P Problem 19.43The mass center of the 7-1b ball has a velocity of (va)1 = 6 ft/s when it strikes the end of thesmooth 7-1b slender bar which is at rest. (Eigure 1)FigureB0.5 ft2 ft2 ft80(a) = 6 ft/sr=0.5 ft।< 1 of 1 >Part ADetermine the angular velocity of the bar about the z axis just after impact if e=0.6.Express your answer with the appropriate units.W₂ =SubmitHAValueProvide FeedbackRequest AnswerUnits?(✓)4 of 5ReviewNext >

To Find : The angular velocity of the bar about z axis Given : The lenght of slenderis The velocity…

The mass center of the 7-1b ball has a velocity of (a)=6 ft/s when it strikes the end of the smooth 7-lb slender bar which is at rest (Eigure 1) Figure tah-60% F-050 Part A Determine the angular velocity of the bar about the axis just after impact if e 0.6. Express your answer with the appropriate units. PH Value 4 Submit Request Answer Provide Feedback -? Units

The mass center of the 7-1b ball has a velocity of (a)=6 ft/s when it strikes the end of the smooth 7-lb slender bar which is at rest (Eigure 1) Figure tah-60% F-050 Part A Determine the angular velocity of the bar about the axis just after impact if e 0.6. Express your answer with the appropriate units. PH Value 4 Submit Request Answer Provide Feedback -? Units

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

2 An object is made of two identical uniform 3m long rods connected as shown. The total mass of the system is 60kg. The object can rotate in the plane of the page about a fixed axis at Point A. There is a friction moment of 500 N m about point A. a. What is the mass moment of inertia of the object about Point A? b. If the object is released from rest in the orientation shown, what will be is initial angular acceleration? stationary Mf A = total mass= 60 kg 500 Nm 3 m 3 m g
This question is about angular acceleration.. The 75-kg wheel has a radius of gyration about the z axis of kz = 150 mm. If the belt of negligible mass is subjected to a force of P = 150 N, determine the mass moment of inertia and the angular acceleration of the wheel. The surface is smooth and the wheel is free to slide. 250 mm P-150N Figure Q8 a) 22.22 rad/s? b) 44.44 rad/s? c) 66.66 rad/s? d) 88.88 rad/s² e) No answer
In the helicopter shown; a vertical tail propeller is used to pre- vent rotation of the cab as the speed of the main blades is changed. Assuming that the tail propeller is not operating determine the final angular velocity of the cab after the speed of the main blades has been changed from I80 to 240 rpm. (The speed of the main blades is measured relative to the cab, and the cab has a centroidal moment of inertia of 650 lb.ft.s2. Each of the four main blades is assumed to be a slender rod 14 ft weighing 55 lb.)
The connecting rod of a horizontal reciprocating engine is 400 mm and length of the stroke is 200mm. The mass of the reciprocating parts is 125 kg and that the connecting rod is 100 kg. The radius of gyration of the connecting rod about an axis through the centre of gravity is 120 mm and the distance of centre of gravity of the connecting rod from big end centre is 160 mm. The engine runs at750 r.p.m. Determine graphically the torque exerted on the crankshaft when the crank has turned 30° from the inner dead centre.
1 A thin 5m long uniform rod is free to rotate in the plane of the page about a fixed axis at Point A. Point A is 2m from one end of the rod. The mass of the rod is 60kg. a. What is the mass moment of inertia of the rod about Point A? b. If friction is negligible, what is the angular acceleration of the rod when it is at an angle of 50° from horizontal, as shown? gl 9 mass = 60 kg 3 m 50° A stationary 2 m
Q/A horizontal axle -A B, Im Long, is pivoted at the mird point C.It Carries a weight of 2 kg at A and awheel weighing 5kg at B. The wheel is made to spin at a speed of 600 j.p.m. in a clockwise direction Looking from its front. Assuming that the weight of the flywheel is uniformly distributed around the rim whose mean dia- meter is 60cm. Calculate the angular velocity of precession of System around the vertical axis through C.
HW8 An airplane makes a complete half circle of 50 meters radius, towards left, when flying at 200 km/h. The rotary engine and the propeller of the plane has a mass of 400 kg and a radius of gyration of 0.3 m. The engine rotate at 2400 r.p.m. anticlockwise when viewed from the rear. Find the gyroscopic couple on the airplane and state its effect on it.
-The rod PQ of length L = /2 m and uniformly distributed mass of M = 10 kg, is released from %3D distributed mass of M = 10 kg, is released from %3D rest at the position shown in the figure. The ends slide along the frictionless faces OP and OQ Assume acceleration due to gravity, g = 10 m/s?. %3D The mass moment of inertia of the rod about its centre of mass and an axis perpendicular to the plane of the figure is (ML?/12). At this instant, the magnitude of angular acceleration (in radian/s2) of the rod is 2m 45°
The heavy turbine rotor of a sea vessel rotates at 1500 r.p.m. clockwise looking from the stern, its mass being 750 kg, if the radius of gyration for the rotor is 250 mm. When the sea vessel is steering to the left on a curve of 100 m radius at a speed of 50 km/hr. Determine the gyroscopic couple and effect of gyroscopic couple with diagram.
The circular concrete culvert rolls with an angular velocity of w=0.58 rad/s when the man is at the position shown. At this instant the center of gravity of the culvert and the man is located at point G, and the radius of gyration about G is kg = 3.2 ft. (Figure 1) Figure @ 4 ft 0.5 ft 1 of 1 Part A Determine the angular acceleration of the culvert. The combined weight of the culvert and the man is 500 lb. Assume that the culvert rolls without slipping, and the man does not move within the culvert. Express your answer to three significant figures and include the appropriate units. α= Submit μA Value Provide Feedback Request Answer Units ***** ? Next >
A rod of mass M=101g and length L=31cm can rotate about a hinge at its left end and is initially at rest. A putty ball of mass m=11lg, moving with speed V=6m/s, strikes the rod at angle theta=21degrees a distance D=L/3 from the end and sticks to the rod after the collision. Part a) what is the total amount of inertia,I, with respect to the hinge, of the rod-ball - system after the collision?
An aeroplane makes a complete half circle of 70 metres radius, towards left, when flying at 500 km per hr. The rotary engine and the propeller of the plane has a mass of 600 kg and a radius of gyration of 0.3 m. The engine rotates at 2500 r.p.m. clockwise when viewed from the rear. Find the gyroscopic couple on the aircraft.