Answered: Find the resistance of the coil.

Engineering

Electrical Engineering

Find the resistance of the coil.

Delmar's Standard Textbook Of Electricity

7th Edition

ISBN:9781337900348

Author:Stephen L. Herman

Publisher:Stephen L. Herman

Chapter21: Resistive-capacitive Series Circuits

Section: Chapter Questions

Problem 7RQ: An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a...

See similar textbooks

Related questions

Q: A radio receiver uses an RLC circuit to pick out particular frequencies to listen to in your house…

A: The radio antenna receives all frequencies. In order to filter the desired frequencies, the radio…

Q: Draw the graphic symbol of a BCD-to-decimal decoder. This is similar to a decoder with 4 inputs and…

A: The BCD-to-decimal decoder is shown below:

Q: Consider an aperiodic continuous-time signa x(t) having the corresponding Fourier transform X(jw).…

A: In this question we will find Fourier transform of given signal....

Q: Given x[n] = 8[n 1], then the DTFT of x[n] is - Select one: O X(ej) = e-ja O X(ej) = -ejw X(ej") =…

A: Given discrete time signal Need to be converted into DTFT using the properties of DTFT DTFT impulse…

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: +1,0V +36 slokn 5.6kn B = 50, assume VBE) = 0.8V fina VE, VC, VB 1E, ib, ic

Q: Three circuits A, B and C are connected in series across a 200 V supply. The voltage across circuit…

A: We got an Series Circuit of A,B,C with, Supply Voltage = 200 V = 200 Sin (ωt) Voltage across circuit…

Q: ) Find Find the power factor of a circuit that absorbs 1.5 kW for a 120 V input voltage and a 16 A…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: A de electrical shunt motor rated 50 kW connected to a 250 V supply is loaded as to draw 200 A when…

Q: A series RLC circuit has a resistance of 7.5 , a capacitance of 10-2 F, an inductance of 1/6 H, and…

Q: Determine the velocity of electromagnetic wave in free space. I need detail calculation.

A: In this case, the velocity of an electromagnetic wave in free space is to be determined.

Q: Q.9 A cathode-ray tube accelerates electrons through a 20 kV potential difference. To what speed are…

A: Given data, Potential difference V= 20 KV Charge on electron e=1.6×10-19 C Mass of electron…

Q: find the value of "t".

Q: Taking the derivative of a second-order system response to find the peak time Tp always gives us a…

Q: Given x[n] = a¹u[n] ←→ X(ej") = = 1-ae-J Then the DTFT of x[n] = (2-"-3")u[n] is Select one: O…

Q: Show that the two systems shown in Figure (1) are equivalent. Depend on your study, what is this…

A: Given:

Q: A 2-pole wave wound dc generator has 120 conductors in each parallel path of its armature. If it is…

A: For wave wound Number of parallel paths is equal to number of poles So A =2 Emf equation will be…

Q: A shunt generator supplies a full-load current of 100 A at 110 V. The shunt field resistance is 55…

Q: A resistor of resistance R = 15 MN is connected in series to a capacitor or capacitance %3D C = 19…

A: The series RC circuit can be analysed based on the initial and steady state voltage across the…

Q: Problem 23. A 4 pole generator with wave wound armature has 51 slots each having 24 conductors. The…

Q: Two shunt DC generators G1 and G2 are rated at 100 and 150 kW at 110 V respectively. Their external…

Q: Of the following test, which is the most valid for checking a diode?

A: Ohmmeter Mode (or Resistance Mode)- a forward and reverse resistance check with an ohmmeter d is…

Q: 2. Transform the sine waves shown in Figure 1 below into frequency domain and find the bandwidth.…

Q: =. A 4-pole, lap-wound armature has 144 slots with two coil sides per slot, each coil having two…

A: Given, Number of poles, P=4 Lap wound, A=P=4 Slots, S=144 with 2 coil sides per slot and each coil…

Q: To access the services of the operating system, the interface is provided by the

A: The correct option along with the explanation is provided in the following section.

Q: A D'Arsonval galvanometer, 1 mA, 50 ohm is to be converted to a 5 Amp-ammeter. What is the value of…

Q: 24. What value is to be considered for a "don't care condition"?

A: The correct option is provided in the following section.

Q: 15) Consider a system with transfer function G(s) = (s + 4)/ (ks^2 + s + 4). The value of damping…

A: Given data, Transfer function is given, Gs=s+4ks2+s+4=s+4s2+sk+4k

Q: Consider a fourth-order system with the characteristic equation 5² +85³ + 18s² + 16s + 5 = 0

A: We have been given one fourth-order system with the characteristics equation , As nothing is asked…

Q: Q2 () () What is the difference between a Wheatstone bridge and a Kelvin bridge? Your explanation…

A: Since you have asked multiple questions, we will solve the first question for you. If you want any…

Q: Make a pneumatic circuit and an electric circuit with Single Actuator (Cylinder). . A double acting…

A: Given: A double-acting cylinder is used to press glued components. Upon operation of a push button,…

Q: wo generating stations A and B have the capacities 500MW and 800MW respectively are interconnected…

A: It is given that: 1. Two generating stations A and B have the capacities 500MW and 800MW…

Q: Question 2: Refer to the Figure 2 below. Determine the following parameters shown on the table given…

A: Given, Volt/div is equal to 500 mV. Time per division is 500 μsec/div

Q: A simple sphere can offer resistance to a current flowing radially outward from it. If the radius of…

Q: In the figure, these three resistors are connected to a voltage R, source so that R2 = 5.5 N and R3…

A: The required parameters can be calculated by using resistor reduction techniques and by using the…

Q: Given X(w) = Then X(0) = Select one: ㅇㅇ 이름 ㅇ 8 년 0 8 이후 1 sin(3) j2 (0

Q: Z = ACBD + ABCD + ABC

Q: In a band pass filter, if fH= 7 kHz and fL= 2 kHz, then the center frequency equals: * 3.7 kHz 0.37…

A: Given: In a band pass filter, fH=7 kHzfL=2 kHz

Q: In the circuit shown, use KCL, KVL, and Ohm's law to determine the value of Is so that the the…

A: It is given that: VR3=4.9 VIR4=3 mA

Q: 38. If the current flowing through a 20 ohm resistor is given as, i(t) = 4 + 5 sin wot - 3 cos 3 wot…

A: Given data, Resistance R=20 Ω Current equation it=4+5sinωt-3cosωt

Q: (1) Determine the output voltage of the DAC (digital-to-analog converter) if the input is…

Q: An electric heater is constructed by applying potential difference of 104V across a wire with a

A: Given data, Potential difference, V = 104 V Resistance R=5 Ω

Q: Define the Radio and TV Waves.

A: Radio Waves: The longest wavelengths in electromagnetic spectrum are found in radio waves, which…

Q: Why is the following situation impossible? A technician is testing a circuit that contains a…

A: Given: 3 resistors Resistance of a single resistor is 'R'. The desired resistance is 73R.

Q: Consider the following layout diagram. Draw the electrically equivalent transistor-level schematic.

A: The Given is to draw the electrically equivalent transistor-level schematic from the given layout…

Q: 35. What is the group of 1s present in 8 cells of a K - map called?

A: The correct option along with the explanation is provided in the following section.

Q: 1 0 8 (t) t

Q: Part 2. Determine the z-transform and ROC of x(n) = 3¹u(n-2)-n7"u(-n-1) Let x₁ (n) = 3"u(n − 2).…

A: Since you have posted the multiple questions so we are supposed to answer the 1st questions.

Q: LT of the given function

A: In this case, the Laplace transform of the given function is to be determined.

Q: X Express the reconstructed signal if x(t) is sampled at 80 Hz. Given x(t)= Acos[(130–20v)πt] v=1

A: The signal x(t) is given as x(t)=∑v=15Acos[130-20vπt]x(t)=Acos[130-20×1πt]+Acos[130-20×2πt]…

Question

A coil of 0.8 pf is connected in series with 110-uF capacitor. Supply frequency is 50 Hz. The potential difference across the coil is found to be equal to that across the capacitor. Find the resistance of the coil.

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Three capacitors having capacitance values of 20F,40F, and 50F are connected in parallel to a 60 - Hz power line. An ammeter indicates a circuit current of 8.6 amperes. How much current is flowing through the 40F capacitor?
An RC series circuit is connected to a 120-V, 60-Hz power source. The resistor is 25 and has a voltage drop of 65 volts. What is the capacitance of the capacitor?
List the five capacitor replacement rules.
You are an electrician working in an industrial plant. You discover that the problem with a certain machine is a defective capacitor. The capacitor is connected to a 240-volt AC circuit. The information on the capacitor reveals that it has a capacitance value of 10 mF and a voltage rating of 240 VAC. The only 10-mF AC capacitor in the storeroom is marked with a voltage rating of 350 WVDC. Can this capacitor be used to replace the defective capacitor? Explain your answer.
An AC circuit contains a 24 resistor, a 15.9-mH inductor, and a 13.3F capacitor connected in parallel. The circuit is connected to a 240-V, 400-Hz power supply. Find the following values. XL=XC=IR=AIL=AIC=AP=WVARsL=VARsC=IT=AVA=PF=%=
What frequency must be applied to a 33-mH inductor to produce an inductive reactance of 99.526 ?
A postage stamp mica capacitor has the following color marks starting at the upper left dot: yellow, violet, brown, green, no color, and blue. What are the capacitance value, tolerance, and voltage rating of this capacitor?
You find that a 25-F capacitor connected to 480 VAC is defective. The storeroom has no capacitors with a 480-VAC rating. However, you find two capacitors rated at 50 F and 370 VAC. Can these two capacitors be connected in such a manner that they can replace the defective capacitor? If yes, explain how they are connected and why the capacitors will not be damaged by the lower voltage rating. If no, explain why they cannot be used without damaging the capacitor.
Please explain this question properly A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
A capacitor has a reactance of 40 when operated on a 50 Hz supply. Determine the value of its capacitance. In a series R–L circuit the p.d. across the resistance R is 12V and the p.d. across the inductance L is 5V. Find the supply voltage and the phase angle between current and voltage
An inductor and a resistor are in series with a sinewave voltage source. The frequency is set so that the inductive reactance is equal to the resistance. If the frequency is increased, then options: Voltage across the inductor= Source Voltage Voltage across the inductor> Voltage across the resistor Voltage across the inductor= Voltage across the resistor Voltage across the resistor > Voltage across the inductor
A capacitor in series with a 20-KO resistance across a 10 V ac source. What size C is needed for equal voltage across R and Xc at frequency of 100 Hz and 100 KHz.