CoursesReportse-ServicesAcademic DepartmentsELearning PortalFor the given waveform, V lags I by 30°Voltage. (V)+Vm+imCurrent (i)27e = otl6 = 30°-im-VmSelect one:O True Peak factor is defined asO a. RMS value / Maximum ValueO b. Maximum Value / Average ValueO c. Average value / Maximum ValueO d. Maximum Value / RMS value

Answered: Peak factor is defined as a. RMS value…

Peak factor is defined as a. RMS value / Maximum Value O b. Maximum Value / Average Value c. Average value / Maximum Value O d. Maximum Value / RMS value

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter20: Capacitance In Ac Circuits

Section: Chapter Questions

Problem 3RQ: How many degrees are the current and voltage out of phase in a pure capacitive circuit?

See similar textbooks

Related questions

Q: Determine the RMS magnitude of Current I.

Q: Find the average value of the voltage in the figure.

A: The average value indicates the DC level present in the signal. It is given by the area under the…

Q: is the RMS value of output voltage of the step down chopper which is having 240 V as a input for a…

Q: Voltage Peak value RMS value Average value Peak-to- peak value O v Time

Q: The number of cycles completed in one second is called as _________________. a. Peak value b.…

Q: 4. The waveform is shown in Figure below is a half-wave rectified sine wave. Find the rms value and…

Q: Supply voltage has an average value of 202 V. Its RMS value is RMS value Vrms =

A: Given: Average of supply voltage is, Vavg=202 V

Q: Define the following: a. R.m.s value of a sinusoidal wave. b. Form factor , Peak factor. c. Power…

Q: 12. a Derive the equation for the RMS voltage in terms of peak voltage for a cosine wave. That is,…

Q: Problem: Caleulate Average valur, Runs value and Form fuctor of the sawtuutlh wave shon in the…

A: we need to find the average value,rms value,form factor.

Q: Apply Input : 10sin(wt) . Plot the output graph and express. Calculate the RMS. R1= 2kΩ

Q: A 29-Ω television and an 16-Ω amplifier are connected in series across a 158-V source of voltage…

A: Given: A 29 Ω television and a 16 Ω amplifier are connected in series across 158 V source and also…

Q: A step- down dc chopper has a resistive load of R=152 and input voltage 200V. when the chopper…

Q: 3. Find the characteristic frequencies of the coupled electric circuits of the figure below.…

A: The circuit diagram is shown below,

Q: Why does the measured time delays of the two sets of waveforms the same even though the resistors…

A: Power factor is defined as the ratio of active power to apparent power.

Q: convert the v1 and v2 value in rms value

A: In this question, Phasor value of Voltage V1 and V2 are given. We need to convert the v1 and v2…

Q: ——- is the RMS value of output voltage of the step down chopper which is having 230v as a input for…

Q: A 50 HZ Single-phase Injerter of 8o% $quare waveform output voltage supplies a 4omli with 82 from a…

A: For a single-phase inverter,f=50HzL=40mHR=8ΩVs=200V

Q: is the duty cycle of step down chopper which is having 216 V as a input and 202 V RMS output…

Q: Q3. For the power electronic circuit shown in figure below, sketch the output voltage Vo, Find the…

Q: For the below sinusoidal voltage trace displayed by the CRO, the time/cm switch is on 5ms/cm and the…

A: Here each square box is 1 cm x 1 cm And 1 cm length is divided into 10 parts.

Q: The measured AC power represents the of the power waveform * Peak value O Average value rms value O

A: The measured AC power represents the RMS value of the waveform. The power output of the circuit:

Q: Find the RMS Valve

A: We will solve for the RMS value of the given triangular wave.

Q: The RMS value divided by average value is given by a. Average Value O b. Instantaneous Value c. Peak…

Q: the RMS value of the current is? /2) the peak value of the voltage is?/3) the value of the reactive…

Q: Only find the rms and the output voltage

Q: What is the calculated phase angle between the load voltage and current? Using the calculated phase…

A: V=10 V peak f=1 KhZ For given load we have to find load phase angle power factor apparent power,…

Q: Sine wave can be represented by three parameters a. peak amplitude, frequency and bandwidth b.…

A: Sine wave is represented as Vt = Vm sinwt+∅ where Vm is the peak of the signal…

Q: Find the RMS valve [Just try

A: From the standard formula we can able to find the root mean square value of any signal

Q: (a) The peak amplitude. (b) The peak-to-peak value. (c) The average value. (d) The rms value. (e)…

A: as per question we need to answer a,b,c we need to find peak amplitude value, peak to peak value and…

Q: RMS value of 20A. (i) Write down the equation for the instantaneous value (ii) find the value of (i)…

A: In this we will write current equation..

Q: The total RMS current in the series circuit of Te

Q: average real power

A: Given- Vrms=46∠115°Irms=2∠52° From the given data-ϕ=115°-52° =63°So,Power factor, cosϕ=cos63°…

Q: Output voltage for Vmax = 350V and f = 60Hz and calculate the average value of its current.

A: The solution can be achieved as follows.

Q: Peak factor is defined as O a. Maximum Value / RMS value O b. Maximum Value / Average Value c.…

A: Peak factor is ratio between maximum and RMS value.

Q: Q/ Prove that the output of discrete LTI system for a sinusoidal input is sinusoidal

A: We need to prove the given statement.

Q: The step down DC chopper uses DC source voltage V(dc) = 200 V and resistive load impedance of 10…

A: We have an step down DC chopper with, DC source voltage (Vdc) = 200 V Resistive Load Impedance (R) =…

Q: If the peak secondary voltage is 75V 60HZ, then, a) the peak output voltage is V b) the average…

A: In the question, Central tap full wave bridge circuit Peak Secondary voltage V= 75V Find the…

Q: Voltage Peak value RMS value Average value Peak-to- peak value O V Time VT = Vmsinwt

A: Given, The wave form is sinusoidal. Please find the below attachment for the clear explanation.

Q: Find the RMS value

A: The wave diagram shows the maximum value of the voltage as Vm.

Q: Form factor is defined as O a. Average value / RMS Value O b. Average Value / Maximum Value O c.…

Q: (b) Figure 1.1 shows the Thévenin equivalent circuit model that could be used to represent the…

Q: The ratio between the RMS values to the mean value is called as

A: RMS value refers to the root mean square value of the signal

Q: is the RMS value of output voltage of the step down chopper which is having 220 V as a input for a…

A: In this question , we will finf output RMS voltage of opamp...

Q: Please determine based off waveform A)peak amplitude B)peak to peak value C)average value

A: (A) Peak Amplitude is 5 volt

Q: A series of data is gathered discretely at equal intervals of time from an unknown voltage waveform…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: (c) Determine the total current before and after power factor correction.

A: In the given question three different types of loads are connected in parallel. We will first write…

Q: A complex voltage waveform which has an rms value of 240V contains 30% third harmonic and 10% fifth…

A: Given: Vrms=240V 3rd and 5th harmonic components are present in the voltage wave form. Frequency of…

Concept explainers

Single Phase AC Circuit

Alternating Current (AC) is a type of electric power in which the electric current changes, both in magnitude and direction, at regular intervals. This AC Circuits can deliver power in either a Single Phase system or a Three Phase system.

Question

Courses
Reports
e-Services
Academic Departments
E
Learning Portal
For the given waveform, V lags I by 30°
Voltage. (V)
+Vm
+im
Current (i)
27
e = ot
l6 = 30°
-im
-Vm
Select one:
O True

Peak factor is defined as
O a. RMS value / Maximum Value
O b. Maximum Value / Average Value
O c. Average value / Maximum Value
O d. Maximum Value / RMS value

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Analysis of Single Phase and Three Phase System

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Ohmic components have a V-I curve O Non-linear VI curve. Parabolic VI curve. Sinusoidal VI curve. Straight line VI curve.
VR. Ve YL 24 Is 6トO°Y Ic IL A,07 01 f: 50 H2 2mfC V Find Is,Ie, I, Ve,, Vez, I-, VRI, VR2, Ye, VL (ANSWER IN RMS)
find the instantane ous expressions or the applied voltage V, voltage voltage figure. Als draw across resistos Vp and across aeross capaciter the phaser diengram. Vc in Ve R= 62 iz1o 5z sin (6250t)
Calculatethe Value of the Capaeitance at resanamce if w-SooD rad/Seea.k or6 齐

6. Draw phasor diagrams for the following: c) 8Z45° d) 2 –3 Z 5°
C. Draw a general sine wave V vs t and I vs t plot for a purely resistive and a purely inductive circuit and show leading lagging parameters and clearly mark the phase difference.
Prob. I and Vc For the following RMS phasor circuit, a coworker has determined values for 50 Ohms 50 Ohms i,- 225 2253.13° = 190.92 + 254.56 VRMS R1 + R2 Vc = 237.17/26.565° = 212.13+ 106.07 VRMS 100 2 -3Z98.13° =-0.4243 + J2.970 ARMS C -j60 Ohms For this problem provide at least 3 digits of precision for the answers. The results for the following calculations are to be answered in - a) Find the current I b) Determine the real (P) and reactive(Q) power DELIVERED by the source c) Determine the real (P) and reactive (Q) power ABSORBED by each impedance ( resistors R1 and R2, inductor and capacitor). The values for P and Q can be positive or negative. Remember S =P+jQ, so do not include the j with your answer for Q. Each of these answers will require two parts. For the phasor a magnitude and angle will be needed. For the powers, The real power P and the reactive power Q are required.
But the one thing I don't understand is when Vo = Vs - Vd, the Vs is a sine wave substracted by a constant voltage drop so shouldn't Vo also be a sine wave? Why is it a line?
For the resistor shown above what best describes its behavior at 1 MHz? It responds primarily as a resistor It responds primarily as a capacitor O It responds primarily as a inductor It responds primarily as a transformer
A complex number is represented as Z=4+j3 ohm. What will be magnitude and phase of this complex number?
How did they get sin and cos term?
How many degrees are the current and voltage out of phase in a pure capacitive circuit?