Answered: A closed reservoir filled by water, is…

A closed reservoir filled by water, is under the pressure of 49 KPa as shown in the Fig.1. find the velocity of water (V) which leaves the reservoir.

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: An object moving with speed of 5 m/s has kinetic energy of 1200 J. Find the mass of object

A: Given data : Kinetic energy (K.E)=1200 J Velocity (V)=5 m/s Required : Mass of object

Q: In the below system, the pump uses 20°C water. If z2 = 225 ft, what is the flow rate (in ft3/s) if d…

Q: 1. A jet of water strikes on series of cup shaped vanes which deflects it through 165 degrees If the…

Q: Find the flow rate of water through the system shown for the turbine to produce 20kW. Neglect…

A: the power rate of the turbine is P=ρQgHQ=PρgH=200001000×9.81×30=0.068 m3/sec

Q: a. Given A Fan A with Power in Kw of 10.25 and Fan B with 12.75 kw. Speed of Fan B is 750 rpm, Find…

Q: A 4m3/hr pump delivers water to a pressure tank. At the start; the gage reads 138kpa until it reads…

Q: Find the kinetic energy stored in body of mass 1 kg moving with velocity 2.3 m/s

A: Given data : Mass of body=m Velocity=V Required : Kinetic energy

Q: as shown in figure shown below if the velocity of water at point (A)is(30m/s)with pressure of (90000…

A: We have to find pressure and speed of water at point a, b and c

Q: Find the velocity of car Kinetic energy=888 J Mass of car=70 kg

Q: A car is moving on a straight road at 10 m/s .it is accelerated at 14 m/s2. What will be it's…

A: Given data : Time = t Initial velocity = u Acceleration = a To…

Q: If a pump discharges 90 GPM of water whose specific weight is 61.5 lb f /ft 3 (g = 31.95 ft/s 2 ),…

Q: An air compressor has a suction volume of 0.35 cubic meter/ second at 97 kPa and discharges to 650…

A: The suction volume of the air compressor is, V1=0.35 m3/s. The pressure at the inlet of the…

Q: A Wind turbine has a rotor diameter of 33m. At wind speed of a 13m/s what is the power [MW] in the…

A: Given, The diameter of the rotor, d = 33 m The radius of the rotor, r = 16.5 m Speed of wind, V =13…

Q: An elevator with total mass of 1,600 kg is moving up ward with constant acceleration. A friction in…

Q: While the pressure remains constant and 85 psig, the volume of air changes from 20 t3. Find the…

Q: A centrifugal pump driven by a 120-kW motor rotating at 2400 rpm is used to pump 20°C water in a…

A: Answer: The amount of water circulated through the pump is 0.40446 m3/s.

Q: A 150 kN block slides down a plane inclined at an angle of 33º with horizontal. Neglecting friction,…

Q: An object is dropped from a height of 14 m. At what height will it's kinetic energy and it's…

A: Given: kinetic energy= potential energy

Q: A liquid flow through pipe of 10 cm2 a velocity of 6 cm/s. Find the value of discharge

A: Given data : Area of pipe=A Velocity of liquid=V Find : Discharge

Q: Q2/Water is being pumped from a reservoir to the hill, water discharged (0.245m'/s) as shown in Fig.…

Q: A wind turbine receives air at 50kph and receives energy from it then the flowmeter behind it reads…

A: Given Entry velocity, V1 = 50 kph = 13.9 m/s Exit velocity, V2 = 10 kph = 2.8 m/s Find…

Q: A hemispherical tank with a diameter of 8 ft is full of water find the work done in ft-lb in pumping…

Q: the rate of 0.5 kW. How long does it take for the temperature of the water to rise to 35°C if no…

A: Given: mass of water =20 kg T1=25oC rigid tank W=0.5 kW T2=35oC Heat loss =0 Cp= 4.184 kJ/kgK To…

Q: What size pump is needed to supply 10 gpm to a cylinder when the electric motor is rotating at 1725…

A: Given : V = 10gpm = 10 gallon per minute N = 1725 rpm = 1725 rev per minute

Q: Find the kinetic energy of a woman of mass 50,0 kg running at a speed of 8.70 m/s.

A: Given data : Mass m=50 kg Velocity V=8.70 m/s Required: Kinetic energy

Q: on a smooth surfac kg and then they - The energy loss č

Q: QUESTION 7 A pump discharges water at 4 m³/s through a pipe. If the pressure difference between the…

Q: Find the kinetic energy of car of mass 40 kg moving with velocity 22 m/s

A: Given data : Mass of car=m Velocity of car=V Required : Kinetic energy

Q: Given: Mass of toy car=2 kg Velocity=0.9 m/s Find kinetic energy

A: Given data : Mass of toy car=m Velocity of toy car=V Find : Kinetic energy

Q: the in internal and the h change energy

Q: 2. A fuel pump is delivering 10 gallons per minute of oil with a specific gravity of 0.83. The total…

Q: Q2 // A 30 cm diameter pipe, conveying water branches in to two pipes of diameter 20 cm and 15 cm…

A: Given Data Diameter of pipe = 30cm =0.30 m Velocity at inlet v1=2.5 m/s V2= 2m/s d2=0.2m d3=0.15…

Q: then find the average velocity of the spray

Q: Find the force if work done 600 J and displacement 10 m

A: Given data : Work done=W Displacement=d Required : Force

Q: Maria Cristina falls located at south has a height of 100 meters, it discharges at constant rate 2.5…

Q: A mass of a body is (3000 g) is falling of 15m. Find the potential energy after the body cutting…

A: Data given- H = 15 m h = 15-8 = 7 m m = 3000 g = 3 kg The total energy ( kinetic energy +…

Q: However a gas does a differential amount of work δWb as it forces the piston to move by a…

A: Given Cylinder with piston To find Verify the statement differential amount of work δWb as it forces…

Q: A pump lifts water at the rate of 6 m^3/s to a height of 120 m and the friction loss in the pipe is…

Q: em #19: A tank has the shape of a cylinder with height 4 m and base radius 2 m. It is filled with…

Q: The velocity of water in ft/s at the point of discharge is given by v = 12.88 P, where P is the…

A: Write the given expression. v = 12.88 P Differentiate the given expression with respect to the…

Q: Find: O m of steam (in kg/s) & to the heater (in kw).

A: Drawing the Ts diagram of the steam power plant, P1=9 MPa,T1=550 °C,P2=3.5 MPa,T2=400 °C,P3=3…

Q: 5.37 Find the horizontal and vertical forces to hold stationary the nozzle shown in Fig. P5.37. The…

A: Given, A1=1m2A2=0.25m2p2=patm=101kPap1=patm+30=101+30=131kPa Mass flow rate,…

Q: A pump is supplying water at the rate of 4ft^3/s it lifts water to a height of 15ft. Determinte the…

Q: Find kinetic energy Mass=2.1 kg Velocity=3.12 m/s

A: To Find : The kinetic energy of the particle. Given : The velocity is v=3.12 msec The mass is…

Q: Q2: A body (8 N) changes velocity from 5 m/sec to 7 m/sec, find the kinetic energy? *

Q: A certain fluid enters the system at 33 0 C. If temperature change of the inlet and outlet of system…

Q: Water with a mass rate of "M" continuously enters a tank with a diameter of "D". If a hole in the…

A: given; mass rate=M water entering diameter=D lets take height of tank=h diameter of bottom hole=d

Q: Q3. In Fig. 3 below, the pump move water from tank A to pressurized Tank B at rate of 100 m³ in 5…

A: Q: 3 From the given data;

Concept explainers

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.

Question

Not yet answered
سؤال 1
Marked out of 100.00
A closed reservoir filled by water, is under the pressure
of 49 KPa as shown in the Fig.1.
find the velocity of water (V) which leaves the reservoir.
P=49 KPa
3m
Fig.1

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1x

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

help me pls
A pipa transports gas up a hill. At the bottom of the hill, the maan valocity in the pipe is 10 m/sand the pressure is 200 Pa. The pipe lis then rals 10 m to the top of the hill, where the pressure is now measurad to be 30 Pa. Find the valocity at the top of the hiIL The density of the gas is 1.1 kg/m, and the acceleration dua to gravity is 3.81 m/s". P2 = 50 Pa U2 = ??? P, = 200 Pa Ah =10 m U1 = 10 m/s O. 9.53 m/s O b. 19.07 m/s O. 4.84 m/s O d. 13.29 m/s 177 m/s
A pump is working on these parameters 0.56 me/s with TDH of 63 meters. The pump efficiency is at 0.94% and the motor efficiency is at 0,89 %. What is the brake power in kW? Make your answer in whole number and choose the next whole number, say for example 25.2 kW it should be 26 kW.
Q1: Find the pump efficiency if the pressure difference across the pump is 230 kPa. If the outlet 2₁ 14 cm Z2 diameter of the pump is 7 cm, the inlet diameter is twice the outlet diameter. take the mass flow = 50 rate of the pump is equal to 50 kg/s 72. 1 Wate C the pump nmotor = 85 % Motor 20 W
Completely solve and box the final answers. Write legibly Brake Horsepower of Centrifugal Pump. Using Fig. 3.3-2 and a flowrate of 60gal/min, do as follows. a.Calculate the brake hp of the pump using water with a density of 62.4 lbm/ft3. (ans. 0.81 hp or 0.60 kW). Compare with the value from the curve. b.Do the same for a nonviscous liquid having a density of 0.85 g/cm3. (ans. 0.69 hp or 0.51 kW)
A fluid undergoes a non-flow frictionless process. Work is -156.2kJ. if V1=0.845m3 and the pressure varies as -730V + 700 kPa where volume is in m3. Find the final volume
Find the value of x for adaibatic process of air. P^x V = constant
Find the rate of change of hlt) (m) it water is the fluid with p= 1000 kglm
A certain fluid enters the system at 33 0 C. If temperature change of the inletand outlet of system is 182 0 F. Find the outlet temperature in 0 C.
A fan described in a manufacturer’s table is rated to deliver 500 m3/min at a static pressure of 254 cm of water when running at 257 rpm and requiring 3.6 kW. If the fan speed is changed to 516 rpm and air handled were at 65deg C instead of standard 21deg C, find the power in kW.
a. Given A Fan A with Power in Kw of 10.25 and Fan B with 12.75 kw. Speed of Fan B is 750 rpm, Find the Speed in rpm of Fan A. b. If Fan A and Fan B has the head pressure respectively equal to 22.125 and 38.925 cm of water, what is the new value of Fan A speed, if a 12% increase of that 750 rpm is the new value of Fan B.
A pump continuously transports water to an open tank for 12 hrs everyday. If the theo. horsepower for the process is 4hp (1 hp = 550 (ft∙lb_f)/s) and the pump is 65%efficient, What is the total monthly cos? Assume electricity costs 4.5 PESOS per kWh.