1. Exciter and rotor winding are isolated from earth, so how can you detect an earth fault in the rotor circuit? 2. Mark the protection zone for the differential relay, which relay protects if the fault appears outside this zone.

Q: 1000MW thermal plant has an overall efficiency of 34%. If the coal used has a heating value of…

A: In this question we will find coal consumption of given plant per hour with given data..

Q: 02: Determine the stable range of the parameter (a) for the closed-loop unity feedback systems with…

A:

Q: 2. The input to a 11-kV, 30, Y-connected synchronous motor is 60 A. The effective resistance and…

A:

Q: n0 O A. po'p1 + b

A:

Q: A string insulator has 6 units. The voltage across the bottom most until is 20% of the total…

A:

Q: 5. A parallel-plate capacitor has a plate area of 0.2m² and a plate separation of 0.1 mm. If the…

A:

Q: 14MA J=1A V 23 KQ

A: Resistance: Resistance opposed the flow of current in electric circuit. It is measured in Ohm's(Ω).…

Q: Given: Vi = Vpeak Sin wt V Vpeak %3| = 5 V With the ideal foward voltage = 0.7V, draw the waveforms…

A: It is given that: V1=VPeak Sin ωtVPeak=5VRL=1KΩVD=0.7V

Q: Calculate the output oltage in v of an opamp circuit with Vd=0.6 V. Vc=0.4 V, Ad=126 and Ac=2.

A:

Q: 1- A single phase transformer with a ratio of 6600/400 V takes to no-load current of 0-7 A at 0-24…

A: Since you have asked multiple questions in a single request, we will be answering only the 1st…

Q: Extrinsic semiconductor is needed to develop an electronic device. Explain how the material is…

A: When some impurity is added to pure or intrinsic semiconductor then the material formed is called…

Q: The coil of a PMMC instrument has 60 turns, on a former that is 18 mm wide, the effective length of…

A: The pmmc coil can be solved by using below formula.

Q: Is there a way to clean up this answer by using proper notation

A:

Q: An A.C. supply voltage source v(t)=12 sin (377t) volt is connected in series with 50 N resistor. The…

A:

Q: Which of the following statements is true about a Moore sequential machine? A. The outputs of a…

A:

Q: (B)Using the Fourier Transform, integral, pairs and properties, evaluate: f(t)=cos(24t).sin(64t

A:

Q: Q3: For the system of Figure 1, given G(s) = and C(z) Find the closed-loop transfer function and…

A: To find the close loop transfer function of the system and also find the characteristic equation

Q: A.) 1 example of DC analysis of darlington pair solved problem.

A: NOTE:- As per our company policy, experts are allowed to answer only 1 Question at a time, so only…

Q: E8.24 Find V, in Figure E8.24 using Thevenin's theorem. ANSWER: V, = 1.4654/-12.34° V. 40 24/0" V j4…

A:

Q: The generator of a motot-generator set is delivering its full-load output of 10 kilowatts. The…

A: Given  data: The given out put of motor generator output = 10 kW The generator…

Q: Determine the cutoff frequency of an op-amp having specified values B1=4 MHz and AVD= 171 V/mV.

A: Given  Bandwidth and voltage gain of an op amp.we need to determine the cutoff frequency. Please…

Q: 1. A 3-phase, 400-V, synchronous motor takes 52.5 A at a power factor of 0.8 leading. C: power…

A: In this question we will find power supplied tp motor and induced emf with given data... Note:- as…

Q: supply has three inductive coils each having resistance of 16 ohms and reactance of 12 ohms and are…

A:

Q: 17. In the standard notation for a voltaic cell, the double vertical line represents? A. a phase…

A: Voltaic cell based on Electromagnetic chemical reactions  Electric current through voltaic cell…

Q: 4. bus throughput Consider a serial bus (1 bit wide) that runs at 2GHZ, using alternate cycles for…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 1. For the given circuit, sketch the waveform for Q. CIk Q D- Clk

A:

Q: The outputs of combinatorial logic circuits are simply reliant on the inputs

A: In this question we will write about combinational logic circuits output....

Q: Which circuit? Look at the 2 circuits below. Ia. In which circuit is the voltage the biggest? b.…

A: For the given two circuit answer the following Questions : As we can observe from the given…

Q: Given this control system in Figure 1, find K so that there is 10% error in the steady state for a…

A:

Q: %3D What must be the value of Rf so that the Op-amp circuit below will oscillate. Also find the…

A: We need to select correct option for given circuit

Q: E8.23 Use (a) superposition, (b) source transformation, and (c) Norton's theorem to find ANSWER: V,…

A: The total current in any portion of a linear circuit equals the algebraic sum of the currents…

Q: For a coaxial cable, the magnetic field strength at a radius less than the ? conductor's inner…

A: To find the magnetic field intensity in the coaxial cable, apply Ampere circuital law As per Ampere…

Q: H.W: for the circuit shown in figure find: (a) the charge in each capacitor. (b) The energy in each…

A:

Q: Given this transformer with load, what is the expected phase of the primary and secondary voltage?…

A: The solution is provided in the following section.

Q: Two wattmeters are used to measure power input to a 1.5 kV, 50 Hz, 3-phase motor running on…

A: NOTE- As per the rules we can answer only 3 sub-parts, please post the remaining sub-parts as the…

Q: A waveform Vin ranged from 0 to 3 V needs to be scaled so the signal range is (-3,+3} V without…

A: First input and output relationship is obtained. Using superposition theorem remaining problem is…

Q: Find the total current flowing in the circuit. Show me the solution it would really help.

A: In this question,   We need to determine the total current flowing in the circuit?  If two…

Q: A mobile phone base-station is on a 11 m high mast which stands on top of a hill of height 32 m…

A: given data, hr = 11 m We know that in LOS communication distance (d) given by- d = 4.12(ht+hr)  Km

Q: The winding of a 3-phase, 6 pole, 60 cycle alternator has 2/3 pitch. What is the chording angle

A: Chording angle is defined as the angle by which pitch are shorted. A full pitch coil having zero…

Q: n op-amp has an open-loop gain of 80,000. Vsat = ±14 V. A differential voltage of 0.5 V p-p is…

A: 1) A circuit that can change the frequency of oscillation with an application of a dc voltage is…

Q: What is the level of the current through the input(s) of an op-amp? O a. 1.7mA O b. infinite O c.…

A: 1) When the bypass capacitor is removed from a common-emitter amplifier, the voltage gain 2) What is…

Q: e condition for positive feedback is that the phase shift around the feedback loop must be D a. 90 O…

A: These are the few questions related to the understanding of significance of negative sign in the…

Q: Q.1. The gain margin (in dB) of a system having the loop transfer function G(s)H(s)-(2)"/(s(s+1) is…

A:

Q: 14. use an etemally generated electrical current to produce a chemical reaction that would 14 not…

A: Salt bridge is a laboratory device also called ion Bridge uses an eternally generally electrical…

Q: Derive an expression for sag in a transmission line of equal hight poles.

A: Given: The poles are of equal height.

Q: 12V 子 什トA 28 K2 14MA J=1A J=1 A 上4Ka 23 KL V= ?

A:

Q: 1: What are the main characteristics that a communication device can exhibit? Explain in a brief…

A: Communication devices are the part of communication system as the system includes all the hardware…

Q: Q14/> 412 (in Volts) 1KO 2 3 10V 5V 1KO 1KO se NODE Analysis technique to find the all voltages and…

A:

Q: Given: V1 = Vpeak sin wt V Vpeak = 5 V With the ideal foward voltage = 0.7V, draw the waveforms of…

A:

Q: 4. Complete the timing diagram for the gated SR latch based on the Table 4. Assume that the input…

A:

Thermistors

A thermistor is a special type of resistor whose resistance is more temperature-dependent than standard resistors.  The resistance of the thermistor decreases with increasing temperature. This is the basic principle of thermistors. This allows the thermistor circuit to detect very small temperature changes that cannot be observed with the Resistance temperature detectors (RTDs) or the thermocouples. Since the resistance of a thermistor is temperature dependent, it can be connected to an electrical circuit to measure body temperature. This high sensitivity to temperature changes makes thermistors very useful for accurately controlling and calibrating temperature measurements. In general, resistance increases with increasing temperature in most metals, but thermistors react negatively.