8. For each row in Table 1, use the Comment column to describe the action taken for each instruction. Determine the values for the below assembly code block; provide the final values for each register listed in Table 2. Table 1 Instruction Register mov mov mov and xor al Table 2 dl al, 11 dl, 13 cl, al al, dl Register Final Value dl, cl Comment

8. For each row in Table 1, use the Comment column to describe the action taken for each instruction. Determine the values for the below assembly code block; provide the final values for each register listed in Table 2. Table 1 Instruction Register mov mov mov and xor al Table 2 dl al, 11 dl, 13 cl, al al, dl Register Final Value dl, cl Comment

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

Create a HDL model of the Instruction Register component for a Simple-as-Possible (SAP) Computer. Show the VHDL model and testbench codes.
Describe the SBB instruction in further detail.
Derive the micro-operations and respective control signals in the same fashion as Table for the processor in Figure for the instruction thati- adds Accumulator to MBR.ii- Loads M(X) to Accumulator
Select all of the registers listed below that are changed during EVALUATE ADDRESS phase of an LC-3 LDR instruction. Select NONE if none of the listed registers are changed. - MAR - DST register - PC - IR - MDR - NONE
For the Z80 instruction LD (28) BC ED43001C, Where is the Op-Code field in the instruction?
For each LEGv8 instruction in Exercise 2.9, show the value of the opcode (Op), source register (R_n), and target register (Rd or Rt) fields. For the I-type instructions, shown the value of the immediate field, and for the R-type instructions, show the value of the second source register (Rm). ADDI X9, X6, #8 ADD, X10, X6, XZR STUR X10, [X9, #0] LDUR X9, [X9, #0] ADD X0, X9, X10
Show the assembly instruction for the following machine code, given in hexadecimal. Explain all fields in detail. 03A2F023
Write the appropriate labels for the instruction cycle state diagram provided below:
For the MIPS instruction bne $s6,$t2,-31406, show the immediate number, opcode, rs, and rt in binary in the given order, separated by comma.
For each of the following sets of RISC-V assembly instructions below, identify any data hazards that occur and indicate which type (i.e., EX hazard 1a or 1b, MEM hazard 2a or 2b, or load-use hazard) of hazard has occurred. You can specify where the hazard has occurred by indicating which instruction (i.e., the first instruction, second instruction, etc.) will experience the hazard. x11, 0(x6) x12, 8(x6) add x20, x11, x12 x20, 0(x6) x13, 16(x6) add x20, x20, x13 x20, 8(x6) ld ld sd ld sd
Derive the machine code representation for the instruction blt r7, r8, LOOP for an Altera Nios II Soft Processor.
Draw the timing diagram for MARIE’s Subt instruction using the format of Figure 4.16.