1. The mean effective pressure of an engine running at 300 rpm is 500 kPa. What is the indicatedpower if the engine has bore of 250 mm x 450 mm. Select the correct answer below: A. 110.5 kW B. 150 kW C. 200 kW D. 182. 2 kW 2. In a certain process, entering is 1500 KJ/kg and 150 m/s. If the energy leaving is 12000 Kj/kg/ Determine the velocity at exit. Select the correct answer below: A.) 145 m/s B. 1020 m/s C. 789 m/s D. 978 m/s

1. The mean effective pressure of an engine running at 300 rpm is 500 kPa. What is the indicatedpower if the engine has bore of 250 mm x 450 mm. Select the correct answer below: A. 110.5 kW B. 150 kW C. 200 kW D. 182. 2 kW 2. In a certain process, entering is 1500 KJ/kg and 150 m/s. If the energy leaving is 12000 Kj/kg/ Determine the velocity at exit. Select the correct answer below: A.) 145 m/s B. 1020 m/s C. 789 m/s D. 978 m/s

Refrigeration and Air Conditioning Technology (MindTap Course List)

8th Edition

ISBN:9781305578296

Author:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Publisher:John Tomczyk, Eugene Silberstein, Bill Whitman, Bill Johnson

Chapter40: Typical Operating Conditions

Section: Chapter Questions

Problem 10RQ: The seasonal energy efficiency ratio (SEER) includes the energy used in the _____and _____cycles.

See similar textbooks

Similar questions

Q 1: For a particular gas system, the internal energy is given by : U = 2.5 PV + C , where P: Presure , V: volume and C : constant, the sysytem is taken into cycle shown in fig.(Q1) below with three Processes, Calculate Q & W if the pressure is given by P= 105+ 10° (v-0.02)² ? 05- 0.4 0.3E A 02E 0.1 0.01 002 003 V (m³) -> Fig. (Q1) P (MPa)
Q 1: For a particular gas system, the internal energy is given by : U = 2.5 PV + C , where P: Presure , V: volume and C : constant, the sysytem is taken into cycle shown in fig.(Q1) below with three Processes, Calculate Q & W if the pressure is given by P= 105+ 10° (v-0.02)² ? 0.5- 0.4E 0.3E A 0,2 A 001 002 003 V (m³) > Fig. (Q1) P (MPa)►
1. An engine from a quarry vehicle used in the Build a Beach program of DEMR has a power requirement of 560 kW. Per hour of its operation, it ejects 234 MJ into its surroundings at 50 °C. If it behaves like a Carnot engine, answer the questions below. A. How much work (MJ) is done by the engine per hour of operation? B. What is the efficiency (%) of the engine?C. What is the temperature (°C) of the hot reservoir? 2. Determine the entropy change (kJ/K) associated to the conversion of 10 kg of ice at -11 °C to steam at 121 °C. 3. Anna and Beth are using another rare metal, the nth metal (c = 0.600 J/g-℃), to build the 5-kg cuirass of their design. Initially, the metal is at 2250 K. It is then submerged to 10 kg of water at 15 °C. If the remaining liquid water after submerging the metal is 8.5 kg, solve for the net entropy change (kJ/K) of the system.
An engine burns a liter of fuel each 12 minutes …The fuel has specific gravity of 0.8 and a heating value of 45MJ/kg…The engine has an efficiency of 25%...What is the brake horsepower of the engine?
30. Steam enters a turbine 80 lbs of steam per minute with an enthalpy of 1700 BTU/lb and velocity of 98 ft/s. It leaves the turbine at 1400 BTU/lb at 880 ft/s. The heat loss is 90,000 BTU/hr. Find the horsepower output of the turbine.
5. An engine trom a quary vehicle used in the Buid a Beach program of DEMR has a power requirement of 560 kw. Per hour of its operation. it ejects 234 MJ into its suroundings at 50 °C. If it behaves like a Carnot engine, answer the questions below. a. How much work (MJ) s done by the engine per hour? b. What is the efficiency (%) of the engine? c. What is the temperature ("C) of the hot reservoir?
Show your complete solution for each problem. Only the final answer in your calculation should be rounded off to two decimal digits. Box your final answer. 1. The increase in the specific internal energy is 33.8 BTU/Ibm in a reciprocating compressor draws 40 lbm/min of air whose density is 0.074 lbm/ft³ and discharge it with a density of 0.311 lbm/ft³. At the suction, the pressure is 18 lb:/in² and discharge 88 lb:/in². If the changed in kinetic energy was neglected, determine the work on the air in horsepower (hp).
Q1/ A turbojet engine powers an aircraft that is flying at a speed of 240 m/s, has an exhaust speed of 560 m/s, and a specific thrust of 325 N s/kg. Using the three different formulae, . calculate the propulsive efficiency. What are your comments? (Neglect the fuel-to-air ratio). T gale efflux
3. Please calculate the annual electricity production of a wind farm with 20 turbines. The annual mean wind speed is 7 m/s and diameter of the blades is 20 m. If we assume power consumption of a person is 3,000 kWh, about how many people will this energy support? Annual electricity production (KWh) = K Vm³ At T Where: - - - K = 3.2 (factor based on turbine performance) Vm= annual mean wind speed (m/s) At = swept area of turbine (m2) T = number of turbines Suitable for medium- to large-scale wind turbines (> 200 m2 swept area)
Q1. Answer the following: - A- What are the differences between the heat and temperature? B- List two important factors that the specific heat of a gas depends on these factors? C- List three applications in your home depend on thermodynamic principle operation? D- Name the parameter that the nozzle utilizes to produce an increase in the kinetic energy? E- What is the important factor that the potential energy depends on it?
A steam turbine is operated under the conditions shown in the figure.Define:a. steam flow rate (kg/min) to produce 1000 kW powerb. actual steam rate (kg/kWh)!c. turbine efficiencyd. What type of steam turbine belongs to this?
A Carnot engine having a 340 x 620 mm bore and stroke operates between 500 degree Celsius and 50 degree Celsius. The engine rejects 45 kJ of heat in the atmosphere while running at 400 rpm. Assuming a four stroke engine. Find a. thermal efficiency ( %) b. Wnet (kJ) c. Power Produced (kW)