TLD dosimeters: O ts detector uses sodium chloride (NaCI) O Depends on light emission exhibited by certain materials The less usable type of dosimeters

Q: What amp fuse do I need for 3w LED lights?

A: What amp fuse do I need for 3w LED lights?

Q: 2. Derive an expression for the output voltage of the circuit below in terms of the fou input…

A:

Q: determine the capacitance (in µF) required to establish a capacitive reactance that will match that…

A:

Q: a) i) Sketch (with full labelling) an example of each of a random, energy, power signals. ii)…

A: Energy signal: The signal that is of finite duration and its magnitude is finite then this signal is…

Q: (a) | The cost curves of a three-generator system are given below: Q1 C1 = 350 + 7.20P + 0.0040P? C2…

A: As per the guidelines of Bartley we supposed to answer first three subpart only

Q: E2 The first step in determining the AC equivalent model for a transistor is setting all dc sources…

A:

Q: E2 The input impedance parameter (hie) in CE configuration is almost equal to O a. re O b. Bre O c.…

A: Solve the problem

Q: Q1: A single core 66 kV cable working on three phase system has a conductor diameter of 2 cm and a…

A: In this solution the concept of intersheath graded transmission cables. In intersheath grading same…

Q: E2 Problem No. 3 (P3) A CE Fixed Bias BJT configuration has the following parameters: Vcc=12V,…

A:

Q: 4) A sequential circuit has one flip-flop Q, two inputs x and y, and one output S. It consists of a…

A: For the Full adder circuit The sum S=x⊕y⊕Q Carry C=xy+yQ+xQ The sequential circuit is given by

Q: The -- model has the advantage that the parameters are defined by the actual operating conditions. O…

A: Option c  re model

Q: In three phase transmission line system with no transposition have the inductance matrix as shown…

A:

Q: How would you relate the function of a capacitor to your personal life in terms of saving money?…

A: Capacitor is knowing for increasing power factor or correcting power factor if it is lower than the…

Q: Šolve the next block diagram Find the out pu t C(2) in the z domain

A:

Q: Use superposition to solve for Vx in the circuit

A:

Q: 20 V 2 A Figure P 5.5-5 Encuentre el circuito equivalente Thevenin. . Rt=3 Ohmios Vt 10V ORI3 Ohmios…

A:

Q: 1. Difference between Luminance and illuminance? 2

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Determine the output voltage in V with VA-4.4 V, VB-2.54 V, RA-4 kohm, RB-4 kohm, RC-6 kohm and RD=6…

A:

Q: Find Vo in the network 4 kN 니 mA 8 kN 3 kN 6 kN 4 k2 24V(+ 6 ΚΩ Vo 12 kN 12 kN

A:

Q: Determine the output voltage in V when R1=9 kohm, R3-6 kohm, R5-13 k-ohm, R7=102 ohms, Reference…

A: The given circuit diagram is shown below: It is given that: R1=9 KΩ=9×103 ΩR3=6  KΩ=6×103 ΩR5=13…

Q: Draw the output waveforms (So, U, and V) for the below sequential circuit by assuming the…

A:

Q: Consider a system with the following closed loop characteristics polynomial: s+ 6s +11s?+ (K+6)s +…

A: According to Routh Hurwitz criterion , if the system is said to be stable only when all the elements…

Q: 2H ww- wer 10 cos 2r V :0.25 F 6 sin 21 V

A:

Q: FIND THE INVERSE LAPLACE OF : 6s-25s+25 F(s) 2 (s–3)(s´+5s+4)

A: In this question we need to find a inverse Laplace transform of the given signal

Q: Determine the input and output impedances of a voltage follower amplifier where R; = 10 kn and R; =…

A: The solution is given below

Q: can you try doing it in kcl and kvl kirchhoff's theorem? thank u

A: The given circuit is shown below. We need to determine the branch circuit currents by using KVL and…

Q: c) i) Determine the number of bits per level required when using FSK with 4 different frequencies…

A: It is given that: i)FSK with 4 different frequencies ii) QAM with a constellation of 256 points

Q: In the circuit shown, R1 = 3 N, R2 = 2 N, R3 = 5 N, ɛ1 = 4 V, ɛ2 = 10 V and ɛz = 6 V. Find the…

A:

Q: H.W. : Design a low-pass RC filter to have a cutoff frequency of 30 krad/s. Use a 0.01- uF…

A: We need to design low pass filter

Q: Using various types of transformers, give 10 impacts to the end-users per type of transformer in…

A: Transformer: Transformer is the static device that either step-up or step-down the voltage. It works…

Q: Q1. An equilateral transmission line has a total corona loss of 53 kW at 106 kV and a loss of 98 kW…

A:

Q: 1-z-1+z-2 y(z) = ;ROC: 1< |Z|< 2 Z-1 (1 – 27-1)(1 – Z-1)

A:

Q: A full-wave half-controlled bridge has a supply voltage of 220V at 50Hz. The firing angle delay α =…

A:

Q: A temperature sensor transfer function is 44.5 mV/°C. The output voltage is measured at 8.86V on a…

A:

Q: Question 2 Assume a digital to analog conversion system uses a 10-bit integer to represent an analog…

A: “Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: 3phase 600 kVA alternator has a rated terminal voltage of 3300V (line alue). The stator winding is…

A: Solve the problem

Q: Arrange AM, SSB-SC, DSB-SC, and FM in the decreasing order of bandwidth required for transmission.…

A: We need to find out bandwidth for different modulation .

Q: 10) What will be the value of Ic, if la1 = 100 - 30° and Ib2 = 20 - 90°?

A: To find the value of lc, if Ia1 = 100 &lt; 30°  and Ib2= 20 &lt; 90°  .

Q: Consider a system with the following closed loop characteristics polynomial: s+ 6s + 11s?+(K+6)s +Ka…

A: The solution is given below

Q: 1. Consider the voltage divider circuit for biasing an n-channel D-MOSFET. Given the following…

A: We need to find out drain current and voltage for given circuit

Q: Q1 Choose the correcet answer for each of the following: 1. The off-delay timer (TOF) starts timing…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Q6-Assuming that all of the valence electrons contribute to current flow, (a) calculate the mobility…

A: It is given that: V=10 Vl=100cmThe lattice parameter of copper is 3.6151×10-8, copper is FCC, σ =…

Q: The drawback to using this equivalent circuit, however, is that it is defined for a set of operating…

A: In this question we will write modelling of BJT...

Q: - A semiconductor material has electron and hole mobilities µn and µp respectively. When the…

A:

Q: Q 2: Astable multivibrator was designed using a 555 timer. The frequency of the output signal should…

A: We need to find resistance value for given timer .

Q: In the following circuit, calculate the: 1. Impedance, 2. Circuit current, 3. Power factor, 4.…

A:

Q: For an FM modulator with a modulation index m = 1.5, a modulating signal vm(t) = Vm sin(2000nt), and…

A: Given  Modulation index=1.5 A modulating signal and carrier signal is also given. We need to…

Q: A device that increases input AC power. O a. Inverter O b. Amplifier Oc. Attenuator O d. Rectifier

A:

Q: Problem No. 2 (P2) A BJT amplifier with in a voltage vider bias configuration has the following…

A:

Q: Find the node voltages for the circuit + 41. 2Ω V3 1A (4 12 4Ω +) 10 V ww ww

A: