The rotating loop in an AC generator is a square 11.0 cm on a side. It is rotated at 75.0 Hz in a uniform field of 0.800 T. Calculate the following quantities as functions of time t, where t is in seconds. (a) the flux through the loop mT.m² (b) the emf induced in the loop (c) the current induced in the loop for a loop resistance of 1.50 A (d) the power delivered to the loop W (e) the torque that must be exerted to rotate the loop mN-m

The rotating loop in an AC generator is a square 11.0 cm on a side. It is rotated at 75.0 Hz in a uniform field of 0.800 T. Calculate the following quantities as functions of time t, where t is in seconds. (a) the flux through the loop mT.m² (b) the emf induced in the loop (c) the current induced in the loop for a loop resistance of 1.50 A (d) the power delivered to the loop W (e) the torque that must be exerted to rotate the loop mN-m

University Physics Volume 2

18th Edition

ISBN:9781938168161

Author:OpenStax

Publisher:OpenStax

Chapter13: Electromagnetic Induction

Section: Chapter Questions

Problem 31P: A rectangular wire loop with length a and width b lies in the xy-plane, as shownbelow. Within the...

See similar textbooks

Similar questions

At s1iat frequency is the reactance of a 20F capacitor equal to that of a 10-mH inductor?
A coil with a self-inductance of 3.0 H carries a current that decreases at a uniform rate dl/dt = -0.050 A/s. What is the emf induced in the coil? Describe the polarity of the induced emf.
Two coils close to each other have a mutual inductance of 32 mH. If the current in one coil decays according to I=I0eat , where I0= 5.0 A and =2.0103s1 , what is the emf induced in the second coil immediately after the current starts to decay? At t=10.0103s? ?
Check Your Understanding A transformer steps the line voltage down from 110 to 9.0 V so that a current of 0.50 A can be delivered to a doorbell (a) What is the ratio of the number of turns in the primary and secondary windings? (b) What is the current in the primary winding? (c) What is the resistance seen by the 110-V source?
A rectangular wire loop with length a and width b lies in the xy-plane, as shownbelow. Within the loop there is a time-dependent magnetic field given by B(t)=C((xcost)i+(ysint)k) ,with B(t) intesla. Determine the emf induced in the loop as a function of time.
When a camera uses a flash, a fully charged capacitor discharges through an inductor. In what time must the 0.100-A current through a 2.00-mH inductor be switched on or off to induce a 500-V emf?
The self-inductance and capacitance of an oscillating LC circuit are L = 20 mH and C = 1.0 F , respectively. (a) What is the frequency of the oscillation? (b) If the maximum potential difference the plates of the capacitor is 50 V, what is the maximum current in the circuit?
In the given circuit an inductor of L = 6.20-mH and a resistor of R = 12.4-2 resistor are connected in series with a dc battery of E = 3.90-V. E ll R L S What is the voltage across the resistor immediately after the switch is closed?
In the figure, an ac generator with emf E = Em sin wat, where Em = 25.1 V and wa = 376 rad/s, is connected to a 4.41 UF capacitor. (a) What is the maximum value of the current? (b) When the current is a maximum, what is the emf of the generator? (c) When the emf of the generator is - 12.2 V and increasing in magnitude, what is the current? (a) Number i Units (b) Number i Units (c) Number i Units
An emf of 121.5 mV is induced in the windings of a coil when the current in a nearby coil is increasing at the rate of 1.04 A/s. What is the mutual inductance of the two coils in mH?
Use the worked example above to help you solve this problem. An AC generator consists of eight turns of wire, each having area A = 0.0890 m², with a total resistance of 10.3. The loop rotates in a magnetic field of 0.445 T at a constant frequency of 63.5 Hz. (a) Find the maximum induced emf. V (b) What is the maximum induced current? A (c) Determine the induced emf and current as functions of time. E = ( V)sin(wt) I = ( A) sin(wt) W = (d) What maximum torque must be applied to keep the coil turning? N.m (
Use the worked example above to help you solve this problem. An AC generator consists of eight turns of wire, each having area A = 0.0910 m, with a total resistance of 11.2 Q. The loop rotates in a magnetic field of 0.579 T at a constant frequency of 62.3 Hz. (a) Find the maximum induced emf. V (b) What is the maximum induced current? A (c) Determine the induced emf and current as functions of time. E = V)sin(@t) I = A)sin(@t) W = (d) What maximum torque must be applied to keep the coil turning? N: m EXERCISE HINTS: GETTING STARTED I'M STUCK! An AC generator is to have a maximum output of 318 V. Each coil has an area of 0.120 m² and a resistance of 15.6 N and rotates in a magnetic field of 0.707 T with a frequency of 41.3 Hz, with the axis of rotation perpendicular to the direction of the magnetic field. (a) How many turns of wire should the coil have to produce the desired emf? N = turns (b) Find the maximum current induced in the coil. I max A (c) Determine the induced emf as a…