Q: Briefly describe how a distance can be measured by the method of phase comparison

A: From the method of phase comparison, the distance is measured indirectly by determining the number…

Q: For grounded systems, the _ for the service and the system bonding jumper for separately derived…

A: The equipment grounding conductor connections at the source of separately derived systems are done…

Q: What do you mean by cutoff voltage for JFET?

A: The JFET is the abbreviation for junction field effect transistor. There are two types of JFET…

Q: Name three common sources of interference.

A: Signals are a means of communication. Electrical signals are transmitted between sending point and…

Q: 3. What are the classifications of Core Loss and Copper Loss?

A: Electrical machines can be either generator or motors and transformers. They can be either Ac…

Q: 4. Why do you think this phase change took place.

A: IN THE MODULATION OF DOUBLE SIDEBAND SUPPRESSED CARRIER HAIR WE WILL USE SYNCHRONOUS DETECTOR AS A…

Q: Duestion of Write down the construction alternatOx with the an of diagram of operation. and write…

A: The alternator is also called the synchronous generator is an electrical machine that is used to…

Q: Some electricians do not bother to calculate the minimum size of neutral service conductor. They…

A: 3-phase star connection balanced system does not require a neutral wire in the system. Basically, in…

Q: a. What is meant by transmittive cell type in LCD construction

A: According to guidelines we need to solve only the first question. According to the question, we need…

Q: In ac analysis of transistor biasing circuits, coupling capacitors should be open circuit. True…

A: In DC analysis the coupling capacitors are replace by open circuit.  And In AC analysis the coupling…

Q: what is the Analysis of 3 Phase star connected circuit? please write introduction

A: Power systems include source and load at sending and receiving respectively. Three-phase sources and…

Q: is connected. Determine Foil current and output of transform

A: Transformer is a static device, which transfers electrical energy from one circuit to other circuit…

Q: ineed conclusion for this topic( improvement of transient stability by using turbine fast valving…

A: Turbine fast valving method : Fast valving is a means of reducing turbine mechanical input power…

Q: Flashing DC genreto

A: Flashing in DC Generator is completely related to the field winding of it. self excited DC generator…

Q: ransmission line

A:

Q: Classify faults in brief

A: Faults can be classified in various types: Open circuit faults and Short circuit faults. These…

Q: Pollution and pollutant standards in regards to power plants

A: Major power plants are thermal power plants and fuel of thermal plants is coal. Coal is major source…

Q: Why  the elements of Jacobian matrix belong to derivative of reactive power of a voltage controlled…

A: Voltage-controlled bus: It is also called a generator bus or PV bus. In this bus, the known…

Q: A 100-MVA, 18-kV generator is connected to a transformer. The generator has reactances of 19%, 26%…

A: Given: S=100 MVA VLmax.=18 kVReactances-Xd''=19% , Xd'=26% , Xd=130%Time constants-Td''=0.035 sec ,…

Q: a voltage standing wave ratio o

A: Reflection-When light wave passes through interface diagonally between two media if it gets…

Q: Circuit breaker usually operate under   A) after D. C. component has ceased B) transient state of…

A: Circuit breaker:- It is an electrical device which used as a switch for safety purposes. It protects…

Q: Supposed a 5000 kva, 13.8 volt, 60 hz, 3-phase capacitor bank with grounded neutral is being…

A: The power system has to transmit power from the generation side to the load side. For this purpose,…

Single Phase Induction Motor

The single-phase induction motor or engine consists of a single rotating phase in the stator and a rotating cage in the rotor. When phase one supply is connected to the stator winding, a magnetic field is generated. In the pulsating field, the rotor does not rotate due to inertia. So, a single-phase import motor does not start and requires some initial methods.