1. The two circuits shown below are taken from the lecture notes.Vs = 12V-tR₂R₁ΙΚΩOvVoutVOV32The thermistor RT has a resistor Ro = 1k2 initially, and all other resistances have the same valueof 1k02. When the temperature is raised slightly, the resistance decreases by an amount AR.a) If now, the position of RT is swapped with R2, deduce an expression for Vout for each case.(In the right picture, Vout = VCD).b) Make a plot of Vout vs T in case case. (T is assumed to be small).

Answered: Image /qna-images/answer/77de164e-e181-491a-a24f-eac00909107c.jpg

Answered: 1. The two circuits shown below are…

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

60 V D1 D2 2 kohm D4 D3 -60 V Assume that an input signal is applied to the circuit given above, as shown in the figure next to it. Accordingly, answer the following questions. The diodes used are silicon diodes, their operating voltages are 0.7 volts, and can be omitted because their resistance is very small. Write the name of this circuit, thinking about which circuit we do in the courses is equivalent to the purpose.
In the circuit shown below, if VA= 1V and V-2V, the statuses of the diodes are (Assuming ideal diodes) D₁ VA V₂₁ D₂ ERL Vout Select one: O a D₂ is ON, D₂ is ON O b. None of these Oc. Dy is OFF, D₂ is ON O d. Dy is ON, D₂ is OFF
Find the equivelent resistance of the circuit below. (Rin)Conduction diodes' resistance is 0Insulating diodes' resistance is infinite.R1 = 10 ohm
Diodes Are Connected In Series To Share A Total... 21 Question • Two diodes are connected in series to share a total reverse voltage of VD=D 5 KV. Reverse leakage currents of the diodes are ID1=30 mA and Ip2=35 mA. - Find Vp1 and Vp2 for R,=R2=100 k2 - Find R, and R2 for VD1=VD2 R1 VD1 Hint: Is=L,+IRj= I,2+IR2 VD R2 VD2
A thermistor is placed in a 200°C environment and its resistance measured as 30000Q. The material constant B is 3627°K. If the thermistor is then used to measure a particular temperature and its resistance is measured as 6002. The thermistor temperature in °C. Select one: O a. 573 Ob. 255 OC. 692.64 d. 965.64
A forward voltage of 1.75V shifts to the left at a rate 2.65mV per degree centigrade in temperature from 25°C to -35°C. What is the new forward voltage of the diode? * Your answer Find the reverse saturation current of a Silicon diode that displays a forward current of 20 mA at 0.75 V when the Thermal Voltage is 0.038 V. ( Express your answer in 3 decimal places. Your answer can be in p (pico) or n (nano) unit. e.g. only 5 nV. Upload your solution in the file upload question but type Final Answer here. * Your answer
What voltage is boosted at the output of a multiplier.Choices: average, rms, peak, or instantaneous Which assumption is not used in the analysis of multipliers?Choices: a capacitor will not discharge, start with the cycle of the source that will forward bias the nearest diode, the output will always be multiplied, or a single diode is forward biased at a time A voltage multiplierChoices: multiplies the output voltage, has very high voltage and low current ,can employ inductors, or may not have equal numbers of diodes and capacitors A voltage regulator maintains constant voltage at the load regardless of variations atChoices: the input and output, the load, source, or in the environment Between a lower percent regulation and a higher one, which is better?Choices: lower or higher
The input voltage Vi of the circuit shown in the figure changes as shown in the graph. A) Draw the graph of the output voltage Vo.B) Interpret the state of the diode in the circuit for 0-T / 2 and T / 2-T time intervals. the diode in the circuit is ideal. (R = 73)
Full-wave rectified sine wave circuit is used to measure the RMS value of a half square wave with the help of PMMC meter. The meter was actually calibrated for sine wave. The circuit uses a meter movement with a full scale deflection current of 200uA and internal meter resistance of 5kΩ. Assuming Non-ideal diodes having resistance 1kΩ, Analyze the circuit to determine the value of series multiplier resister and the corrected RMS voltage, if meter is to read 225V RMS full-scale.
Q2 (a) Figure Q2(a) shows a clipper circuit made with a gemanium diode. Given the voltage input, Vin = 20 Vp-p, VDc = 5 V, Rs = 10N and RL=1 kN. (i) Sketch the full cycle of input voltage, Vin(t) in sinusoidal waveform. (ii) Determine the output voltage values for all input values. Show all the calculations and support your answers with the aid of diagram. R. Vin Si Ge R VOUT Vpc Figure Q2(a)
The input voltage in the following circuit is Vs = 33.62 V rms and the frequency is 50 Hz. The value of R;=R2= 33.62 k2. What would be the maximum voltage that the voltmeter would measure (in Volts) if the diode has a forward voltage drop of 0.9 V. Vs (+ R1 0.5uF R2 0.5uF
a) Design a clamper circuit so that for the input waveform V,(t) as given in Figure 4(a), the output waveform V,(t) as shown in Figure 4(b) can be produced. You shall use ideal diode as part of your circuit design and provide the analysis of your design procedure with the aid of the simplified equivalent circuits. V(t) 10v- t2 t3 t4 t5 -10V (a) V.(t) 15V t1 to t3 t4 t5 -5V (b) Figure 4

SEE MORE QUESTIONS

Recommended textbooks for you

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Introductory Circuit Analysis (13th Edition)

Electrical Engineering

ISBN:

9780133923605

Author:

Robert L. Boylestad

Publisher:

PEARSON

Delmar's Standard Textbook Of Electricity

Electrical Engineering

ISBN:

9781337900348

Author:

Stephen L. Herman

Publisher:

Cengage Learning

Programmable Logic Controllers

Electrical Engineering

ISBN:

9780073373843

Author:

Frank D. Petruzella

Publisher:

McGraw-Hill Education

Fundamentals of Electric Circuits

Electrical Engineering

ISBN:

9780078028229

Author:

Charles K Alexander, Matthew Sadiku

Publisher:

McGraw-Hill Education

Electric Circuits. (11th Edition)

Electrical Engineering

ISBN:

9780134746968

Author:

James W. Nilsson, Susan Riedel

Publisher:

PEARSON

Engineering Electromagnetics

Electrical Engineering

ISBN:

9780078028151

Author:

Hayt, William H. (william Hart), Jr, BUCK, John A.

Publisher:

Mcgraw-hill Education,

SEE MORE TEXTBOOKS