Q5. A general analysis of the switch-mode inverter shown in the figure below is to be done. The switching frequency f, which is also the frequency of the triangular signal is 1450 Hz. The de voltage, Va, is 600 V. Output voltage is sinusoidal voltage with a frequency equal to 50 Hz. TA ADA. Va TA- ADA- VAN (Figure 8-4 on page 203 from Mohan's Book) a. Find the frequency modulation ratio, mr. b. Why the frequency modulation is chosen as an odd integer? c. Calculate the output voltage (rms value of first harmonic), when the amplitude modulation ratio, m., is equal to 0.8. +

Q5. A general analysis of the switch-mode inverter shown in the figure below is to be done. The switching frequency f, which is also the frequency of the triangular signal is 1450 Hz. The de voltage, Va, is 600 V. Output voltage is sinusoidal voltage with a frequency equal to 50 Hz. TA ADA. Va TA- ADA- VAN (Figure 8-4 on page 203 from Mohan's Book) a. Find the frequency modulation ratio, mr. b. Why the frequency modulation is chosen as an odd integer? c. Calculate the output voltage (rms value of first harmonic), when the amplitude modulation ratio, m., is equal to 0.8. +

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In motor control of train, IGBT control AC motor save more energy than GTO due to less switching loss. State THREE more reasons why IGBT use in motor control has many advantages over GTO. If one of the freewheeling diode in your single phase inverter in above settings has reverse recovery failure. Describe what would happen to the circuit.
Single-phase Half Wave Inverter produced a Square wave output across the load R=3 ohm and E=11OV and duty cycle d=40% 1- plot the wave form of output voltage , voltage across switches, and the source current 2- find the average load current 3-the power delivered at the load
a type of DC source where the characteristic output voltage has perfect unidirectional waveform and is based on electrochemical principle. A. Gemerator B. Converter C. Battery D. Inverter
8-The waveform of output voltage of half-controlled three phase bridge rectifier in each cycle contains: Two- pulse six- pulse three- pulse 9-The DC supply voltage of single phase bridge inverter is 300V. For quasi-square wave output voltage with a 60 percent ON time, the RMS value of output voltage is: 232.37V 220.5V 270.9V 10-For three phase bridge inverter with 120° conduction and resistive star-connected load, the waveforms of: (a) The load current and line voltage are quasi-square. (b) The load current is quasi-square and line voltage is a six- step. (c) The load current is six- step and line voltage is quasi-square. 9.
A single phase inverter has square wave output voltage. What is the percentage of the fifth harmonic component in relation to the fundamental component ?
Q3. Choose the correct answer from the multiple-choice list for each question. 1. A single-phase AC voltage controller with ON-OFF control has: a) two SCRS in parallel b) one SCR is parallel with one diode c) one SCR is anti-parallel with one diode d) two SCRS in anti-parallel 2. Multilevel inverters converts a) dc power to dc power c) ac power to ac power de power to ac power d) ac power to dc power 3. Three phase to single phase half wave cycloconverter requires of SCRs. a 6 b) 8 c) 12 d) none of the mentioned 4. AC voltage controllers convert a) fixed ac to fixed de b) variable ac to variable de fixed ac to variable ac d) variable ac to fixed ac 5. A single-phase half wave voltage controller consists of a) one SCR is parallel with one diode b) one SCR is anti-parallel with one diode c) two SCRs in parallel d) two SCRs in anti-parallel number 3
The circuit that converts ac to dc is called a. Attenuator b. Rectifier c. Inverter d. Amplifier
Single - phase Half Wave Inverter produced a Square wave output across the load R = 3 ohm and V= 110V and duty cycle d= 40 % Find: 1- plot the wave form of output voltage, voltage across switches , and the source current 2- find the average load current 3 - the power delivered at the load
A single phase half-bridge voltage source inverter (VSI) has a resistive load of 2.4Ω andinput dc voltage Vdc = 48V. The desired fundamental frequency of the load voltage is 50 Hz.Determine: RMS output voltage at fundamental frequency and voltage rating of switches
A single phase half bridge inverter has input voltage of 48 V DC. Inverter is feeding a load of 2.4 ohm. The rms output voltage at fundamental frequency is ?
electrical engineering what is the function of inverter ?
Square wave inverter to a 125 V dc source,It has an output frequency of 60 Hz and R=20Ω and L=25 mHit has an RL series Load with.a. Calculate load current. b. Calculate RMS load current. c. Determine the average welding current.