Find the real and reactive power absorbed by each element in the following circuit. -j5 n HE + VE Vsi + 202 www j3 n V₂ +125/0° V rms A I +95/-10° V rms Vsz
Q: )Two complex loads Z1 and Z2 are connected in parallel and powered by a value voltage effective 7.2…
A: In this question, We need to determine the total capacity of the combine load and value of…
Q: 9. An inductor has the following characteristics: Carbon steel core, Core length of 100mm, 500 turns…
A:
Q: For a 2-PAM scheme (assume equiprobable), to what value does E₂ the bit error probability approach…
A: Given Eb/No ---> 0 Then BER =?
Q: R= L = G = C =
A: Given data, Impedance Z0=43-j2 Ω Propagation constant γ=2+j7 m-1 Frequency f=241 MHz
Q: A 1GHz cosine wave of 1V rms amplitude travels down a transmission line with a propagation velocity…
A:
Q: Find the voltage between terminals a and b. Use any of the following techniques: a) Overlap. b)…
A: Given below clear explanation
Q: 5. In a certain biased limited, the bias voltage is 10 V peak sine wave. If the positive terminal of…
A:
Q: A 36, 460 V, 100 hp, 60 Hz, six-pole induction machine operates at 3% slip (positive) at full load.…
A: Given that In a 3-phase induction machine Power=100hp Voltage=460V frequency(f)=60Hz No.of poles =6…
Q: Since a 100-gain instrumentation amplifier operating at room temperature amplifies a 10μV signal…
A: Given data The gain of the instrument amplifier, Av=100 The input voltage of the instrument…
Q: How many degrees does V₁ = 12sin(wt-25°) lead V₂= 18cos(wt+65*)?
A:
Q: P14.44. Consider the circuit shown in Figure P14.44. The two coils have L1=0.1 H, L2=10 H, and M=1…
A: We need to determine and sketch i1(t) and v2(t) w.r.t time.
Q: Problem Calculate the angle of refraction at the air/core interface, 0₁. critical angle, and…
A: The light is moving from the air to the core. The incident angle and the reflected angle in terms of…
Q: Find the minimum sampling frequency for the bandpass signal whose frequency spectrum is given in the…
A: Given: The spectrum of a band pass signal as, To find: i) Minimum sampling frequency above shown…
Q: A shunt generator delivers 180 A at a terminal voltage of 250 V. The armature resistance and shunt…
A:
Q: The magnetic field from the current-carrying conductor induces a current in the metal sheath or…
A: Given information, The magnetic field from the current-carrying conductor induces a current in the…
Q: The op-amp shown in the following figure has R1 = R2 = R3 = 100 2 Rf = 1 k2, and V1 = V2 = V3 = 50…
A: Given: In this question, the given details are, The given op-amp figure is, And the given values…
Q: term Phojas slepsiesentation NE) = cos (3wot +30°) + sin(juot-60°) v(t) = (as( swot +30°) + sin…
A:
Q: t the current density be J = e* cos 4 ya, + e*sin 4 ya, A/m². Determine the current ossing the…
A:
Q: 2. Calculate the output voltage of the circuit of Fig. 15.49 for input of 150 mV rms. 36 k Figure…
A: Given: In this question, the given details are, Here, the given input voltage is, Vi=150 mV rms, and…
Q: For 4 pole induction motor a ņ 1₁ = √₂² = 0.252 1X₁ =gX₂ =g8 Vel = 480 v Find S Find Smax Find 3…
A: It is given that: p=4r1=r2'=0.2 ΩX1=X2'=8 ΩNm=Nr=1775 rpmVL=480 VAssuming f=60 Hz
Q: A loadline is drawn on the BJT transistor characteristics shown in Figure 3. f. Determine the value…
A:
Q: A radio antenna broadcasts a 1.0 MHz radio wave with 30.0 kW of power. Assume that the radiation is…
A: Given data: The power is, P=30.0 kW=30×103 W The wave's intensity, r=35 km=35×103 m
Q: Question 04: The inputs for a gated S-R latch are shown in figure. Find the output Q and Q in proper…
A: The given diagram is shown below,
Q: Design a circuit with logic gates that deactivate three solenoid valves when the object is present…
A: According to the question, we need to design a circuit with logic gates that deactivate three…
Q: Design a combinational circuit produces the binary sum of two 2-bit numbers x1x0 and y1y0. The…
A:
Q: 6.19 Obtain the equivalent capacitance of the circuit in Fig. 6.54. 35 μF Figure 6.54 40 μF 10 με 10…
A: Given a circuit Asked to find the equivalent capacitance seen from the terminals a,b
Q: (-) The switch in the circuit below has been in position a for a long time before it moves to…
A: Since you have asked multiple question, we will solve the first question for you. If you want any…
Q: Lightning strikes a dielectric sphere of radius 20 mm for which &, = 2.5, σ = 5 x 10-6S/m and…
A: Given: In this question, the given details are, Lightning strikes a dielectric sphere of radius 20…
Q: 3. When two resistors are connected in series the total resistance is 108 0; when connected in…
A: Two resistors Total resistance in series = 108 ohms Total resistance in parallel = 24 ohms
Q: 6. Find v(0*). a) -5 V b) 10 V c) -15 V d) 20 V e) none of these 7 Find (E) 10 V 2 kn ww t=0 20 mH…
A: Since you have asked multiple questions in a single request, we will be answering only the 1st…
Q: Determine Vo and is in the Op-Amp circuit shown in the figure below. ww 6 ΚΩ |12V 6 ΚΩ 16ΚΩ 6 ΚΩ 6…
A: We need to find out the output voltage and current for given circuit.
Q: ble 1. Voltages in Volt (V) and Currents in milli Ampere (mA) Parameter VL V₂ V3 IG Computed Values…
A:
Q: A balanced 3 phase star connected load draws power from a 400 V supply. Two wattmeter's indicate…
A: Given- A balanced three-phase star-connected load draws power, From supply voltage, V=400 V. Two…
Q: Reduce the circuit to a single current source with a resistor in parallel
A: Given, The given circuit diagram,
Q: 4. Findi(t) and vo(t). 10cas(10*t) V + 10Ω ΑΜ ἰ 109 30μF ++ + 10mH Lell Big ΜΕ 10Ω
A:
Q: Question No. 27 A 230 V, 50 Hz, 4-pole, single-phase induction motor is rotating in the clockwise…
A: Given- A single-phase induction motor rotating in the forward direction, Frequency, f = 50 Hz Number…
Q: VL = 600 ohms V2 = 500 ohms V3 = 100 ohms
A:
Q: The area of a Parallel plate capacitor is 20 in2. Give the answer in m² O 12.9 x 10-4m² O 12.9 x…
A: In this question We need to determine the area of parallel plat capacitor in meter2 . We know 1 in=…
Q: Using superposition, solve for 6A using mesh analysis in clockwise
A: Given, Circuit is We need to find current through R8 resistor using superposition theorem due to…
Q: 4. Given a carrier power of 10kW, verify that the total transmitted power remain the same as the…
A: Given information, Carrier power is Pc=10 kW. Modulating index is mf=0.25. We need to verify that…
Q: QA) a. Sketch the output v. and determine the dc level of the output for the network of Fig. 1. b.…
A:
Q: Consider the signal x()= cos(57)sin(37). a) Find the exponential Fourier series for the signal…
A: This question is based on exponential Fourier series.
Q: x(n) = 0.25"u(n) + 0.5"u(n-1)
A: To find Z-transform:
Q: 4.36 Find the Norton equivalent of the circuit in Fig. 4.98. 4 A Figure 4.98 6Ω 692 www For Prob.…
A:
Q: -12V 60 www >30 :40 R₁ 40
A:
Q: 2. Consider a sample of GaAs at 300 K in which the Fermi level is 0.40 eV below the bottom of the…
A:
Q: the following electrical system. 8(t) L=2H C=0.25F m JE R=6
A:
Q: Exercise. There is a system that works with a sampling rate of 48 kpsp and requires a bandpass…
A: According to the question, there is a system that works with a sampling rate of 48 kbps and requires…
Q: 1. A compound-wound generator terminal connection box contains terminal leads a. F1, F2 and A1, A2.…
A: Compound wound generators:- Compound wound generators have both series field winding and shunt…
Q: A short shunt compound generator delivers a load current of 39A at 240V, and has the armature,…
A: Given:- IL= 39 AV =240 VRa =0.45 ohmRse= 0.06 ohmRsh=220 ohmEg = ?
Step by step
Solved in 3 steps with 3 images
- 10 Q j10 O j10 O ... Vx ell ell 10 V sine -j10 O sine @node x: Y11VX = Isc1 RE IM RE IM Y11 Blank 1 Blank 2 Blank 3 Blank 4what is the reactive power absorbed by the load ZL in VAR? Assume source is in rms1.18 In the circuit shown in the figure below, for what value of C will the current-I be in phase with the sinusoidal source voltage .= sin2t? S I C (1 + j1) 2 el eareern Vs slinw
- Find the RMS value of Vit)-100 sin(377t+76) V 141,421 V 55,10 V 100 V 70.71 VP.3: Find the rms value for the following sinusoidal waveforms a. v= 120 sin(377t + 60°) b. i=6x 10³ sin(2# 1000r) c. u=8 x 10-6 sin(2# 5000 + 30°) P.4: Find the rms value for the following sinusoidal waveforms a. v= 20 sin 754r b. v= 7.07 sin 377r c. i=0.006 sin(400r + 20°) d. i 16 x 10³ sin(377r - 10%) P.5: Write the sinusoidal expressions for voltages and currents having the following rms values at a frequency of 60 Hz with zero phase shifts: a. 4.8 V b. 50 mA c. 2 kVShown in the figure below is an "RL" circuit drive by an AC power source. The AC power source has an RMS voltage of Vps (RMS) = 9.84 Volts and is running at a frequency of f = 8.585e+04 Hz. The resistor has a resistance of R = 2170 and the inductor has an inductance of L = 3.54e-03 Henries. Vps R ww Write the FORMULA for the total impedance of the circuit Ztot = Determine the numerical value of Ztot = 2890.5 Determine the numerical value of $z= = 41 Determine the current through the circuit: • I(PEAK) = 4.81E-3 • I(RMS) = 3.404E-3 Determine the voltage across the resistor: • VR(PEAK) = 7.387 • VR(RMS) = 5.22 ✔✔ Amps ✔Amps Write the FORMULA for the phase of the total impedance of the circuit z... = | tan-1 2701 R x Volts X Volts Determine the voltage across the inductor: • VL(PEAK) = 9.184 • VL(RMS) = 6.49 ✔ Volts Volts L R²+ WL- ✔ degrees 2 If a second circuit were connected in parallel with the inductor, this circuit would be considered as: O a low-pass filter O a capacitive switcher…
- For the following waveforms: i = 2 sin(wt – 60°) v =-50sin(wt + 30°) The relationship between the two waveforms is: a) the current leads the voltage by 90° b) the current lags the voltage by 90 the current and the voltage are in phaseFind the RMS value of V)-100 sin(377t+76) VQUESTION 3 An inductor, a capacitor, and a resistor are connected in parallel with a function generator. The inductor draws 100mA RMS, the capacitor draws 150mA RMS, and the resistor draws 200mA RMS. Find the magnitude of the total current. O 450mA RMS O 544mA RMS O 352mA RMS O 206mA RMS
- 5) Find the reactance the inductance and impedance of the circuit. Calculate the current of this circuit and the sketch waveform of current and voltage. V1 10 V 60 Hz R1 m 100kQ 12 Vrms 1000 Hz 0° 6) Find the reactance the inductance and impedance of the circuit. Calculate the currents of this circuit R www 502 L L1 106mH eee 10 mHTe netuork show in ope eating in the tondy Thandy state wilh sinussidal vol voltage douce and V, 2 Sin2t delernine the volla fe Va(t) 2178 F Va 2178F 2173F IH60. Design a circuit to limit a 20 V rms sinusoidal voltage to a maximum positive amplitude of 10 V and a maximum negative amplitude of -5 V using a single 14 V de voltage source. 61 Datermine the volto in the girRuit F Figura 1 1?