A 6-pole asynchronous motor operating is on a 60Hz network. What will be the rotor speed if slip is 3%?

Q: For an LTI discrete time system with the following impulse response h (n)= 8 (n-1)-28 (n-3) + 8(n-5)…

A:

Q: transformer has a rated output of 400 kVA at a power factor of 0.6. Determine the rated power output…

A:

Q: a. A current of 7.4 A flows through a conductor. Calculate how much charge passes through any…

A: The one coulomb of charge is the ratio of 1A of current passing through the conductor for 1 second.

Q: QI/A 4-pole, 1755 rpm, 60 Hz, 3-phase induction motor star has the following circuit model…

A: Given, Frequency f=60Hz, Poles P=4 Resistance R1=0.2Ω, R2=0.1Ω Reactance X1=0.5Ω, X2=0.2Ω Phase…

Q: In an AM transmitter and receiver, when a carrier signal has high frequency (2Vpk, and 20kHz)and…

A: Given: carrier signal has high frequency (2Vpk, and 20kHz) and with the information signal (1Vpk and…

Q: A 10-pole 3-phase induction motor supplied from a 380V, 50 Hz supply. If slip is 4% calculate: The…

A: Given a 3-phase induction motor with, Total number of pole, P=10. Supplied voltage, V=380 V.…

Q: Q5) [Book 1.1-7] Figure P1.1-7 shows a periodic 50% duty cycle dc-offset sawtooth wave x(t) with…

A: We need to find out the power for given signal

Q: The following table gives a set of 10 measurements that were recorded in the laboratory. Calculate…

A: We have been given 10 set of measurement of an instrument and we have been asked to find the…

Q: Determine the I.D.F.T of the signal X[eJw] which given by X[ew] = 1+2 cosw+ 3 Cos 2w

A:

Q: Use a Karnaugh map to simplify the following standard POS expression (X + Y + Z(X + Y + ZX + Y +…

A: The POS expression is the opposite expression to SOP form. The '0' can be placed for the given…

Q: Q) A 50 Hz transformer takes 80 W input at 1.5 A and 120 V. If the primary winding resistance is 0.5…

A: Given- 50 Hz transformer, Input power- Po=80 W,Io=1.5 A,V=120 V,R=0.5 Ω. To Find- No load factor.…

Q: Consider the linear dynamics. Let B₁ = A = SO 1-2 O O O 1-4 A For S=1 in A x= Ax+Bu where x EIR c)…

A: “Since you have posted a question with multiple sub-parts, we will solve first three subparts for…

Q: For the magnetic circuit shown, the air gap cross-sectional area is 0.004 m², the air gap length…

A:

Q: Example 2: For the lossless TL shown in below with le Zo/3 and ZR = 0 (short circuit load). Use…

A:

Q: A single-phase power line comprises two conductors each with a radius 8.0 mm and spaced 1.2 m apart…

A:

Q: 15 Referring to Fig. 59, determine the phase an- gle between the following phasors and, in each…

A: Phasor is the rotating vector used for the representation of the quantities such as voltage,…

Q: How do we increase or decrease the generated voltage output in the operation of a factory finished…

A: Basics An alternator or synchronous generator is a machine that is used for converting mechanical…

Q: E5.6 Use Thévenin’s theorem to find V, in the network in Fig. E5.6. 6 ΚΩ 2 ΚΩ ww Figure E5.6 ον(+ ww…

A: We need to find out the output voltage for given circuit

Q: 3.5 For each of the circuits shown in Fig. P3.3. a) find the equivalent resistance seen by the…

A: Since you have posted the multiple questions so we are supposed to answer the 1st one with all…

Q: Using physical equations, is the number of photons in one joule of red light greater than, equal to,…

A: Given that w have to compare that no of photons in one joule of red light is greater,lesser and…

Q: Q1- Design a voltage regulator that will maintain an output voltage of 20 V across a 1 K load with…

A: We need to design the regulator circuit .

Q: A transmission line has the following primary constants: resistance R = 15 /loop km, inductance L =…

A: According to the question, it is given that Resistance (R) = 15 Ω Inductance (L) = 3.4 mH…

Q: Calculate 12, 13, 17, V3, and V₁. 10 V 70 kn w V 20 kn - 1₂ 30 k 5 mA +

A:

Q: In the circuit shown in Figure, the switch S is closed at time t = 0. the voltage across the…

A: We need to find out the voltage across inductor

Q: The Fourier series coefficient of time domain signal x (t) is X[k] = jδ[k-1] – jδ[k+1] + δ[k+3] +…

A:

Q: How do we increase or decrease the generated voltage output in the operation of afactory finished…

A: It is asked to explain briefly that how to increase or decrease the generated voltage output in the…

Q: Q2. True or False Questions: 1. Hydrometeor Attenuation is a reduction in signal amplitude caused by…

A:

Q: 6. Calculate the flux in a 4-pole dynamo with 722 armature conductors generating 500 V when running…

A:

Q: Resistor networks have total re corresponds to the expression. RT=R₁+ (R₂ // ((R3 // R4) + (R5 // R6…

A:

Q: What is the equivalent resistance of the resistors between nodes a and bin Ohms? +1 a 3 Ω b Μ 4 Ω 6Ω

A: Given circuit:

Q: In the circuit shown in Figure, the switch S is closed at time t = 0. the voltage across the…

A:

Q: Q19) For the circuit shown in Fig. 11, the value of C needed to make the response underdamped with…

A:

Q: 3. Consider the following Boolean function: F = bcd + ābc + ābcd + bcd + ābc (a) Represent the…

A:

Q: Q2. True or False Questions: 1. One of the major propagation factors which can hinder space…

A: Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: Use ohm's and kirchhoff's law to find Vx, I input (Ient), and the power delivered by the dependent…

A: Given- Current source = 6 A Voltage across 2 ohm at node a = 2V Voltage across 2 ohm = 8 V To find-…

Q: Problem 3. Given a z transform X(2) = = 2-1 (1-z-¹) (1-1.42-¹ +0.482-2)' determine the initial and…

A: Given: Z transform X(Z) of a function x[n] To find: i) initial value of x[n] ii) final value of x[n]…

Q: Problem 6 For the following circuit, find the Thevenin equivalent resistance RTH looking into…

A:

Q: Find L-1

A:

Q: + B + C + D)(A + B + C + D)(A + B + C + D)(A + B + C + D)

A: Here the properties of POS have been discussed to solve it.

Q: Find the Fourier series coefficient of the signal y(t) = x(t-t0) + x(t+t0).

A:

Q: c) 7/4 L d) 5/8 L e) 4/7 L Q16) For the circuit shown in Fig. 10, the energy stored in the 4 mF…

A: We need to find out the energy stored by capacitor

Q: The variable resistor R in the circuit in (Figure 1) is adjusted until va equals 50 V. Suppose that…

A:

Q: Q5/Chose the correct data input for 2-1 multiplexer that used to Design the * (switching network F…

A:

Q: Problem 7 For the amplifier circuit shown, find the voltage gain A = Vo/Vs. Rs V. TB BIZ RE + V₂ Rc

A:

Q: If a problem refers to "unity feedback" configuration, it means: W(s) R(s) + E(s) D(s) U(s) + G(s)…

A:

Q: 5. Using mesh analysis, solve for is. Iz, is. io 135 V + 32 W 202 www 50 www 20.0 40 www 101 10 in

A:

Q: References: at least 2 reliable sources. ii) Calculations Part A: AC CIRCUIT AND IMPEDANCES For this…

A:

Q: List 6 parts of Multimeter including each corresponding function.

A: Multimeter parts and its function.

Q: Apply DeMorgan's theorem to the expression X + Y + Z. Apply DeMorgan's theorem to the expression…

A:

Q: A system is shown in Fig. Q2. Calculate the values of K and T for 2 seconds of peak time and 10%…

A:

Winding and Constructions

Alternating Current (AC) winding is generally of the 3-phase type due to the inherent advantages of the 3-phase machine. Armature coils must be connected to the yield balance (equivalent in magnitude and 2/3 of the series phase difference of the rod) 3-phase electromotive forces (emf). The armature should be divided into step-bands to start with slots around the perimeter.In the construction of AC machines, the frame is used as an external protective shield to protect it from environmental conditions. The frame also serves as the outer perimeter, allowing the interior to be easily placed. The static state section of the devices is the stator winding attached stator.