1 ohm 2 ohm ww 3 ohm ? Calculate the total current in the circuit www 4 ohm www 5 ohm www 120 V 20 AO 11.43 A 15.5 A 10.4 A O

Q: The switch 62 t=0 -www- 622 30v www opens 62 ↓i(t) H 10V when t=o. Compute i(t) when to with -10 F

A: The circuit diagram,

Q: VIN R V= 43,68 V, RL = 2,77 k2 and VZ= 10,68 V PDmax=1,5 W Find Rmin? Vz 1,5W VOUT 4

A:

Q: re, Zi,Zo,Av =? With CE Capacitance and Without CE Capacitance.

A: The required parameters can be calculated by using the DC and AC analysis of the amplifier circuit.

Q: Solve the given circuit using node method:

A: The node voltage need to be calculated by using the nodal analysis. Since the dependent voltage is…

Q: Electric space-heating cables shall not be installed over cabinets whose clearance from the ceiling…

A:

Q: -2 Define mathematical expression for each x₂ (t) where i = 1, 2, 3 using the elementary…

A: Given: A signal x(t),  To do: We have to define mathematically the following signals in the terms…

Q: and 0 The radius of the inner conductor of a long coaxial cable is a. The inner radius of the outer…

A: According to the question, The radius of the inner conductor of a long coaxial cable is a. The inner…

Q: x₁ (t) t -2 Define mathematical expression for each xi (t) where i = 1, 2, 3 using the elementary…

A: it is asked to represent the given waves with respect to reference wave

Q: Find the output current io in the circuit shown below using superposition, where vs = 24 cos(4) V.…

A:

Q: 3. In the circuit below, the switch has been closed for a long time before opening at t = 0. Find…

A:

Q: #₁(t) = t -2 Define mathematical expression for each , (t) where i = 1, 2, 3 using the elementary…

A: We need to represent the given signal with respect to reference Signal.

Q: Question 7 Draw a circuit that computes the function described by the input/output table. You may…

A:

Q: 1 000kVA 34500/400 Volt Dy connected distribution transformer has an electrical load of 500 kVA with…

A: Transformer rating; 1000 KVA, 34500/400 Load KVA; SL=500 KVA Power factor; cosϕ=0.8  (Lagging) To…

Q: explain the process to get Vout. i am no the best at Kvl or voltage potential

A: Need to explain the process for applying kvl to the loop to get the required value across the…

Q: Write the resulting function by performing the simplification on the 6-variable discrete Karnaugh…

A: We need to determine the simplified expression using K-map.

Q: Find the voltage in V at node A in the given circuit. For given circuit find voltage at node A in V.…

A: In this question we need to find the voltage at node A

Q: can you explain to me a bit more, so I understand everything until you get the solution. I see how…

A:

Q: Where multimotor and combination-load equipment for air- conditioning and refrigeration is installed…

A: Grounding refers to the connection of electrical equipment or installations to the earth or a…

Q: A 120V per phase, three-phase source delivers power to the following delta- connected load: Phase 1…

A:

Q: How can you protect your equipment from possible threats such as power surges?

A: In this question we discuss about how can you protect your equipment from possible threats such as…

Q: The total inductance for this circuit is The total inductance for this circuit is The total…

A:

Q: R1 R3 +6²-²² R2 Vg a b t=0 Find the expression of the current i in the time domain. i(t)= L The…

A:

Q: A three-phase slip ring induction motor develops full load torque at a slip of 0.04 when the slip…

A:

Q: The impedance connecting node 3 to neutral is: Select one: a. jo b. j0.8 c. -j1.25 d. -j4.55 The…

A: The impedance and admittance connected to node 3 to neutral needs to be obtained from the given…

Q: A B C D (b) D X

A: it is asked to provide the Boolean expression for the logic circuit in the image

Q: Identify the nature of the signals f(1) 41 Discrete time & discrete amplitude L 1- f(1) x f(1)…

A: The different type of signal waveform,   To find- Nature of signal.

Q: It is known that the circuit shown in the figure has kpss = 14 mA, Vp = -8 V, VGso = -3.2 V, RG = 1…

A:

Q: In the network given below, find io(t) for t> 0 using the differential equation approach. Please…

A: In this question we need to find the current io(t) for t>0.

Q: 3. Using Gauss Law calculate the net Electric flux of a hallow sphere containing four charges…

A: charges inside the hollow sphere are  Q1 =1nC Q2 = 3 nCQ3 =1 nCQ4 =-2 nC

Q: A linear dynamical system is described by i(t): = Az(t), where A = (a) Find the characteristic…

A: Part a solution is in step 3 please refere that section first

Q: A three-phase, star connected alternator has a nameplate rating of 100kVA, 4160V, three phase, 60Hz,…

A:

Q: D3.5. A point charge of 0.25 µC is located at r = 0, and uniform surface charge densities are…

A:

Q: In the circuit given in the figure, Vcc= 12 V, Vin = 10 mV, B = 100, ro = 40 kn, RB = 360 kn, RC =…

A: The required ratio of output voltage to the input voltage can be calculated by using the DC and AC…

Q: A three-phase, 50Hz transmission line with a length of "240" is given. It has values of “27” MVA,…

A:

Q: 2. Determine the voltage e, across the 20-01 resistor. 15 Vi 4012 www 1512 www 2012

A: In this question, we need to determine the output voltage Vo   We are solving problem using the…

Q: EXAMPLE 3-1 Determine the electric field intensity at P(-0.2, 0, -2.3) due to a point charge of 1.5…

A:

Q: (iii) Develop & describe the neat circuit diagram of percentage differential relay for protection of…

A: It operates on the basis of the phase difference between two or more similar types of electrical…

Q: Describe the traces you would see on an oscilloscope monitoring voltage changes across a resistance…

A:

Q: A 120V per phase, three-phase source delivers power to the following delta-connected load: Phase 1 =…

A: In this question We need to determine the three phase currents.  Phase currents are given of the…

Q: Use Nodal Analysis to find the unknown currents shown in the circuit.

A: The unknown current in the circuit needs to be calculated by using the nodal analysis.

Q: A linear dynamical system is described by i(t): = Az(t), where A = (a) Find the characteristic…

A:

Q: Find Vx using the Thevenin Equivalent Circuit AND Norton Equivalent Circuit. Show these circuits and…

A:

Q: 1) Three identical synchronous generators were connected in parallel and the idle frequency values…

A: The amount of power that a generator creates and distributes to the load is known as its active…

Q: The parameters of a three-phase transmission line are given as Z = (12.84 + j72, 76)Ω and y = j5,…

A:

Q: Exercise 2.1 Write a Boolean equation in sum-of-products canonical form for each of the truth tables…

A:

Q: . Consider x(n) = {4 5 6 7} with length N = 4, a) Find its discrete Fourier transform (DFT) X(k). b)…

A: Given, Discrete sequence is x(n) = {4,5,6,7} Length of x(n), N=4; We need to determine a) DFT of…

Q: For a certain electrical circuit the applicable differential equation is 100(d2i/dt2) + 200(di/dt)+…

A:

Q: 2.12. Consider a system with input x[n] and output y[n] that satisfy the difference equation y[n] =…

A:

Q: A 120V per phase, three-phase source delivers power to the following delta- connected load: Phase 1…

A:

Q: 2.) The total capacitance of two Capacitors in series is 3MF. The first has a capacitance GMF and…

A:

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.