List the three main multiplexing techniques Compare FDM, TDM, and WDM based on: What types of signals are being combined? What are being shared? 3. Assuming we are sending data items of 16-bit length. If two data items are swapped during transmission, can the traditional checksum detect this error? Explain

List the three main multiplexing techniques Compare FDM, TDM, and WDM based on: What types of signals are being combined? What are being shared? 3. Assuming we are sending data items of 16-bit length. If two data items are swapped during transmission, can the traditional checksum detect this error? Explain

Systems Architecture

7th Edition

ISBN:9781305080195

Author:Stephen D. Burd

Publisher:Stephen D. Burd

Chapter8: Data And Network Communication Technology

Section: Chapter Questions

Problem 37VE

See similar textbooks

Similar questions

The differences between Frequency Division Multiplexing (FDM) and Time Division Multiplexing (TDM) are very important to comprehend, and it is necessary that a clear understanding be established between the two. Could you kindly provide me with a report that is just one page long?
A signal is carrying data in which one data element is encoded as one signal element (r = 1). If the bit rate is 200 kbps, what is the average value of the baud rate if c is between 0 and 1?
A voice channel occupies a bandwidth of 28 kHz 10 voice channels are to be multiplexed together using the FDM (Frequency Division Multiplexing) technique, considering a guard band of 12 kHz. Illustrate the configuration of the multiplexing and demultiplexing using the frequency domain with proper labeling.
For the following stream of digital signal which is being transmitted by bit rate 5 Kbps: 101100000000110 a) Draw the waveform for all line codes you studied. b) Determine if the line code is self synchronized or not. c) Determine if the code can be used with ac coupling or not d) Determine the Bandwidth of the line code e) Which code is used in magnetic recording f) Which code is used in LAN
One way to electrically or optically represent a binary 1 or 0 is to use current state modulation, which represents a binary 1 with the presence of voltage (on a copper cable) or the presence of light (on a fiber-optic cable). Similarly, the absence of light or voltage represents a binary 0.
Block coding is normally referred to as mB/nB coding; it replaces each m-bit group with an n-bit group. Explain?
An analog signal carries 8 bits per signal element. If 6000 signal elements are sent per second, find the bit rate.
IV For a bit stream 0110010 1, sketch the waveforms for (1) NRZ-I (i) Manchester Note: (i) For NRZ-I and differential Manchester, assume that the signal level for the previous bit at the start is negative. (ii) For pseudoternary, assume that the most recent preceding '0' bit has a positive voltage. (ii) Differential Manchester (iv) Pseudo ternary
For the bit stream 101101010, describe and sketch the waveforms for each of the codes below: (i) NRZ-L (ii) NRZ-I (iii) Manchester (iv) Differential Manchester (v) Bipolar RZ Assume that the signal level for the preceding bit for NRZ-I was high.
The highest frequency in a composite analog signal is 16 hertz. Choose the best sampling rate of the signal in Pulse code modulation, so that the original signal can be reproduced at the receiver side. 8 13 5 42
What is the Nyquist sampling rate for each of the following signals? - A low-pass signal with bandwidth of 150 KHz?
What exactly does it mean to have an inverse ARP?