A 12-ohm resistor is connected in parallel with a series combination of 8-ohm and 16-ohm resistors. If the voltage across the 8-ohm resistor is 48-volts, calculate the (a) total resistance, (b) total supply voltage, and (c) circuit current
Q: The plans show curved lines running between switches and various outlets. What does this means
A: The plans show curved line running between switches and various outlets enhances to differentiate…
Q: If the voltage divider (b) in the previous question is connected to the voltage divider (a) by means…
A: Given : Brief description: In the above given question they have mentioned an electrical circuit…
Q: Describe circuit's every working procedure and describe all equipment and function according to the…
A: Working procedure,equipment and function of OP275 Low pass filter design circuit:
Q: Three resistors are connected in series across a 12-volt battery course. It has found to be that the…
A: Given, three resistors are connected in series across a 12-volt battery, Let, R1, R2 and R3 be…
Q: Three 120-ohm resistors are to be connected in four possible ways. Calculate the equivalent…
A:
Q: d.1. What are the two concepts that make up grounding in its simplest form? A. Impedance and…
A: Grounding : connecting high voltage device intentionally to the group using conductor this called…
Q: 5) The Murray Loop Test figuer shown below is used to locate ground fault in a telephone…
A: Solution- Murray loop test, R = R1+R2 = 600 Ω R3 = 2 kΩ = 2000 Ω R4 = 1 kΩ R1 =RR3R3+R4 =…
Q: If E1= 27 Volts ,E2= 3 Volts ,and E3= 23 Volts, calculate the values of the indicated currents using…
A: In the question, If E1= 27 Volts ,E2= 3 Volts ,and E3= 23 Volts, calculate the values of the…
Q: How does voltage divide in a series circuit?
A: As per our guidelines, we are supposed to answer only one question. Kindly repost other questions as…
Q: A DC is supplied through a solid conductor cable. The fault in the cable can be determined by using…
A:
Q: Four wires of equal length and of resistances 10 ohms each are connected in the form of a square.…
A: Given: Four wires of equal length and resistances R=10 Ω each are connected in form of squares. So…
Q: 5. Three resistors A, B and C are connected in series to a 134-volt dc source. If the resistance at…
A: The obstruction offered to the flow of current is called resistance. The electrical component that…
Q: If the cable in Figure ran for the whole of its length, grouped with others of the same size in a…
A: Ambient temperature – The standard or reference temperature for the installation of cables is…
Q: If the voltage divider (b) in the previous question is connected to the voltage divider (a) by means…
A: Here we can use kirchauff voltage law to find I and vout
Q: 1. At which end of the. scale are resistance readings more reliable, the crowded or the uncrowded…
A: We are authorized to answer one question at a time, since you have not mentioned which question you…
Q: With diagrams, explain what a wiring, schematic and line diagrams are for a single line…
A: According to the question, we have to explain with diagram. what a wiring, schematic and line…
Q: The common grounding electrode conductor installed for multiple separately derived systems shall be…
A: The metal water pipe compiles with 250.68(C)(1) the main reason behind this is that the wire in this…
Q: |(3-2) Describe the operation of Circuit A. What is the function accomplished? (3-b) Determine the…
A: It is given that : VZ=6.8 V IZmin=2mA Vin=12±1 Volts ILmax=90 mA ILmin=10 mA
Q: A 12-ohm resistor is connected in parallel with a series combination of resistors of 8 and 16 ohms.…
A:
Q: 2. An Electrical heating pad rated 110v and 55 W is to be used at a 110 Volt source. It is to be…
A: In this question 5 electric bulbs are connected in parallel....We have to find out current flowing…
Q: A 12-ohm resistor is connected in parallel with a series combination of 8-ohm and 16-ohm resistors.…
A:
Q: 1. At which end of the scale are resistance readings more reliable, the crowded or the uncrowded…
A: Resistance measurement is an important measurement that a multimeter may do. Not only may resistance…
Q: 4. Electrical systems can be designed to perform a variety of tasks, using series, parallel, or…
A:
Q: Replicate the following circuit showing where each pin should be connected using a breadboard…
A: This is made up of components such as an LDR, a variable resistor, a capacitor, a transistor, and a…
Q: Using Superposition Method. Determine the voltages at the 5-ohm resistor due to the 24-Volt, 38-Volt…
A:
Q: A 10Ω- and 15Ω- resistor are in parallel across a dc voltage source. If the 10Ω- resistor has a…
A: In Parallel combination, voltage of each branch would be same. So voltage across source and…
Q: A light bulb is rated for 120 volts and 60 watts (it means that the light bulb dissipates 60 watts…
A: In this question we need to find a power dissipated in each bulb when two similar bulb having rating…
Q: b. You have been contracted to design and implement a Christmas Tree Lights for Kwame Nkrumah…
A: The total number of lamps is 1500, since the lamps are similar, the resistance of each lamp will be…
Q: resistance R of the unknown.
A:
Q: Part 2- Problems Show formulas and substitution. 1. How much power is consumed by a 12-ohm toaster…
A: As per our policy, i have attempted 1 question Given V=120 voltsR=12 ohm Calculating power…
Q: How do the voltage drops in a series circuit compare to the supply voltage?
A:
Q: A three pole contractor would allow how many paths for current allow ?
A: The path allowed for the passing of the current by the three pole contractor are four.
Q: The short-circuit and open-circuit tests were performed high-voltage rating of 7600 volts and…
A:
Q: Three resistors A, B and Care connected in series to a 126-volt dc source. If the resistance at A is…
A: The solution can be achieved as follows.
Q: 7. A 12-ohms resistor is connected in parallel with a series combination of 8 and 16-ohms. If the…
A: Given R1 =12 ΏR2 =8 ΏR3 =16 ΏReq =R1∥R2+R3 Voltage drop across 9 ohm resistance is 48 V
Q: Based on the Pictorial Diagram below. One lamp controlled by two 3- way switches in different…
A: To draw electrical wiring diagram showing one lamp controlled by two three way switches
Q: Two fixed type resistors, 5 ohms and 7.5 ohms are connected in series. If a 12 volt battery is…
A:
Q: A 10-ohm and20-ohm resistance are connected in parallel. An other resistance of 5-ohm is connected…
A: based on given information draw the circuit then apply nodal analysis to find the node voltage .…
Q: How much power is dissipated by a dc circuit with a resistance of 80 ohms if the across the circuit…
A: The power dissipated in a dc circuit =V.V/R or…
Q: What is the maximum size Grounding Electrode Conductor regardless of the size of the
A: In this we will write about the maximum size Grounding Electrode Conductor regardless of the size of…
Q: Determine the total current flow in a lamp having 220 volt current supply, a fan of 240 volt supply…
A:
Q: 7.C. Which of the following statements about bonding is true? A. The joint or termination must…
A: 7.C. Which of the following statements about bonding is true? Article 100 of the NEC defines…
Q: 4. Suppose in procedure step 7 that R3 developed a short-circuited condition. How would the current…
A: The explanation is as follows.
Q: Kirchhoff loop for the bottom loop of the diagram.
A:
Q: The total resistance of a three series circuit is 25 ohms. Resistor 1 is 6 ohms and has 18 Volts…
A: Given data: Three series connected resistors with RT=25 ΩR1=6 ΩVR1=18 VVR3=12 V
Q: What is the current flowing on the 9-ohm resistor if the source voltage is placed at 16 volts?…
A: In this question first we will find equivalent resistance across ab then total current and will find…
Q: In a 3-phase, 4-wire, 400/230 V system, a lamp of 200 watts is connected to one phase and neutral…
A: We have a 3-phase 3-wire system in which 2 lamps are connected between 2 phase and neutral . We have…
A 12-ohm resistor is connected in parallel with a series combination of 8-ohm
and 16-ohm resistors. If the voltage across the 8-ohm resistor is 48-volts,
calculate the (a) total resistance, (b) total supply voltage, and (c) circuit current.
Step by step
Solved in 2 steps with 1 images
- Three types of electric devices A, B, and C are connected in series across a 115-volt ac source, and the voltage drops across the individual units are equal. If EB leads EA by 90 elec deg and EC lags behind EA by 90 elec deg, what are the emfs across A, B, and C?Two resistances of 10 and 15 ohms each respectively are connected in parallel. The two are then connected in series with a 5 ohm resistance. With 25 volts supply for the entire circuit. a. What is the equivalent resistance? b. Power at 15-ohm resistance.State the characteristics of voltage and current in a series circuit connection of resistors. State the characteristics of voltage and current in a parallel circuit connection of resistors. please explain it properly.
- Two heating units A and B are connected parallel across a 240-volt supply. Unit B takes thrre-times as much power in A, and the total power is 2400 Watts. Determine resistances of A and B.There are three 15,000-ohm resistors connected in series across a 120-volt DC source. What is the voltage distribution across each resistor? What would be the voltage reading across the first resistor if a 0-120 volt meter with a 100-ohm per volt sensitivity is used? What would be the voltage reading across the first resistor if a 0-120 volt meter with a 10,000 ohm per volt sensitivity is used?Three types of electric device A,B, and C are connected in series across a 115-volt a-c source, and the voltage drops across the individual units are equal. If Eb leads EA by 90 elec deg and Ec lags behind by 90 elec deg, what are the emds across A,B,C? Ans: EA = EB = EC = 115 Volts
- For the circuit below, determine the resistor voltage. The source is 6 volts, the Zener potential is 5.1 volts and the resistor is 1k.R1 of 90 kilo ohm and R2 of 10 kilo ohm are in series across a 43-volt source. A) Draw the schematic diagram. B) What is the voltage drop at R2?Please kindly help me to answer this question. Please provide all the solutions, givens, and formulas used. Thank you very much! The exciting current of an electromagnet is rated at 12 amperes. When connected across a 122 - volt source the current is 14 amperes. Determine the ohms in a resistor which must be connected in series to limit the current to (a) rated value, and (b) 9 amperes.
- three type of electric device A, B, and C are connected in series across a 115 volt AC source, and the voltage drops across the individual units are equal. if EB leads EA by 90 elec deg and EC lags behind EA by 90 elec deg, what are the emfs across A, B, and C?5. What is the resistance of a copper bus-bar with the dimensions shown figure below.Determine the voltage across resistor R2. (assume Zener voltage is 3 volts)