Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with 2m and 50cm in dimension, respectively. The Tx-RX distance is 500m. The aperture efficiency is 0.9 for Tx and 0.5 for Rx. The Tx power is 30 dBm and the receiver threshold is -100 dBm with Te-900k for Tx and 700K for Rx.. Calculate (a) the received power (b) the path loss (c) the link margin, and (d) the received SNR.

Q1. A link is operating at f=60GHz & 500 MHz bandwidth. The Tx & Rx antennas are square-shaped with 2m and 50cm in dimension, respectively. The Tx-RX distance is 500m. The aperture efficiency is 0.9 for Tx and 0.5 for Rx. The Tx power is 30 dBm and the receiver threshold is -100 dBm with Te-900k for Tx and 700K for Rx.. Calculate (a) the received power (b) the path loss (c) the link margin, and (d) the received SNR.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

How many channels are available in the 5 GHz band? List all the channels. What is the channel bandwidth?
2- What is the difference between narrowband FM and wideband FM refer tothe spectral component of the two signals.
Design Armstrong indirect FM modulator to generate an FM signal with fc = 400 MHz and Af = 97.2KHz. A NBFM generator of fc1 = 100KHz and Af₁ 25Hz. Fifth frequency tipplers can be used as multipliers, any number of frequency doublers and a local oscillator with tuning range (400-1500) KHz is readily available for frequency mixing. =
Explain through equations what happen if there is a phase error θc between the transmitted QPSK signal and local (replica) carrier signals in coherent QPSKdemodulator. Then what happen if θc=90o
Spectra quality in ATR-FTIR is dependent on sample material. True False
A product detector has a 27-MHz carrier and is used to pass audio frequencies from 200-Hz to 15-KHz range. What is the approximate center frequency of the filter needed to pass the lower sideband is used?
b. What is the channel capacity for signal power of 250 W, noise power of 50 W, and bandwidth of 3 MHz? c. What is the channel capacity when the S/N ratio is doubled but the bandwidth is reduced by a factor of 5?
Derive the frequency reuse factor for a triangular cell
7) Calculate Log2(64) 64,32,6, and 2 9) What is the bandwidth of a signal that ranges from 5 MHz to 10 MHz? 10MHz. 5MHz. 5KHz. 10KHz.
Problem 4 to separate ITU channel 59 using a fiber Bragg grating (FBG) and an optical circulator. The FBG is made from a fiber with an effective index of refraction of the core of 1.48 at You are to implement a simple one-channel demultiplexer ITU channel 59. a.) Draw a diagram of the demultiplexer b.) Calculate the periodicity of the index of refraction modulation in the core of the FBG fiber
(a) In a Single Side Band (SSB) generator the side filter center is 2 MHz. Since the information signal is 4 kHz, what should be the carrier frequencies for the upper and lower sidebands? (b) Compare AM Independent Side Band (ISB) and AM Single Side Band Reduced Carrier (SSBRC) techniques and write down their differences?
An Armstrong method is used to generate WBFM with a carrier 768MHz and Al-388.8KHz. A narrowband indirect FM with fe-150KHz and Af-75Hz. Only the fourth triple frequency and any number of doubles are available as frequency multipliers. In addition, an oscillator with a frequency from 50-200 KHz is also available.