A chemist samples a river's water to measure the amount of fertilizer runoff from the area farms. In a 0.0775 L sample, the chemist measures 327 μg of nitrate. Express the concentration of nitrate in parts per million (ppm) and parts per billion (ppb). Assume the density of the river water sample is 1.00 g/mL. concentration: ______ppmppm concentration:_______ppb

Q: [References] Suppose you dilute 30.0 mL of a 0.100 M solution of Naz CO3 to exactly 100.0 mL. You…

A: Stock solution 1 Initial molarity (M1) = 0.100 M Initial volume (V1) = 30.0 ml

Q: Chemistry Convert the following airborne concentrations from ppm to mg/m3 at NTP. Please show the…

A: We have to convert ppm to mg/m3 1 ppm is also equal to 1 mg/L So the required conversion factors…

Q: The calibration curve was generated using known concentrations of five solutions of a newly…

A: The amount of a substance dissolved in a specified volume of the solvent produces a solution of a…

Q: Following the directions in the laboratory manual, you create Standard 2 by transferring the…

A: Calculate the total volume of mixture of solution in the test tube. i.e.…

Q: Table 8.7 (data)     HCI plug location 10   NH3 plug location 60   Deposit location 32…

A:

Q: How many milligrams of strontium carbonate, SrCO3, will dissolve in 4.000 L of deionized water at…

A:

Q: Activity 3 Direction: Match the following processes with their descriptions. 1. Storage a. Some…

A: General chemistry

Q: A chemist must prepare 925. mL of 435. mM aqueous aluminum sulfate (Al₂(SO4)3) working solution.…

A:

Q: You have a stock solution certified by a manufacturer to contain 175.0 z 0.3 wg SO;"/ml. You would…

A:

Q: If you have an empty burette in a burette clamp, in what order do you do these steps to fill the…

A: To fill an empty burette,we have to close the stopcock of burette. Then we should remove the burette…

Q: A student creates a calibration plot for serial dilutions of Cu(NO3)2. A graph of concentration in M…

A: (a) y = 0.345x -0.11 Absorbance = y = 0.655 0.655 = 0.345x -0.11 x = 2.22 M   (b) Molarity = Mass %…

Q: Pt(s) |X* (aq), x2* (aq) || Y3+ Given the line notation: (aq) || Y3+ (aq) |Y(s) where: x2+ . x* E° =…

A: Left side denote anode and oxidation takes place at anode. Right side denotes cathode and reduction…

Q: Sample Pretreatment on Calibration V Sample Problem: A water sample was tested for iron content, but…

A:

Q: A chemical factory has been illegally disposing their chemical wastes without necessary…

A: Given, Site                                   A                          B…

Q: A tank contains 60 kg of salt and 2000 L of water. A solution of a concentration 0.015 kg of salt…

A: Use of differential equation.

Q: A chemist makes 960. mL of potassium permanganate (KMNO,) working solution by adding distilled water…

A:

Q: 12.0−mL portion of 7.00 M stock solution is to be diluted to 0.300 M. What will be the final volume…

A: Molarity is defined as total number of solute present in 1000 ml of solution .   For neutralisation…

Q: Exploring the propitiates of gases experiment. Please show calculations. Volume (mL) Pressure (atm)…

A:

Q: In lab this week, assume you use a 25.00-ml volumetric pipet to transfer the standard red dye…

A: Volume of stock solution taken (V1) = 25 mL Volume of the solution made in volumetric flask (V2) =…

Q: You decide it is time to clean your pool since summer is quickly approaching. Your pool maintenance…

A: Given that : The concentration of chlorine (Cl2)= 4.08×10−5 M. The molar mass of chlorine (Cl2) is…

Q: You were asked to watch a video where a small amount of water was placed into a can on a hot plate.…

A: When a hot can containing water vapour is placed inverted in a cold water, the water vapour in the…

Q: The labware we used in Quant Lab is divided into “qualitative” or “quantitative” analytical purpose.…

A: 2ml of H2SO4 solution would be pipetted out into a flask to dissolve the copper oxide ore sample.…

Q: using the Kc equation and unit conversion answer this question A treatment wetland has an area of…

A: Given Details:                    Area = 1 hectare                    A = 104 m21 m3 = 103  litre⇒1…

Q: A student wants to determine how different factors affect the rate of dissolving a solid in water.…

A: With increasing in temperature,  particles are dissolved more rapidly due breaking of solute-solute…

Q: 2. Use the trendline equation from the calibration plot (that you wrote down in Table 2) to…

A: Solution: In colorimetry experiment we plot absorbance vs Concentration. we get a straight which…

Q: Predict what will be observed in each experiment below. predicted observation (choose one)…

A: Note: You have posted 2 questions at same time. But according to our guidelines I can solve only the…

Q: A 10 ml of concentrated acetic acid was added in a sufficient quantity of water to make 350 ml of…

A:

Q: A student prepares a 0.28 mM aqueous solution of acetic acid (CH,CO,H). Calculate the fraction of…

A:

Q: 7. What happens to the rate of reaction as you increase the surface area?

A:

Q: AI Review | Constants | Perie Calculate the final concentration of each of the following. Part B You…

A: The answer to the following question is-

Q: The following tabulated data is provided to answer this question and the remaining questions in the…

A: In a acid-base titration the end point is the neutralization point and at that point the no of moles…

Q: Which analytical separation method is best for recovering river bodies that are polluted by heavy…

A: Basically the river bodies are polluted by heavy metals like…

Q: Run 1 Volume of Vinegar 2.00 mL Used Concentration of NaOH Initial Buret reading Final Buret reading…

A: Stoichiometry, in balanced chemical reaction is defined by the ratio at which reactants are reacting…

Q: student creates a calibration plot for serial dilutions of Cu(NO3)2. A graph of concentration in M…

A: Introduction :  Percent error is an expression to let know the difference between calculated value…

Q: 4) But the real angler continues, regardless of the local sage. What sort of tone does the author…

A: The sort of tone does the author create by using the connotative effects of the word sage in…

Q: Table 1. Concentration of acetic acid in the vinegar sample Concentration of Volume of acetic acid…

A: The quantification of the amount of substance or analyte that is present in the solution is carried…

Q: A student prepares a stock solution of BaF2 by dissolving 50.00 g of a BaF2 in 1.00 L of water. An…

A:

Q: experiment A pair of 100 mL samples of water are taken from a well bored into a large underground…

A:

Q: a. Convert 52.6 mM (millimolar) to μM (micromolar) and to M (molar). b. Convert 200.0 μM to mM…

A:

Q: A bubble of air escaping from a diver’s mask rises from a depth of 124 ft to the surface where the…

A: Given, Depth of the driver"s mask = 124 ft surface pressure = 1.00 atm volume of bubble = 10.0 mL…

Q: What volume of 0.200 M K2C204 is required to react completely with 30.0 mL of 0.100 M Fe(NO3)3?…

A:

Q: A tank contains 90 kg of salt and 2000 L of water. A solution of a concentration 0.0225 kg of salt…

A: “Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Procedure it attached below, but question is in the screenshot.   Part A: Solution Preparation Work…

A: Since you have asked multiple question, we will solve the first question for you. If you want any…

Q: 8.If the label tells you to apply 3 ounces of Pesto 60 SP per 1,000 sq. ft. then how much would be…

A: Given that, Pesto 60 SP required per 1000 sq. ft = 3 ounces  To find: 1). Quantity of Pesto 60 SP…

Q: Which of the following describes a gradient elution process? O stationary phase has varying…

A: We have to describe a gradient elution process.  We know that in a gradient elution process, the…

Q: Convert the concentration of Cl2 to parts per million (ppm).

A: Convert molar concentration to grams per liter (Molarity x molecular mass of solute) concentration…

Q: Lab 1. Students study the reaction Znis) + 2 HCKaq) → Halg) + ZnCllag) In Trial 1 they use a single…

A: The principle applicable here is the rate of reaction will depend upon the surface area of the zinc…

Q: Use the following information to answer numerical-response question 14 and question 42. Arsenic…

A:

Q: 3. Calculate the concentration of Cl- in the 10mL unknown NaCl solution. The Ksp for Silver…

A: Answer is below

Q: alculate the concentration in ppm of Cd in a 2.00 mL sample which has been shown to contain 16.4 μg…

A: Solution stoichiometry involves the calculation of the concentration of solutions in the given…

Analytical Tools

Analytical tools or analysis tools help one to get into a conclusion or results from the data collected. Analytical tools can be applied for simple data sets and also in the case of big data analytics.