Effects of Temperature, pH, Enzyme Concentration, and Substrate Concentration on Enzymatic Activity
INTRODUCTION
Enzymes, proteins that act as catalysts, are the most important type of protein[1]. Catalysts speed up chemical reactions and can go without being used up or changed [3] Without enzymes, the biochemical reactions that take place will react too slowly to keep up with the metabolic needs and the life functions of organisms. Catecholase is a reaction between oxygen and catechol [2]. In the presence of oxygen, the removal of two hydrogen atoms oxidizes the compound catechol, as a result of the formation of water [2]. Oxygen is reduced by the addition of two hydrogen atoms, which also forms water, after catechol is
…show more content…
The hypothesis is as the substrate concentration has an increase so will the reaction of velocity if the amount of enzyme is kept constant.
MATERIALS AND METHODS To study the effects of temperature, pH, enzyme concentration, and substrate concentration there were certain steps that were followed in order to conduct this experiment. Each factor had a separate procedure to follow to find how each had a different effect on the enzyme.
To find the effect of temperature on the activity of an enzyme, the experiment deals with the steps as follows. First, 3 mL if pH 7 phosphate buffer was used to fill three different test tubes that were labeled 10, 24, and 50. These three test tubes were set in three different temperature settings. The first test tube was placed in an ice-water bath for ten minutes until it reached a temperature of 2° C or less. The second tube’s temperature setting was at room temperature until a temperature of 21°C was reached. The third tube was placed in a beaker of warm-water until the contents of the beaker reached a temperature setting of 60° C. There were four more test tubes that were included in the procedure. Two of the test tubes contained potato juice were one was put in ice and the other was placed in warm-water. The other two test tubes contained catechol. One test tube was put in ice and the other in warm water. After
In this lab or experiment, the aim was to determine the following factors of enzymes: (1) the effects of enzymes concentration the catalytic rate or the rate of the reaction, (2) the effects of pH on a particular enzyme, an enzyme known and referred throughout this experiment as ALP (alkaline phosphate enzyme) and lastly (3) the effects of various temperatures on the reaction or catalytic rate. Throughout the experiment 8 separate cuvettes and tubes are mixed with various solutions (labeled as tables 1,3 & 4 in the apparatus/materials sections of the lab) and tested for the effects of the factors mentioned above (concentration, pH and temperature). The tubes labeled 1-4 are tested for pH with pH paper and by spectrophotometer, cuvettes 1a-4a was tested for concentration and cuvettes labeled 1b-4b was tested for temperature in four different atmospheric conditions (4ºC, 23ºC, 32ºC and 60ºC) to see how the enzyme solution was affected by the various conditions. After carrying out the procedures the results showed that the experiment followed the theory for the most part, which is that all the factors work best at its optimum level. So, the optimum pH that the enzymes reacted at was a pH of 7 (neutral), the optimum temperature that the reactions occurs with the enzymes is a temperature of 4ºC or
• Fourthly, we kept the temperature at a constant 25°C using a water bath. At low temperatures, an increase in temperature causes an exponential increase in enzyme activity. This is because an increase in temperature provides more kinetic energy for the collisions of enzymes and substrates, so
I put one test tube for each control, substrate, and enzyme in the 4° C (ice bath), 23° C (room temperature), 37° C (body temperature), and 60° C (water bath). Add the inhibitor that was used and what it was used for.
The use of multiple test tubes and Parafilm was used for each experiment. Catechol, potato juice, pH 7 phosphate buffer, and stock potato extract 1:1 will be used to conduct the following experiments: temperature effect on enzyme activity, the effect of pH on enzyme action, the effect of enzyme concentration, and the effect of substrate concentration on enzyme activity. For the temperature effect on enzyme activity, three test tube were filled with three ml of pH 7 phosphate buffer and each test tube was labels 1.5 degrees Celsius, 20 °C, and 60 °C. The first test tube was placed in an ice-water bath, the second test tube was left at room temperature, and the third test tube was placed in approximately 60°C of warm water. After filling the test tubes with three ml of the
Enzyme catalysis is dependant upon factors such as concentration of enzyme and substrate, temperature and pH. These factors determine the rate of reaction, and an increase in temperature or pH above the optimum will
Students will be observing normal catalase reaction, the effect of temperature on enzyme activity, and the effect of pH on enzyme activity in this experiment. The enzymes will all around perform better when exposed in room temperature than when it is exposed to hot and cold temperatures. This is based on the fact that the higher the temperature, the better the enzymes will perform, but as the temperature reaches a certain high degree, the enzymes will start to denature, or lose their function.
Hypothesis: I believe the rate of reaction will speed up as the temperature increases until it reaches about 37oC, which is the body temperature, where it will begin to slow down and stop reacting. I believe this will occur because enzymes have a temperature range at which they work best in and once the temperature goes out of this range the enzyme will stop working.
Lab six requires students to observe the effects of pH and enzyme concentration on catecholase activity. Enzymes are organic catalysts that can affect the rate of a chemical reaction depending on the pH level and the concentration of the enzyme. As pH comes closer to a neutral pH the enzyme is at its greatest effectiveness. Also at the absorbance of a slope of 0.0122 the enzyme is affected greatly. The pH effect on enzymes can be tested by trying each pH level with a pH buffer of the same pH as labeled as the test tube and 1mL of potato juice, water, and catechol. This is all mixed together and put in the spectrophotometer to test how much is being absorbed at 420nm. As the effect on enzyme concentration can be tested almost the same way. This part of the exercise uses different amounts of pH 7-phosphate buffer and potato juice, and 1mL of catechol mixed together in a test tube. Each substance is put in the spectrophotometer at a wavelength set tot 420nm. The results are put down for every minute up to six minutes to see how enzyme concentration affects reaction rate. The results show that the pH 8 (0.494) affects the enzyme more than a pH of 4 (0.249), 6 (0.371), 7 (0.456), and 10 (0.126). Also the absorbance is greatest at a slope of 0.0122 with test tube C that has more effect on the reaction rate, than test tube A, B, and D.
Background and Introduction: Enzymes are proteins that process substrates, which is the chemical molecule that enzymes work on to make products. Enzyme purpose is to increase the rate of activity and speed up chemical reaction in a form of biological catalysts. The enzymes specialize in lowering the activation energy to start the process. Enzymes are very specific in their process, each substrate is designed to fit with a specific substrate and the enzyme and substrate link at the active site. The binding of a substrate to the active site of an enzyme is a very specific interaction. Active sites are clefts or grooves on the surface of an enzyme, usually composed of amino acids from different parts of the polypeptide chain that are brought together in the tertiary structure of the folded protein. Substrates initially bind to the active site by noncovalent interactions, including hydrogen bonds, ionic bonds, and hydrophobic interactions. Once a substrate is bound to the active site of an enzyme, multiple mechanisms can accelerate its conversion to the product of the reaction. But sometimes, these enzymes fail or succeed to increase the rate of action because of various factors that limit the action. These factors can be known as temperature, acidity levels (pH), enzyme and/or substrate concentration, etc. In this experiment, it will be tested how much of an effect
There were three test tubes in which the experiment was held. A relatively equal sized portion of raw potato (this contained the enzyme [a biological catalyst] hydrogen peroxidase) was placed in each tube. Then, enough water to cover the potato was added. Proceeding this, each of the test tubes were assigned a temperature; cold, room temperature or warm (this was written on the tag so that they were not confused). The test tube destinated ‘cold’ was placed in a ice bath for five minutes. At the same time, the ‘hot’ test tube was placed in a hot water bath for five minutes. Meanwhile, the room temperature test tube sat at room temperature for five minutes. When the five minutes were over, the test tubes were returned to the rack (so that they were able to be observed). Then, the test tubes were allowed to sit at room temperature for five more minutes. Once that period of time was over, 2 ml of hydrogen peroxide (the substrate) was added to each tube.
The purpose of this experiment was to record catalase enzyme activity with different temperatures and substrate concentrations. It was hypothesized that, until all active sites were bound, as the substrate concentration increased, the reaction rate would increase. The first experiment consisted of five different substrate concentrations, 0.8%, 0.4%, 0.2%, 0.1%, and 0% H2O2. The second experiment was completed using 0.8% substrate concentration and four different temperatures of enzymes ranging from cold to boiled. It was hypothesized that as the temperature increased, the reaction rate would increase. This would occur until the enzyme was denatured. The results from the two experiments show that the more substrate concentration,
In part II of the lab six small glass tubes were obtained in a test tube rack. Ten drops of distilled water were then added to test tube 1, five drops to tubes 2-4, and no drops in tubes 5 and 6. Five drops of 0.1M HCl were added to test tube 5 and five drops of 0.1M NaOH to test tube 6. Five drops of enzyme were then added to all tubes except tube 1. Tube 3 was then placed in the ice bucket and tube 4 was placed in the hot bucket at 80-900C for five minutes, the remaining tubes were left in the test tube rack. After the five minutes five drops of 1% starch was added to every tube and left to sit for ten minutes. After ten minutes five drops of DNSA were then added to all the tubes. All the tubes were then taken and placed in the
Abstract: Enzymes, catalytic proteins that at as catalysis which makes the process of chemical reactions more easily. There are two main factors that actually affects enzymes and their functions which are temperature and pH. Throughout this experiment, the study how pH and peroxidase affects each other and the enzyme was made. The recordings of how the enzymes responded when it was exposed to four different pH levels to come up with an optimum pH which was predicted in the hypothesis and the IRV at the end.
In the exercise # 2 we observed the effect of substrate concentration, enzyme concentration, pH and temperature on enzyme activity. All the data showed that once potato extract was added to catechol and water the reaction varied dependent on the level of catechol. As in
reaction rate increases. If the temperature of an enzyme gets to high the reaction rate will slow