Consider a system consisting of the cascade of two LTI systems with frequency response2 - e-jw1+e-jandH₁(elw)H₂(el) ==111-1/72e-1² + 4e²--12w1) Find the difference equation describing the overall system;2) Determine the impulse response of the overall system;3) Use adders, multipliers, and delay units to draw the block-diagrams of H(el) in Directform I, Direct form II, cascaded form and parallel forms.

Answered: Image /qna-images/answer/1178e485-d0f7-43f5-8a64-8e2033a89334.jpg

Answered: 1) Find the difference equation…

Engineering

Electrical Engineering

1) Find the difference equation describing the overall system;

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

PleaseThe input-output relationship of a discrete-time LTI system is given as follows?[n] = 2x[n − 4] − 3x[n − 6].a) Determine the impulse response of the system, h[n].b) Using h[n], show that the system is causal.c) Using h[n], show that whether the system is BIBO stable or not.d) Determine the transfer function H(z). Plot pole-zero diagram. Indicate ROC.e) Using H(z), show that whether the system is stable or not.f) Determine the frequency response of the system, if exists. Why?g) Determine the impulse response of the inverse system calculated in f).
A stable input signal x(n) is applied to an LTI system with unit impulse response h(n)=2δ(n)+ (1/2)'' u(n), and the output is y(n)=2(1/4)'' u(n) is obtained.a) Find the frequency response, H(ejw), of the system.b) Find the x(n) sign and spectrum applied to the input by DTFT.c) Give the input/output differential equation of the system.
The impulse response of an LTI system is h(n) = 3δ(n) + (1/4)n u(n). Find the frequency response, H(e jω), and the difference equation of this system. An input signal x(n) = (1/3)n u(n), is applied to this system and an output signal y(n) is observed. Find the output signal, y(n), using DTFT methods. Give the system function H(z) using the frequency response H(ejω). Find the zeros, poles and ROC of this system and show them on the complex plane. Discuss the stability, causality, FIR/IIR and memory properties of this system.
b) G(?)=K [(S−1)(S−2) / (S+2)(S+3)] ; Construct nyquist curves for K=1, 5/3, 9 values. Write down the Nyquist stability criterion and explain whether the system is stable or not. c) Define the gain and phase margin, this time on the nyquist curve.
Q3 in a digital telephony network, the signal of human voice needs to be sampled and digitized before transmission. it is found that limiting the bandwidth of human voice to 3000 hz would be enough to ensure good-quality phone calls. a. Human voice contains frequency components above 3000 Hz. How canwe ensure that the voice signal will only occupy a bandwidth of 3000Hz? b. The sampling rate is determined to be 50% higher than the Nyquistsampling rate. Determine the sampling rate c. A pulse-code modulation (PCM) scheme is used to represent thedigitized voice signal, where 10 bits are used for each sample.Determine the data rate of a single voice call. d. Time-division multiplexing (TDM) is used to aggregate a maximum of 40voice calls in a telephone line. Determine the maximum data rate thatyou can observe over a telephone line. e. Determine the minimum required bandwidth of the telephone line thatcan support a maximum of 40 phone calls.- d. Explain what…
Determine the z-domain transfer function for each of the following LTI systems. The impulse response for these expressions is denoted by h[n], the input signal by x[n], and the output signal by y[n]. Provide your response as the ratio of two finite-order z polynomials or as a z polynomial of finite order. Assume that the input signal starts at n = 0 or later in every scenario. For n < 0, further suppose that y[n] = 0. Indicate if the system is IIR or FIR.
1.Find the impulse response of the equivalent system (i.e,, find h[n]) such that y[n]=x[n]∗y[n]holds where h1[n]=h[n]+0.5drag[n−1], h2[n]=0.5drag[n]−0.25drag[n−1], h3 [n]=(0.5)n u[n]with u[n]denoting unit-step function. this is a signal systems question
1. Since this is a first order system, provide expression for the time constant. 2. Provide a state space representation of the system. 3. Obtain the transfer function of the system using the state space model. 4. Determine the control gain Kp that results in steady-state error of 0.1
Scale the inductor and capacitor so that themagnitude and the phase angle of the output current do not change whenthe input frequency is changed from 20 krad/s to 500 rad/sec.1. What are the scaled values of the inductor and capacitor?2. What is the steady-state value of the output current, io, when theinput current is 400 cos 500t mA?
d2y(z)/dz2 + 3(dy(z)/dz) + 2y(z) = 3(dx(z)/dz) +2x(z) The above is a linear differential equation. Let's assume x(z) and y(z) as the input and output of an RC sytem respectively. a.Suppose there is an application of an impulse x(z) = δ(z) determine the output y(z) of the system. b.Determine the frequency response & transfer function of the system Also plot the 0-pole locations of the system.
A robotic system with transfer function ?(?) =(100)/(s(0.1s+1)(0.1s +1)) is controlled with gain K as shown in the figure. A)To analyze the frequency response of this system, draw the Nyquist graph. B)Apply the Nyquist stability criterion. C)Verify the stability analysis you made in part (b) by plotting root locus plots for the positive and negative values of the K gain. D)Calculate the gain value that makes this system borderline stable and show it on Nyquist and Root locus graphs. E)Calculate the gain margin, phase margin, gain crossover frequency and phase crossover frequency values. F)Explain whether the system is stable over the gain margin and phase margin values. WE NEED TO SOLVE THE PROBLEM IMMEDIATELY. PLEASE HELP.
You are given an unknown digital system with just the information that it is stable and causal. You are supposed to determine the frequency response and impulse response of it, so you apply a known input x(n) = u(n) to the system and observe y(n) = (30/13) [ 0.8n – (-0.5)n ] u(n) output. Give the system function H(z), its ROC, and the frequency response H(ejω). Calculate the impulse response h(n). Give the difference equation of the system. Is this system FIR/IIR ?