kindly help me with this problem thank you ill give like for the answer mixture consists of a certain amount of caffeine dissolved in 100 ml. of water
Q: Silver chloride (AGCI) is a white-gray solid used to treat mercury positioning. A student vacuumed…
A: The correct option is:
Q: What percent of X can be extracted with 100 mL hexane? b) What will be the percent X remaining in…
A: The question is based on the concept of solvent extraction. we have to calculate amount extracted…
Q: Use the items to construct a flow chart for the procedure used to create a saturated borax solution…
A: The blanks in the given procedure is filled as follows,
Q: How would the following errors change the calculated value of the percent oxalic acid in the…
A:
Q: (Topic: Gravimetry multi-component analysis) The calcium and magnesium in a urine sample were…
A: Solution - Principle of gravimetry The principle of this type of analysis is that once an…
Q: If given the option between using a P1000 and a P200 pipetter to dispense 200 uL, the P200 should be…
A: P1000 pipette measure between 200μl to 1000μl And P200 pipette measure upto 200μl
Q: Phena Cetin 80 75 70 65 60 55 45 40 35 30 25 4000 3500 3000 2500 2000 1500 1000 500 Wavenumbers…
A: We have find out formation of phenacetin.
Q: Trial % Acetic Acid 1 5.292 5.940 5.828 f. How much NaOH solution in mL would you have used per…
A: Mean is the average of the numbers, i.e., add up all the numbers, then divide by how manynumbers…
Q: A chart is prepared by plotting In Ksp versus 1/T, using data obtained by performing a lab…
A: We have plot of lnKsp vs 1/T with equation of line as y = (-5.0020x10^3)x+(2.100x10^1) . We have to…
Q: A ceric sulfate solution that was standardized using 200 mg of arsenic trioxide (MW = 197.84g/n)…
A:
Q: Sophia and her friend Nora have the same unknown solid. Sophia has progressed a little faster with…
A: The solute dissolved when the hot solution added then it allowed to room temperature slowly.
Q: A large volume of liquid is found to have some insoluble solid present in the bottom of the…
A: Various techniques has been used for the purification of the substances.
Q: Sources of Error Determine the relationship between the observed/apparent value (EX) VERSUS that of…
A: Given: Not all the solid was transferred during the filtration of the precipitate.
Q: For the extraction of acid from a mixture of carboxylic acid and biphenyl you began with 200 mg of…
A: Percent recovery can be calculated using the initial amount and amount recovered.
Q: Vitamin C Analysis, a student accidentally puts 1.0 g of sodium bicarbonate (NaHCO3) solid into the…
A: The sodium bicarbonate (NaHCO3) solid is a base which neutralises the acid in the reaction. Hence it…
Q: A ceric sulfate solution that was standardized using 200 mg of arsenic trioxide (MW 197.84g/n)…
A:
Q: Which of the satements below is/are limitations of Dumas Method? The Ideal condition is just an…
A: The statements given are,
Q: Please provide thorough explanation showing steps with units if needed Will give a like Please…
A: a) No of sigma bonds = 3 No of pie bonds = 1 b) Both diagrams minimize the formal charge on…
Q: The total amount excreted into urine as unchanged drug after an oral tablet (A) of 50 mg was 36.4…
A: The term bioavailability means the amount of concentration available in systemic circulation after…
Q: A student doing this experiment had some problems with the procedure, as described below. Explain…
A: On reaction of magnesium and hydrochloric acid, magnesium chloride and hydrogen gas is produced. The…
Q: Assume an organic compound has a partition cocfficient between water and ethyl acetate equal to…
A:
Q: Accurately prepare a 50cm stock solution of (approx.) 0.003M potassium permanganate solutic Very…
A: Given that: the volume of potassium permanganate solution = 50 cm3 the volume of potassium…
Q: Partition (or Distribution) Coefficient I best way to think about this is to start with a solute…
A: In the given problem we have to describe why the set of liquids used during the solvent extraction…
Q: Why should you know the composition of the weighing form? a. So that it can be washed properly b.…
A: Composition of the compound tells about the mass .
Q: Design a procedure on how you will prepare 1.25 M table sugar (C12H22O11) solution and 1.25 M table…
A: To prepare 1.25 M table sugar (C12H22O11)solution and 1.25 M table salt (NaCl) solution diluted to…
Q: Mass Na CO3 Vi HC1,mL 0.00 0.10 Vf HC1,mL 36.75 Trial VHC) used, ml MHCI 1 0.2135 0.2025 0.2112…
A: Since you have asked a question with multiple sub-parts, as per our company guidelines we are…
Q: 7. The level of ethyl acetate is determined in colchicines by headspace gas Answer: 0.055. in water…
A: In the given problem the head space gas chromatography technique is used to determine the amount of…
Q: A stock salt solution is prepared by dissolving 5.69 g of table salt in water and diluting the…
A:
Q: Calculate the gravimetric factor of: FeO in Fe2O3 Bi2S3 in BaSO4 BaSO4 in (NH4)2SO4…
A: Gravimetric factor is conversion of gm Of compound into gram of single element. It is the ratio of…
Q: Given the following data, prove that the distribution of benzoic acid in water and benzene follow…
A: The total number of moles/mass of benzoic acid is not given to calculate the extracted number of…
Q: A ceric sulfate solution that was standardized using 200 mg of arsenic trioxide (MW = 197.84g/n)…
A:
Q: Can elastic hose use for pumping and transferring concentrated solution of CH3COOH for long time? If…
A: Natural or synthetic rubber is used to make elastic tubes. Hose is primarily used for the…
Q: 4.00 (±0.01) mL4.00 (±0.01) mL Class A transfer pipet is used to transfer 4.00 mL4.00 mL of a 0.300…
A: While diluting a solution, the dilution equation used is: M1V1 = M2V2
Q: A 3mL sample of NaOCl solution was diluted with water and treated with 2g of KI and 10mL Acetic…
A: Here 3ml of sample of NaOCl solution was treated with 2g of KI and 10 ml CH3COOH . The solution…
Q: Molecular weight of a certain volatile liquid which is placed in 225 g flask which has total…
A: According to the question, we need to determine the molecular weight of the volatile sample. Given:…
Q: A student doing this experiment had some problems with the procedure, as described below. Explain…
A: question is looks complex i am answer to only first question that is a.
Q: 25L bag was filled with air, a 10uL sample was then injected into the bag to make 50ppmv vapor…
A:
Q: Identify the effect of the condition on the parameters. Write increase, decrease, or no effect. And…
A: A) The test tube used in the determination of the ΔHrxn for nitric acid was still wet with water. […
Q: (a) Based on the tabulated data, prove that the distribution of benzoic acid in water and and…
A: From the data, the ratio of CwaterCbenzene is as follows, Cwater Cbenzene CwaterCbenzene…
Q: In this experiment, the problem is that the volume of the volumetric pipet is not accurately known…
A: As we know density and volume are related to each other Density = mass/ volume As volume is…
Q: Could you please write me a brief summary about the results that I have and it's about the…
A:
Q: In the single solvent recrystallisation of benzil with methanol, where will a methanol insoluble (in…
A: A multiple choice question based on purification, which is to be accomplished.
Q: During Buchner filtrati on a portion of the filtrate isused for swirling the resi due into the…
A: SOLUTION: Step 1: A Buchner funnel is a piece of laboratory equipment used in filtration. It is a…
Q: ☐ An analysis where we know what analytes we are looking for is called An analysis where we do not…
A:
Q: DATA FROM RECRYSTALLIZATION EXPERIMENT Weight of crude benzoic acid, g 0.2498 Weight of filter…
A:
Q: You have 100 mL of a solution of benzoic acid in water; the amount of benzoic acid in the solution…
A: Volume of benzoic acid solution = 100 mL Mass of benzoic acid in solution = 0.30 g Distribution…
Q: Please help me there are multiple parts, double check your answer as previous tutors got it wrong.
A: The given illustration is the procedures for the preparation of borax solution.
Q: the hormone estradiolhas a partition coefficient of 3.2 between 1-octanol and water. How many…
A: In the given problem we have to provide the number of extraction required to achieve approximately…
Q: After the extraction process, the organic solvent containing the organic compound was cooled and…
A: The transfer of the substance from one solvent to another solvent by the process is termed the…
kindly help me with this problem thank you ill give like for the answer
mixture consists of a certain amount of caffeine dissolved in 100 ml. of water
a) How much caffeine was originally used when 0.31 g of the organic compound was devolved n watt:, and 150 ml ether was used as extraction solvent
b) How much was dissolved n ether
Step by step
Solved in 2 steps with 1 images
- If the same mass of Na2SO4 (MW: 142 g/mol) and K2SO4 (MW: 174 g/mol) were weighed and used for the gravimetry experiment, which will yield a greater amount of precipitate? Assume that the experiment was done correctly. Indeterminate, it will depend on the (A amount of BaCl2 used. Na „SO, , because it has a smaller В molecular weight. They will yield the same amount of precipitate because the same mass was initially weighed. K,SO, , because it has a larger (D molecular weight. 4Q1: What is the density (g/ml) of a 3.6M Sulfuric acid solution that is 29% H,So, by mass (Mwt. = 98)? Q2: Fill the blanks with suitable answers 1: The is the thing being dissolved. ......... 2: The branches of quantitative analysis are and 3. The filterability of the precipitate depend on the of practices. Q3: Which one is correct? 1. Molality changes with temperatures. 2. Molality does not change with temperatures. 3. Molarity changes with temperatures. 4. Normality changes with temperatures. Q4: What weight of pyrite ore (impure FeS,) must be taken for analysis so that the BaSO, precipitate weight obtained will be equal to one-half that of the percent S in the sample? Note: Mwt. of Ba =32, Mwt. of BaSo4 =233, Mwt. of FeS, =119I NEED HELP PLEASE ASAP!!! Hoping for complete solutions since I’m having a hard time with this. Pls skip if unsure or not willing to answer the subitems (these are all connected for one item). Please show full solution and I'll give thumbs up. Thank you!
- plz do both with detail explanation plz ...do not give incomplete solution2 Trial 1: [4] Volume of NaOH, dispensed (mL) Trial 1: [5] Molar concentration of NaOH (mol/L) Trial 2: [4] Volume of NaOH, dispensed (mL) How Trial 2: [5] Molar concentration of NaOH (mol/L) Trial 3: [4] Volume of NaOH, dispensed (mL) Trial 3: [5] Molar concentration of NaOH (mol/L)Benzalkonium Chloride (E=0.16) =1.5g Distilled water qs 0.9% NaCl solution ad =100 mL Make isoton. Sol. Apply on affected area p.r.n. 1. How many mL of distilled water must be added to make the Benzalkonium chloride preparation isotonic? 2. How many mL of 0.9% NaCl must be added to make a 100 mL solution?
- (Preparation of 0.1 N HCI solution in 250 ml D.W) Procedure: Preparation of approximately (0.IN) HCI from 37% and 1.2 Sp.g • Calculate the Normality of the concentrated HCl from the law: To prepare (500ml) of 0.IN HCL: NI VI = N2 V2 NI x ? = 0.1 x 500 • Transfer some of distilled water to 500ml volumetric flask and add the calculated volume of conc. HCI. Mix the content thoroughly. Complete to the mark with distilled water and make a label.1 4 6 7. 8 9. 10 -10 An aqueous solution at 25 °C has a H,O' concentration of 6. x 10 "M. Calculate the OH concentration. Be sure your answer has 1 significant digits. | M Subm Continue © 2022 McGraw Hill LLC. All Rights Reserved. Terms of Use Privacy CentChoose the situation below that would result in a AHsolution near 0 A B O C OD DE O When IAH solvent! >> AHsolutel O When IAHsolutel > AHhydration! O When IAHsolutelT Normal T No Spac... Heading 1 Heading Paragraph Styles 5. Astock solution of 0.1M of NazCO3 is available. How many milliliters are needed to make a 100.0 mL of 0.01M 0.02M 0.03M 0.04M 0.05M solutions?given the molar mass of of compound A as 327.34g/mol and the mass being 0.016g. calculate the concentration of compound A (the stock standard) if it is mixed with 50ml water then 2ml, 4ml and 6ml of the stock standard are measured into a 10ml volumetric flask. calculate the concentrations of the 2ml, 4ml and 6 ml solutions.Can you help me determine the required amount of 500mg ascorbic acid tablets to puverize the necessary amount of distilled water to make the desired concentration of stock solution (0.1M) Show complete and justifiable computations pls.SEE MORE QUESTIONS