power
Q: Draw the output waveform on the top of the input waveforms for this circuit, Assume that +Vout(max)=…
A: In this question, We need to draw the output waveform of the given operation amplifier. We are…
Q: Using Z Transform find y[n] if x[n]= (1+β^n)u[n] h[n]=u[n] please solve step by step subject: signal…
A:
Q: Prove dx(t)/dt________Laplace_ _sX(s)
A: Laplace transform is used to analyze the continous time domain signal into s domain or frequency…
Q: Draw the logic circuit represented by each of the following expre- • AB + AB ● AB(CD + EF)
A: In this question we will draw logic circuit represented by given expressions....
Q: Balanced 3 Phase Supply 3 +PC- A +CC- C Line-to-line supply voltage is 380 V with the phase sequence…
A: In this question, We need to determine the total power P, load power factor and type of the power…
Q: 1. Calculate the power gain in decibels for each of the following cases. a. Po 100 W, P₁ = 5 W.
A: Given, Output power, Po=100 W Input power, Pi=5 W
Q: A 1000 W carrier is amplitude modulated and has a side-band power of 300 W. The depth of modulation…
A: Given, Carrier power, Pc=1000 W Side band power, PSB=300 W
Q: Sketch DC and ac equivalent circuits and theoretically Analyze DC and ac analysis of a Single Stage…
A: The given circuit is as shown below,
Q: Based on the circuit, where v(t) is the input, and v.(t) is the output. Answer the ff. R oooo v(t)…
A:
Q: Q2-100 KVA, (6600/330) ,single-phase transformer, the primary connected to supply voltage 100 V and…
A:
Q: Obtain the admittance parameters for the two-port network of Fig. 3. 100 Ω + 0.2V2 50 Ω Μ 30 Ω…
A: Given here a two port network and asked to find admittance parameters which are called as y…
Q: For static (time-independent) fields, which of the following current densities are possible? (a) J =…
A: We need to check whether the given field are static or not
Q: If two signals modulate the same carrier with different modulation depth of 0.3 and 0.9, the…
A: Resultant modulation index is calculated as
Q: Q4. In a CE germanium transistor amplifier circuit shown in (fig. 5). Determine the 0.985. operating…
A: For the above given common emitter amplifier circuit we need to calculate all the DC parameters and…
Q: The frequency and waveform of a digital signal is best determined using which of the following…
A: The spectrum analyzer measures the size of the input signal compared to the frequency within the…
Q: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…
A: The input waveform shown in the figure below is applied to an inverter, which is used to operate a…
Q: For the Circuit shown in fig iT = I1 Sin (1004+10") +13 (sin 300++20²) + Id sin (yoot if I +36)A In…
A: Capacitive reactance is inversely proportional to frequency Inductive reactance is directly…
Q: Q5: Solve the DE: y + y + y = 1, y(0) = 1, y(0) = 3 using Laplace Transform.
A: In this question, We need to determine the signal y(t) using the Laplace transform?. Initial…
Q: Bandwidth occupied by 100 MHz carrier; AM modulated by signal frequency of 10 kHz is?
A: Given, Carrier frequency, fc=100 MHz Modulating frequency, fm=10 kHz
Q: Given the magnetic field vector potential: A=2r cose ar-3r sine a0 (A/m), find at point P (1,5,7):…
A: Current density J: When a current is passing through the cross-sectional area of a material. Then…
Q: G/Verify the following identities Zanh ( x + y) = tanhx + tanky 1 + tanha tanhy
A:
Q: 40. Given that fc(ol) = 100 Hz, Aol = 50 dB, and fc(cl) = 3 kHz, determine the closed-loop gain in…
A: The required parameters can be calculated by using the unity gain bandwidth and the closed loop…
Q: At negative voltage regula sending-end voltage is receiving-end voltage. O greater than O equal to O…
A: In this question we will write about negative voltage regulation....
Q: Calculate the lower and upper cut of frequencies
A: Operational amplifier- An integrated circuit which amplifies weak electric signals into a strong…
Q: thyristors. What will be the firing angle of the thyristors when a load has 67% of its maximum…
A: the ac voltage controller consists of two thyristors connected in anti parallel to regulate ac…
Q: How Get = S+2 Rind the first order in control system and draw
A: Important Notes about first order system First order system can be described by first order…
Q: Q3. For the forward transfer function plot the root locus K G(s)= s(s+2)(s+8)
A:
Q: Needed to be solved correctly in 30 minutes and get the thumbs up please show neat and clean work .…
A: In this question we will find susceptance of given circuit across ab....
Q: Find the overall susceptance across teminal a-b when Vs = −2 sin(4t + 310°) V. 22 4H 22 a w Vs b 1 2…
A: In this question we will find overall suceptance across ab in given network...
Q: 10 Given the potential V = sin cos 6, (a) Find the electric flux density D at (2, 7/2, 0). (b)…
A: In this question we will find electric flux density and work done for moving a charge with the help…
Q: Find V₂ (t) for all time t. 4 V ΖΩ ww √₁²=0 t=0 7 2 H + VR3202
A: Given:
Q: Problem 2 Find V (t) for all time t. 4 V GAD 202 W 41 t=0 t=0 A 7 2 H + VR202 I
A: In this question we need to find a voltage VR(t) for all time
Q: on Max Va Izm Costa Costa x 100 V₂ 12m Cos02+2P₁
A: Transformer is a static device. Among all machines the efficiency of transformer is high due to…
Q: For the given closed loop system, in the Figure below, find the values of K for which the system is…
A: In this question we need to find the stability , instability range and marginal stable condition for…
Q: b) Find the capacitance of a parallel plate capacitor if the area of each plate is 0.1 m² and the…
A: area of each plate is 0.1 m2 and distance between the plates is 2 mm and dielectric is oil with a…
Q: Design an asynchronous counter that divides the input clock signal by 5 then draw counter's logic…
A: The initial values of the asynchronous counter are always "0" An Asynchronous counter can also be…
Q: Q2: (A) Find tan-¹ (1-5i) -1
A: Let the complex number 1-5i be represented by z, 1-5i=ztan-1z=xtanx=z Using the Euler's formula,…
Q: c) For the circiut shown in fig.(2), the swit find ix(t) for t>0, let R₁ R₂=1k2, R3-2k2, a. Fig.(2)
A: In this question we will find current through resistor R1 ....
Q: Derive an expression for the resonant frequency of the parallel circuit containing Z₁ = (R1 + ¡XL)…
A:
Q: Q3) For the circuit shown below, calculate: VPIS 1- Current I. 2- Resistance voltage VR. 3- VDI- 4-…
A: In the given figure, the diode D1 & D2 are forward biased but diode D3 reverse biased. The…
Q: Design an asynchronous counter that divides the input clock signal by 5 then drav counter's logic…
A: Asynchronous counters are counter whose triggering pulses are not dependent on the clock pulses.…
Q: Q5) let x(t) be a 2π periodic function such that x(t)=t2 for t E[-π.π]. Find the Fourier series for…
A:
Q: What will be the voltmeter reading for the below given electrical network? ww 6Ω 4A 3Ω ΖΩ
A: Given circuit,
Q: Q3 Define Environmental errors? A PMMC with coil resistance of 300052 number of coil 300 turns with…
A: In this question we will find deflection angle for PMMC...
Q: Problem 1 Find i and the power developed in the dependent current source, 2v- 6Ω 5Ω 3 Ω ww 2V Μ + Vx…
A:
Q: Q3) Suppose that x(t) is real-valued signal, then show that: . c) if x(t) = x(-t) (even symmetery)…
A: By using the concept of real valued signal and even symmetry we need to derive the fourier series…
Q: A 20 KVA, 2200/220 V, 50 Hz, single phase transformer gave the following reading: O.C. Test: 220 V,…
A: In this question we need to find voltage regulation , maximum efficiency and equivalent circuit…
Q: The antenna current of an A.M. transmitter is 8 A when only carrier is sent, but it increases to…
A: Given: Antenna current when only carrier is sent , Ic=8 A Antenna current when carrier is modulated,…
Q: Exercise 4-1: (a) Determine the resonant frequency for the Wien-bridge oscillator in Fig. 4-9. Use…
A: Wein bridge oscillator circuit using op amp is a basic electronic circuit which is positive feedback…
Q: (B) Solve the differential equation:- y""-3y' +2=0, y(0) = 1,y'(0) = 1, y" (0) = 0
A:
Step by step
Solved in 2 steps with 2 images
- Convert the following instantaneous currents to phasors, using cos(t) as the reference. Give your answers in both rectangular and polar form. (a) i(t)=5002cos(t30) (b) i(t)=4sin(t+30) (c) i(t)=5cos(t15)+42sin(t+30)Based on Figures la,1b and 1c and RLC elements, write a discussion on voltage-current relations and power factor.A 400 MVA synchronous machine has H, = 4.6 MJ/MVA and a 1200 MVA machine has H₂=3.0 MJ/MVA. The two machines operate in parallel in a power plant. Find out H relative to a 100 MVA base.
- Need asap pls help. Solve for the voltages across and currents through each component. Show the complete solution and explain. The total power should be zero..calculate phasor currents I1 and I2 in the circuit shown belowWhat is the real power, reactive power and complex power delivered by the source in the given circuit? Current source is 10, angle 30 degrees A.
- Add the following two impedances (a) in series and (b) in parallel. Z1 = 4 + 3i and Z2 = 12 + 5iplease solve it with the load being 150 MW and - 50 MVar.A non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos3000t-0.5sin400Ot) A is applied to the circuit shown. Find the * ?total power 42 iL iT ic -J92 {J4Q 28 W 39 W 20 W 55 W
- Q1 For the circuit shown in Figure below, find the complex power absorbed by Z1, Z2, Z3, and the source. 50 Zs 1204 -120 (2 j100 www ellA non-sinusoidal current source (iT=2+1.5sin1000t+ 1cos30o0t- 0.5sin4000t) A is applied to the * ?circuit shown. Find the total power İL iT ic -J9N J4Q 39 W O 20 W O 55 W 28 W )!( هذا السؤال مطلوبThree impedance Za= (3+j4) ohms, Zc= (4-j4) ohms and Zr=0+j3 ohms are connected in parallel. Solve for the pf of the combination.