The melting point of Borneo is 206-209oC and 212-214oC for isoborneol. What could we predict for the melting point range of the product isolated from our experiment, the reduction of camphor with NaBH4?
Q: Explain the role of trisodium citrate, Na3C6H5O7 as a component of the Benedict’s reagent for the…
A: A question based on redox reactions in qualitative analysis of organic sample, which is to be…
Q: Assuming partition between equal volumes of organic and aqueous phase, what percentage of each of…
A: Introduction- Solvent extraction is a process where 2 immiscible solvents are separated along with…
Q: Calculate the molarity of the solution of sodium hydroxide that is used. a. M = b. If the original…
A: To answer the sub-parts related to the question above.
Q: Given data from the scale up synthesis of diethyl acetamidobenzylmalonate (Week 14 Content Area),…
A:
Q: Predict the order of elution of benzyl alcohol (C6H5CH2OH), benzaldehyde(C6H5CHO), benzoic acid…
A: Elution is dependent on the polarity of the compound. They are inversely related to each other. If…
Q: 1. What is the purpose of adding Na2SO4 to the dichloromethane layer prior to distillation 2.…
A: In liquid-liquid extraction, separation of compounds takes place on the basis of their relative…
Q: IF A MIXTURE OF 44.7 MG OF BENZOIC ACID, 50.8 MG OF ETHYL 4-AMINOBENZOATE AND 53.3 MG OF…
A: Given: Mass of 9-FLUORENONE recovered = 39.4 mg. And the mass of 9-FLUORENONE used in the mixture =…
Q: 5. Calculate the % yield if 0.5g of p-aminobenzoic acid reacts with 6 mL of ethanol to give 0.43g of…
A:
Q: Protein A binds to molecule Z with a Ka of 15.0 x 109. If the concentration of molecule Z is 30.0…
A: For a protein that binds to a ligand (Z), the fraction of sites occupied (θ) on the protein is…
Q: Aromatic Primary - aliphatic secondary and tertiary amines with 2 N HCl and 5% NaNO2 on ice Write…
A: The reaction of hydrochloric acid with sodium nitrite gives nitrous acid and sodium chloride as…
Q: Propose an experimental design on the separation of components of the mixture of o-nitrophenol and…
A:
Q: Show how Fischer esterification might be used to form the following esters. In each case,suggest a…
A: Given Data: Show how Fischer esterification might be used to form the following esters. In…
Q: Look up the SAR findings of Sulfonamides from literature and draw out generalized 3D pharmacophore…
A: Following are the 3D structures given below-
Q: What is the limiting reagent in the synthesis of triphenylmethanol via Grignard reagent? Show the…
A: The limiting reagent in a reaction is a reactant that is completely consumed during the course of…
Q: Account for the greater amount of internal pressure in the aspirin extraction versus the ß- naphthol…
A: Given solution contain napthalene, B- naphthol and aspirin. Napthalene is a hydrocarbon and it's…
Q: Write the equations for the acid-base reactions involved in this experiment. Clearly show the…
A: Introduction: Extraction and filtration of an organic mixture are done on the basis of the…
Q: Briefly explain the rationale for the addition of 2N sulfuric acid in the assay of ascorbic acid.
A: Role of addition of 2N sulfuric acid in the assay of ascorbic acid explanation is given below.
Q: A mixture of 70%Tween 60 and 30%Span 65 was found to give optimum stability to a particular emulsion…
A: “Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: the reaction mixture containing p-aminophenol, distilled H2O, and acetic anhydride was heated to 200…
A: Ans At 100 °c your product is formed after you increase heat again and again then, up to 168 °c…
Q: Give a mechanism for the following Copper-mediated Chan-Lam coupling of aryl boronic acids and…
A: Here Cu acts as catalyst of the reaction where B acts as co- catalyst of the reaction. Here urea…
Q: Select a suitable solvent for analysis of one of these terpenes by UV spectroscopy. Explain your…
A: The solvents for analysis of one the terpenes by UV spectroscopy does not absorb above the 210 nm…
Q: Write the reactions of Aromatic Primary - aliphatic secondary and tertiary amines with 2 N HCl and…
A: All the 3 amines namely, aromatic Primary amine, aliphatic secondary and tertiary amines react with…
Q: What would happen to the your Kc values if you used an absorptivity constant of 6000 M-1, when the…
A:
Q: Here is a flowchart for the separation of a mixture of a primary aliphatic amine (RNH, pK, 10.8), a…
A: In this question, we have to find out the correct answer of given problem by the help of the…
Q: Discuss what this data indicates about the polarity of Methyl-4-Aminobenzoate
A: Since you have asked multiple questions, we will solve first one for you. For remaining question,…
Q: 2-Methylethylpropanoate is condensed with phenylbenzanoate in an alkaline medium
A:
Q: To synthesize Tylenol, p-aminophenol will be acetylated using 1.4 equivalents of acetic anhydride.…
A: Given: Mass of p-aminophenol = 2.1 g In order to synthesize, Tylenol, p-aminophenol will be…
Q: How would I calculate the theoretical yield of the crystallization of acetanilide from this data?…
A: Given:- 2.05 mL of Aniline & 1.6 mL acetic anhydride. Aniline and Acetic anhydride on react…
Q: Using the end-group analysis to find molecular weight, 6 mol of 1,4-butanediamine reacted with 6 mol…
A: The polymer formed from the given monomers: H2N-(CH2)4-NHOC-(CH2)4-COOH
Q: Give and observation and inference when the compound hexane is subjected into test for Br2 in CCl4
A: Br2 in CCl4 is used for bromination of unsaturated hydrocarbons (alkenes and alkynes)
Q: Horner-Wadsworth-Emmons reaction 2.2g of potassium carbonate 2.3mL of trimethyl phosphonoacetate…
A:
Q: If you had performed the extraction with dichloromethane (d 1.33 g/mL) as the organic solvent and…
A: Given: Density of dichloromethane = 1.33 g/mL Density of water = 1.00 g/mL Three starting compounds…
Q: What was the composition of the distillate in Fraction B which was collected in the middle of the…
A: Question 9) at middle of the distillation. we have 50 % of both ethanol and 1-butanol. both are…
Q: The distribution coefficients fora compound are as follows: Kcyclohexane/water = 1.5 Kpentane/water…
A: Selection of proper solvent system for solvent extraction based on distribution coefficient.
Q: Here is a flowchart for the separation of a mixture of a primary aliphatic amine (RNH, pK, 10.8), a…
A: The given mixture contains amine, carboxylic acid and phenol. All these are soluble in diethyl ether…
Q: There have been cases where wine has been mistakenly adulterated with ethylene glycol…
A: Chromatography is an analytical technique in which a sample mixture is separated into different…
Q: Draw the sulfonamides produced, if any, upon the addition of BSC and excess NaOH to the test…
A:
Q: Why is the refluxing time required for the synthesis of methyl salicylate is quite long?
A: Methyl salicylate is prepared using the following reaction:
Q: Anilinium ion, PhNH3+ , Catalyze semicarbazone formation from benzaldhyde much more effectively than…
A: The semicarbazone is formed when semicarbazide is added to the carbonyl compound, they form imine…
Q: Mescaline (see structure X) is a naturally-occuring psychedelic compound isolated from the peyote…
A: In organic laboratories, acid-base extraction involves the extraction of an organic compound using…
Q: 5) Indicate the type of column (packing) to be used to separate the following mixture of carboxylic…
A: Solutions- HPLC- High performance liquids chromatography. It is a separation technique used to…
Q: Draw the molecular structure of glycerol-1-linolenate-2-palmitate-3-eliadate and calculate its…
A: Molecular structure of lipid is
Q: Propose two additional structural formulas (excluding stereoisomers) for C5H11N that are also…
A:
Q: Compound EE, C4H8O shows a positive result (formation of yellow precipitate) when reacted with…
A: This is a question from inorganic reaction.
Q: Calculate the volume of p-anisaldehyde required to react in a 1:1 ratio with 0.69 g of…
A:
Q: Arrange the following compounds in order of decreasing ease of elution from a column of silica gel
A: Silica gel acts as a stationary phase in silica gel chromatography column and it retains the polar…
Q: How do you rationalize the fact that the cyclohexane A value for phenyl (2.8) is bigger than that…
A: The A values explains the bulky nature of substituents in a cyclohexane. The energetic preference of…
Q: In the experiment borohydride reduction , using 2.0g of benzophenone, a student obtained 1.6g of…
A:
The melting point of Borneo is 206-209oC and 212-214oC for isoborneol. What could we predict for the melting point range of the product isolated from our experiment, the reduction of camphor with NaBH4?
Trending now
This is a popular solution!
Step by step
Solved in 2 steps with 1 images
- Isopropanol is a good extraction solvent for plant pigments as it breaks down cell walls and is miscible with pigments. Can you be sure that you only extracted chlorophyll-a from your spinach leaf? If not, what else might have been extracted?What is the function of the sulfuric acid in the dehydration of alcohols to form alkenes? Why was it important to keep the Gas chromatograph close to room temperature during the analysis of the alkene mixture?You are employed as a coop student at the Drug and Alcohol Testing Association of Canada (DATAC) developing analytical tests for sports doping agents. You are asked to prepare a procedure for the extraction of methylphenidate, the active compound in Ritalin, from urine samples (consider them as simple aqueous layers, you do not need to consider other components!). The goal of the procedure is to extract the methylphenidate into an organic layer which will then be evaporated, and the residue will be tested for the drug.You find that methylphenidate is highly soluble in 2-methyltetrahydrofuran, a bio-renewable solvent. Draw the structure of 2-methyltetrahydrofuran and give two reasons why it is a good solvent choice for liquid-liquid extraction.
- You are employed as a coop student at the Drug and Alcohol Testing Association of Canada (DATAC) developing analytical tests for sports doping agents. You are asked to prepare a procedure for the extraction of methylphenidate, the active compound in Ritalin, from urine samples (consider them as simple aqueous layers, you do not need to consider other components!). The goal of the procedure is to extract the methylphenidate into an organic layer which will then be evaporated, and the residue will be tested for the drug.Your colleague is helping you develop the urine test. They suggest that the urine should be adjusted to a pH above 7 before extracting with the organic solvent. Why is this necessary? Support your explanation with a full arrow-pushing mechanism for the reaction that would occur if the pH was below 7. Include all formal charges, intermediates (if applicable) and products.What is the theoretical yield and limiting reagent for the reaction of benzophenone with sodium borohydride to form diphenyl methanol as described in the experiment provided if you begin with 1.75g of benzophenone in 25 mL of 95% ethanol and add 0.75 g of sodium borohydride portion wise over 45 minutes?If 0.70 g of FeCl3 is used to iodinate 8.42 g of benzene with sufficient ICl, what is the average number of reactions that each FeCl3 molecule must catalyze?
- Example: For the synthesis of adipic acid from cyclohexanone, 1.0 mL of nitric acid and 0.154 g of cyclohexanone were used initially. Following the reaction, 0.325 g of crude product was isolated as light yellow clumps, with a mp range of 145-150 °C. This crude product was purified by recrystallization to yield 0.173 g of pure product (off-white crystals), with a mp range of 151-153 °C. A typical yield of adipic acid is 0.190 g. Use the space provided to write out the Results and Discussion sections that would appear in a lab report for this experiment. 0.15401.0L Cyclohexanone 0.3259 HNO, 145-150°C COOH COOH 0.1739 151-1534 Adipic acid1) A polyester made from sebacic acid (CAS# 111-20-6) and 1,6-hexanediol (CAS# 629-11-8) has the molecular weight fractionation listed below. Calculate an appropriate average molecular weight for this polyester. Source: Batzer, H., Macromolecular Chemistry and Physics 5What is an emulsion, how its form and how to avoid its formation?.
- Explain the role of trisodium citrate, Na3C6H5O7 as a component of the Benedict’s reagent for the Estimation of GlucoseDehydration of 2-Methylcyclohexanol underlies the Evelyn effect, which is defined as the phenomena in which the product ratios in a chemical reaction change as the reaction proceeds. Rationalize this observation.Q26-C (i) Explain pyrolysis process.