Use the follow data below and answer the following questions: Component Concentration (mg/L) CO2 8 Ca2+ 45 Mg2+ 13 Sr2+ 12 Alkalinity 270 Determine the quantity (mass flow) of CaO and Soda Ash using practical solubility limit required to treat hard water taking volumetric flow as 145000 L/d and pH of 7.5 and purity of both reagents as 97%.

Use the follow data below and answer the following questions: Component Concentration (mg/L) CO2 8 Ca2+ 45 Mg2+ 13 Sr2+ 12 Alkalinity 270 Determine the quantity (mass flow) of CaO and Soda Ash using practical solubility limit required to treat hard water taking volumetric flow as 145000 L/d and pH of 7.5 and purity of both reagents as 97%.

Chemistry & Chemical Reactivity

10th Edition

ISBN:9781337399074

Author:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Publisher:John C. Kotz, Paul M. Treichel, John Townsend, David Treichel

Chapter17: Principles Of Chemical Reactivity: Other Aspects Of Aqueous Equilibria

Section17.6: Equilibria Involving Complex Ions

Problem 1.2ACP: What is the minimum volume of 0.0071 M NaCN(aq) necessary to dissolve the gold from 1.0 metric ton...

See similar textbooks

Similar questions

a) What mass of Fe(NH4)2(SO4)2•2H2O(s) is required to prepare a 500 mL solution containing 100 ppm (m:v) in Fe? b) Using this stock solution, what aliquot must be used to prepare calibration solutions, 100 mL volume, of the following concentrations: 0.100 ppm, 0.500 ppm, 2.00 ppm, 4.00 ppm, and 7.00 ppm.
A. 1.4639 g sample of limestone was analyzed for Fe, Ca and Mg. The iron was determined as Fe2O3, yielding 0.0357 g Calcium was isolated as CaSO4, yileding a precipitate of 1.4058 g and Mg was isolated as 0. 0627 g of MgP2O7. Report the amount of Febas %w/w Fe2O3, Ca as %w/w CaO and Mg in the limestone sample as % w/w MgO
A solution is made by mixing 500.0 mL of 0.04170 M Na₂HASO4 with 500.0 mL of 0.03037 M NaOH. Complete the mass balance expressions for the sodium and arsenate species in the final solution. [HASO]+ [Na] = M = M
A solution is made by mixing 500.0 mL of 0.04419 M Na₂HASO with 500.0 mL of 0.03835 M NaOH. Complete the mass balance expressions for the sodium and arsenate species in the final solution. [HASO²] + [Na] = M = M
Calcium in a 5.00 mL urine sample was precipitated, redissolved and required 16.15 mL of 0.1157 N KMnO4. Calculate the % (w/v) of calcium in the urine.
The Kjeldahl method was used to determine the nitrogen content of a protein. A 275 µL aliquot of a 47.0 mg/mL protein solution was digested in boiling sulfuric acid. The solution was made basic and the liberated NH, was collected in 5.00 mL of 0.0512 M HCl. A volume of 7.00 mL of 0.0174 M NaOH was required to react with the excess HCl. Calculate the weight percent of nitrogen in the protein. weight percent: wt% N
A mineral in a fine state of division (0.6324 g) was dissolved in 25.0 mL of 4.0 mol / L boiling HCl and diluted with 175.0 mL of H2O containing two drops of methyl red indicator. The solution was heated to 100 ° C and a heated solution containing 2.00 g of (NH4) 2C2O4 was added slowly to precipitate CaC2O4. Next, NH3 6.0 mol / L was added until the indicator changed from red to yellow, indicating that the liquid was neutral or slightly basic. After slow cooling for 1 hour, the liquid was decanted, the solid transferred to a crucible and washed five times with 0.10 wt% (NH4) 2C2O4 solution, until no Cl- was detected in the filtrate with the addition of AgNO3 solution. The crucible was dried at 105 ° C for 1 hour and then taken to an oven at 500 ° C ± 25 ° C for two hours. The mass of the empty crucible was 18.2311 g. The crucible mass with CaCO3 (s) was weighed 5 times to an average of 18.5467 g. Determine the percentage, by mass, of Ca in the mineral. Ca (40.078 g / mol); C (12.01078…
A sample containing calcium was analyzed by gravimetry, converting all calcium to calcium oxalate monohydrate (CaC2O4 • H2O). The sample weighing 0.2654 g was dissolved by adding 6M HCl, and then ammonium oxalate solution was added to precipitate all the calcium. The precipitate was suction filtered and dried in an oven at 95 °C for one hour. The solid obtained weighed 0.3216 grams.Calculate:A) The percentage of CaCO3B) The percentage of Ca C) The percentage of CaO
Sample containing arsenic weighing 0.800 are titrated with a standard iodine soluton. what should be the normality of the iodine in order that each ml of titrant represents 1/2% As2O3 in the sample (Answer: 0.0809 N show full solution please)
A ferrous sulfate (BP) [FeSO4151.9g/mol] sample was analysed by titration using ammonium cerium (IV) nitrate (NH4)2Ce(NO3)6. The result shown 0.4980g of this sample used 25.50 ml 0.110M ammonium cerium (IV) nitrate. The BP specifies that ferrous sulfate material should contain not less than 86.0% and not more than 90.0% of FeSO4 Does the sample comply with the British Pharmacopoeia specification? A. The sample contains 85.6% ferrous sulfate thus does not comply with the British Pharmacopoeia specification B. The sample contains 85.6% ferrous sulfate thus complies with the British Pharmacopoeia specification C. The sample contains 86.0% ferrous sulfate thus complies with the British Pharmacopoeia specification D. The sample contains 89.0% ferrous sulfate thus complies with the British Pharmacopoeia specification E. The sample contains116.9% ferrous sulfate thus does not comply with the British Pharmacopoeia specification How do you work this out ?
A series of solutions containing NaOH, Na.CO, and NaHCO, alone or in compatible combination, was titrated with o.1202 needed to titrate 25.00-mL portions of each solution to (1) a phenolphthalein and (2) a bromocresol green end point. Use this information to deduce the composition of the solutions. In addition, calculate the mass in milligrams of each solute per milliliter of solution. M HCI. Tabulated below are the volumes of acid (2) (1) (а) 22.42 (Ъ) 15.67 (c) 29.64 (d) 16.12 (е) о.00 22.44 42.13 36.42 32.23 33.333
A dried sample of commercial salt was prepared by a coning and quartering. A 0.911-g sample of the salt was dissolved and diluted to 250.0 mL in a volumetric flask. Repeat 10.00-mL aliquots of this solution were titrated with a 0.054 M silver nitrate solution, requiring 9.68 mL to reach equivalence. Calculate the %(w/w) NaCl in the original sample.