Question Completion Status: Calculate the value of va in the following circuit, for the following values of current and resistance 11-0.22 Amperes RI-36 Ohms R2-53 Ohms R3-97 Ohms R4-27 Ohms 11 www R1 R2 www R3 R4 P 10

Q: 5-If V = (Last 2 digits of your student number) Sinat, what is V? -/20 Ω 20 Ω -j20 Ω 20 Ω

A: The circuit diagram,

Q: 2. Determine the inverse z transform of X(z) = = 1+ 2z¹+z-² 1 3 -1 Z + Z-2 2 Also plot the poles and…

A: The pole is point at which the denominator of system become zero. The zero is point at which the…

Q: Q2) A-Information signal is PCM using 8 levels quantization if the signal is given as 8cos(4xt) with…

A: In PCM, Quantization levels = 8, The signal is, cos(4t) with a sampling rate 10Hz.

Q: IV (+ 2 ΚΩ 3 ΙΩ 4000 + Us 19

A: Given here a circuit and asked to find the Vx using the thevenin theorem

Q: Determine the root locus diagram for the system shown. (s+6) (s+2)(s+4)(s+9) R K

A: Given:A control system, To find:Root locus of the system.

Q: Consider the following transition matrix. [0.2 0.3 0.5 0 0.1 0.9 0.5 0 0.5 a) Which…

A: The question involves analyzing a given transition matrix representing a Markov chain. The…

Q: Question 4: A uniform plane wave of time average power density 75mWcm² in air is normally incident…

A:

Q: 9. a. Draw the load line for the network of Fig. 4. 122 on the characteristics of Fig. 4.121 using B…

A: The given circuit diagram is shown below,“Since you have posted a question with multiple sub-parts,…

Q: 11.17 Following are four successive approximations of tanh s. (a) 3s +3 Synthesize networks for the…

A: Given: Input Impedance of the network Z(s) = Aim:Synthesize the network from the given function

Q: Q) X(t) = A (os (wt +Ø) where A is uniform IR.V. over (0,1) w and I are constant (a) auto…

A: Note: I am solving it in both formats handwritten as well as text typingGiven dataHere  is a uniform…

Q: Calculate the first four non-zero values of the following right-sided sequence using the power…

A: The inverse of z transform is calculated by following methoda) By inspectionb) Power seriesc)…

Q: Vin R C 0.000 Vout Figure Q1 c) Reduce the block diagram derived in (b) above to determine the…

A: The given problem is from circuits and the problem can be solved by using voltage division rule.The…

Q: Write a ladder Program to add the state of two switches (SW1&SW2) connected to the input pins 0 and…

A: Step-1->

Q: nput to the step up chopper is 161 V. The output required is 510 V. If the conducting   time of…

A: Given Data:A step-up chopper with,Input voltage Output voltage On-time To Find;The output voltage…

Q: 5. Solve for the apparent power, average power, reactive power and power factor for each of the…

A:

Q: Ex3 Find Pange of No sol Case Variable resistor is at Maximum value = bk₁ The range V₁=0.5V bkr MU…

A: Since you have posted multiple questions, we will provide the solution only to the first question as…

Q: A- For the lossless T.L with 1-30m, Zr-Zo-502, f-10MHz, find Zs, and Za at d=0.125 2.

A: For the lossless transmission line,

Q: E₁ + R₁ ww 7 V IG +0 a 1₁ V ab R₂ + + E₂ Given that E₁ = 9.5V, E₂ = 2.8V, R₁ = 9760 and R₂ = 2650,…

A: E1 = 9.5 V E2 = 2.8 V R1 = 976 ohm R2 = 265 ohm

Q: 5) Use Norton's theorem to find Io in the circuits below a. 24V (+ 3 ΚΩΣ 2 mA • 6 ΚΩ Μ 4 ΚΩ ο 2 mA 2…

A: Step-1->

Q: Q1. Find the de Broglie wavelength of a 1.00 mg grain of sand blown by the wind at a speed of 20…

A: This problem is related to basic of semiconductor physics in Basic electronics engineering. The De…

Q: Calculate the rms v (a) v(t) = 5+ i(t) = -3 + (b) 12(t) 15 V (م)

A: Function of voltages are given as,(a) (b) (c)

Q: [2] A D.C. to D.C. chopper operates from a 48 V battery source into a resistive load of 240hm. The…

A: Vs = 48 VR = 24 ohmf = 250 HztON = 1 ms = 1x 10-3 sec

Q: 23. When the reactance of a series RC circuit increases, the current will a. increase b. decrease c.…

A: The reactance of the series RC circuit is increased.

Q: 1. In a 50 kVA, 4000/400 V, single-phase transformer the iron and full-load copper losses are 500…

A: “Since you have posted multiple questions with multiple sub parts,we will provide the solution only…

Q: Sketch the Nyquist Stability plot for the open-loop transfer function given by GH (s) = 1 (s+P₁) (s…

A:

Q: 2. Given the information appearing in Fig. 4.119, determine: a. Ic. b. Rc. c. RB. d. VCE. 3 Given…

A: In this questionWe need to determine the all unknown values.

Q: What is the function of the circuit shown in Figure 9? CLR CLK (9) (8) (1) (2) R d>c S PR (3) Loc 20…

A: Step-1->It is the 74LS164 is an 8-bit serial-in/parallel-out shift registerThe 74LS164 is a…

Q: 20 V +1 4A (1 Α 10 Ω ΖΩ 10 Ω Figure 3 8 Ω 6Ω 25 Ω

A:

Q: 1. a) Find the values of 11, 12 and I 3 currents of the multi-loop circuit in the figure? b) What is…

A:

Q: Switch S1 has been closed and S2 has open for a long time until the capacitors are fully charged. At…

A:

Q: 1 - Design a counter using a 74HC163 binary counter MOD is 15 and use LD to design. 2- Draw the…

A: Need to design a MOD 15 counter by using the IC 74163. The reset of the counter should be carried…

Q: QUESTION 1 Calculate the equivalent capacitance and initial voltage drop with respect to terminals a…

A:

Q: Switch S1 has been closed and S2 has open for a long time until the capacitors are fully charged. At…

A: The circuit diagram,

Q: Find v(t) for t 0 in the circuit attached.

A: Given data,The dependent voltage source is .The independent voltage source are  and .To find out for…

Q: Design a bandstop FIR filter with the following specifications: - Lower cutoff frequency =1250 Hz…

A: Solution:Given Data:Lower Cutoff Frequency =1250 HzLower transition Width =1500HzUpper Cutoff…

Q: 9.4 M The RC circuit shown in the figure has resistance of R=9k2 and the capacitance of C The…

A: Capacitor is two terminal passive electrical component. It store energy in electric field.

Q: Consider the inverting OpAmp circuit below, left: Find the Transfer G(s): Vo(s) Vi(s) V₂₁ R₁ as…

A: given op-amp circuit is

Q: Which statement is true when applying a DC power source Vs (>0)? 1. a steady state is reached. 2. vo…

A:

Q: Two half-wave dipoles are arranged as shown in the figure below, with antenna 1 transmitting 300W at…

A:

Q: Resistance R Capacitance C I Impressed voltage E(t) Inductance L In the circuit given above, L-1 H,…

A: it is asked to find i(t) for given circuit

Q: An alternating voltage source with constant angular frequency w is connected to a circuit and…

A:

Q: Sov. 2005 wwx. X. t-ob Vs P Zorloos 1230m ZR=5052

A: The lines that transmit radio signal from transmitter to receiver (antenna ) are called transmission…

Q: For the system represented by the state equation x = Ax(t) the state response x(t) is given by eat…

A:

Q: In the circuit shown, the switch indicated is closed for a very long time, and then opened at t=0.…

A: For this Circuit ,we need to find steady state current and voltage indicated on the diagram before…

Q: Design a 3-tap FIR filter low pass filter with a cut off frequency of 800 Hz and mpling rate of 8000…

A: I have written this solution as handwritten solution. Hope you find the perfect solution.

Q: covered in class only!) a) Find the differential (loop) equation relating output "y(t)" to input…

A:

Q: Vs RE M Rc1 Q₁ M Vcc Rc2 Q₂ M RE Q3 -O V₂ Sketch the feedback small signal model of this circuit.

A: For a small signal circuit DC voltage sources (Vcc) are grounded and DC Current sources are open…

Q: 1 ΚΩ 2. Find Vo Μ 21₂ Μ 1 ΚΩ 6V ΣΚΩ 1 ΚΩ 1 ΚΩ 1 mA να ΟΙ

A:

Q: Calculate the angle of refraction at the air/core interface, 0₁. critical angle, and incident angle…

A: Answer:—Given that ;Refractive index of air  ( air ) = 1Refractive index of core (core ) =…

Q: 5) You want to design an arithmetic comparison combined logic circuit. a. Write your design purpose…

A: The design purpose of the 4-bit comparison (big-equal-small) circuit is to compare two 4-bit binary…

KVL and KCL

KVL stands for Kirchhoff voltage law. KVL states that the total voltage drops around the loop in any closed electric circuit is equal to the sum of total voltage drop in the same closed loop.

Sign Convention

Science and technology incorporate some ideas and techniques of their own to understand a system skilfully and easily. These techniques are called conventions. For example: Sign conventions of mirrors are used to understand the phenomenon of reflection and refraction in an easier way.