Problem Solving (Show your Solution)1. For the following circuit:(STEM)1.Find the total resister value RT2.Find the current ive STEM3. Find the voltage across the individual resistorsadvance1 kf22 kS212V1 k2in.3 reacempTeSC3. A nerve fiber may be approximated as a cylinder with a diameter of 1x10-5 m and length 2.0x10-1m. Find the resistance of this nerve fiber if it resistivity 2.5 Q-m.

Answered: Image /qna-images/answer/3b1c32e3-f10c-4ef9-8d3c-c6281d434012.jpg

Answered: .For the following circuit: 1. Find the…

.For the following circuit: 1. Find the total resister value RT 2. Find the current i 3. Find the voltage across the individual resistors I ka 2 ks2 12V 1 k2

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Directions: Solve for the given problems. Show your complete solutions. Express your final answers into 3 significant figures. The terminal voltage of the battery in figure 4 is 16.6 V. What is the resistance R of the external resistor? What is the internal resistance r of the 18.0-V battery? What should be the diameter of an aluminum wire for its resistance to be equal to that of a copper wire which diameter is 2.17 mm? The two wires are of the same length. ρ (Copper) = 1.68 x 10-8 Ωm ρ (Aluminum) = 2.65 x 10-8 Ωm
Directions: Solve the problem in each situation below. Write the given, show your solutions and box your final answer. Do not forget to affix the corresponding unit symbols for your final answer. Write your answers on a separate sheet of paper. 1. Identify the material used with a roll of 300 m electric wire with a resistance of 5.540. The gauge of the wire is found to be 16.
Directions: Solve for the given problems. Show your complete solutions. Round off your answers into 3 significant figures. 3. An ideal voltmeter is connected to a 2.0-Ω resistor and battery with emf of 5.0 V and an internal resistance of 0.5 Ω as shown in figure 6. a. What is the current in the 2.0-Ω resistor? b. What is the terminal voltage of the battery? c. What is the reading on the voltmeter?
DIRECTIONS: Solve the following given problems with complete solutions and answers. 2. The parallel combination of 40 ohms, 60 ohms and 120 ohms is connected in series with a 15 ohm and 25 ohm resistors. The whole network of resistors is connected to a 120 V line. Determine (a)total current, (b) current passing through the 15 ohms resistor, (c) the potential drop across the parallel group of resistors,(d) the voltage across the 40 ohms and (c) the current through the 120 V resistors. More Edit II :
Answers to the following question will be relevant for the in-labs. Please note your answers when going in for the main lab session. 3. Ohm's law can be sated as V = IR. a. Suppose in an experiment, data is collected of the variation of current with resistance R. Next a plot of R vs I'is made. How does one determine the value of V from that graph? (Explain your answer using an appropriate expression.) b. Instead of measuring resistance suppose that in (a) data of the variation of current with the length of wire is collected. Show how such data can be used to determine the resistivity of the wire.
Directions: Solve for the given problems. Show your complete solutions.Round off your answers into the proper number of significant figures.1. What diameter must a copper wire have if its resistance is to be the sameas that of an equal length of aluminum wire with diameter 3.45 mm?
pls see the attached picture, thank you!A. Theoretical Development. 1. (a) Design an ammeter with three scales: 0-200 µA, 0-2 mA, and 0-10 mA. Use a current sensor rated at 200 μA, 100 mV. What resistance does the instrument insert in the circuit at each scale? (b) Using the same current sensor as in (a), design a voltmeter with two scales: 0-10 V and 0- 100 V. What is the maximum current the instrument draws from the circuit for each scale?
Directions: Solve the following problems below. Show your complete solution. Use the Rubric as your guide in answering. The rubric shall be used by the teacher in checking your answer. Use a separate sheet of paper for your answer 1. Compute the resistance of a hardened copper rod 2 meters long and 8 mm in diameter if the resistivity of the material is 1.756 x 10-8 ohm-meters. 2. A 0.500-meter length of wire with a cross-sectional area of 3.14 x 10-6 meters squared is found to have a resistance of 2.53 x 10-3 ohms. According to the resistivity chart, from what material is the wire made?
Base your ans wer to the question on the information and diagram below. A 20.-ohm resistor and a 30.-ohm resistor are connected in parallel to a 12-volt battery as shown. An ammeter is connected as shown. 12 V 20. 30. 2 Figure 1 5. [Refer to figure 1] What is the current reading of the ammeter? 1. 1.0 A 3. 0.40 A 2. 0.60 A 4. 0.20 A 6. A physics student is given three 12-ohm resistors with instructions to create a circuit that would have the lowest possible res istance. The correct circuit would be 1. a series circuit with a total resis tance of 36 ohms 2. a series circuit with a total resis tance of 4 ohms 3. a parallel circuit with a total resistance of 36 ohms 4. a parallel circuit with a total resistance of 4 ohms
PROBLEM SOLVING. Write your complete solution and box your final answer. 1. The large window air conditioner in Anita Breeze's room draws 11 amps of current. The unit runs for 8.0 hours during the course of a day. Determine the quantity of charge that passes through Anita's window AC during these 8.0 hours. 2. The heating element of an electric toaster is typically made of nichrome wire (an alloy of nickel and chromium). As current passes through the wires, the wires heat up, thus toasting the toast. Estimate the overall resistance of a heating clement which is 220 cem long and consists of nichrome wire with a diameter of 0.56 mm. The resistivity of nichrome is 110x10" N-m. 3. A power saw at the local hardware store bousts of having a 15-Amp motor. Determine its resistance when plugged into a 110-Volt outlet. 4. A defibrillator passes 12.0 A current through the torso of a person for 0.0100 s. How much charge moves? How many electrons pass through the wires connected to the patient? 5.…
Solve for the given problems. Show your complete solutions. Round off your answers into 3 significant figures Refer to figure 7. a. Find the current in the circuit. b. Find the terminal voltage Vab of the 16.0-V battery. c. Compute for the potential difference Vac.
Answer the following. Write your solution and box your final answer on each question. 1. What charge flows past a point in a wire in 6.0 s if the wire carries a current of 2.0 A? 2. If a circuit element can withstand a maximum current of 15 A, how many electrons can pass through it each second?3. How many electrons are transferred in a 10.0 A current that runs for 3.0 s?4. If 2.00 × 102mA of current flows through the filament of a light bulb, how many electrons would pass through the filament in 30.0 s?5. What feature of a river is most similar to current in an electric circuit? (A) The depth of the river measured in meters (B) The temperature of the water measured in degrees Celsius (C) The vertical drop between two points along the river measured in meters (D) The volume of water moving past a point measured in liters per second