A spherical insulator of radius R₁ = 10 cm has a spherically-symmetric charge density given by p(r)=r+r². That sphere is centered at the center of a neutral, conductive spherical shell of inner radius R₂ = 19 cm and outer radius R₁ = 21 cm. (a) Find the total charge on the inner sphere. (b) Determine the charge density induced on the inner surface of the conducting shell. (e) Determine the electric field strength i. from r = 0 to r = 10 cm, as a function of r, ii. from r= 10 to r=18 cm, as a function of r, iii. at r = 20 cm, iv. from r = 22 to r= 30 cm, as a function of r.

A spherical insulator of radius R₁ = 10 cm has a spherically-symmetric charge density given by p(r)=r+r². That sphere is centered at the center of a neutral, conductive spherical shell of inner radius R₂ = 19 cm and outer radius R₁ = 21 cm. (a) Find the total charge on the inner sphere. (b) Determine the charge density induced on the inner surface of the conducting shell. (e) Determine the electric field strength i. from r = 0 to r = 10 cm, as a function of r, ii. from r= 10 to r=18 cm, as a function of r, iii. at r = 20 cm, iv. from r = 22 to r= 30 cm, as a function of r.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Conductors, Dielectrics, and Capacitance Q4) Assume a 2 V conductor wire with a 3 cm diameter is embedded in silica with a relative permittivity of 2.25. The wire's center is 10 cm away from a 0 V conducting plane. Draw the wire, the conducting plane, and the wire's image. 1) Find the capacitance between the wire and its image per unit length. 2) Find the maximum surface charge density on the wire.
A sphere has radius of R. The sphere also has a uniform charge of 4Q. There is a point charge of -Q at sphere's center. Derive an equation for E at points where the radius is less then R.
Q1) A charge q = 2µC is placed at a = 0.1m from an infinite grounded conducting plane sheet. Find;i) The total charge induced on the sheet.ii) The force on the charge q.iii) The total work required to remove the charge slowly to an infinite distance from the plane.
3. The space between the plates of a parallel-plate capacitor is filled with two slabs of linear dielectric material, parallel to the plates. Each slab has thickness L, so that the total distance between the plates is 3L. Slab 1 has a dielectric constant of 2, and slab 2 has a dielectric constant of 2.5. The free charge density on the top plate is o and on the bottom plate is –o. a) Find the electric displacement D in each slab. 1 b) Find the electric field E in each slab. c) Find the polarization P in each slab. d) Find the location and amount of all bound charge. [6]
5. The cylindrical surface p = 6 cm contains the surface charge density p₁ = 10e-10lzl nC/m². a.) What is the total amount of charge present?
(al:Determine E caused by the spherical cloud of electrons with a volume charge density of - 1.68 x 10 -18 for 0 10mm. Clearly mention the surfaces, there differential components and write the equation properly by doing all the steps. (b): For the dielectric composition shown in the figure find out its total capacitance.
Two 1.20 m non-conductive wires form a right angle. A segment has +2.50 µC of charge, distributed evenly along its length; while the other segment has -2.50 µC of charge, distributed uniformly along its length, as illustrated in the ﬁgure. Find the magnitude and direction of the electric field produced by these wires at point P, which is 60.0 cm from each wire.
A spherical conducting shell has a charge of 22 ic on its outer surface and a charged particle in its hollow. If the net charge on the shell is 3- 16 uC , what is the charge on the inner surface of the shell?
3. Consider a metallic wire encircled by a cylindrical conducting shell as shown below. The space between the wire and the shell is filled with a dielectric of permittivity ɛ1. The space outside the shell is another dielectric with permittivity E2. • Inner radius: a • Outer radius: b (1) Initially, no charge is present. Find the electric field and potential distribution in the whole space. For (2) and (3), assume the wire is charged with infinite line charge density pi. (2) Find the induced surface charge density on surfaces a and b. (3) Find the distribution of electric fields, electric flux density, potential, and polarization.
32. Find the resistance of the sector of a spherical shell of conductivity a, with a cross-section shown in the figure below, between its base.
A spherical conductor has a radius of 0.04m. On the surface an amount of charge is evenly distributed with a surface charge density of o = 6.5- nC What is the strength of the electric field at the surface of this conductor? m2
A conductor material in the form of a quarter ring with a radius of 2 inside a, outside radius b, and thickness h. The material has a conductivity , the surface on the y-axis is given a potential VO, and the surface on the -axis x is given a zero potential. What is the resistance between the two ends of the square surface of the conductor material b