17.b. Which of the following is the best example of a building supplied by a single branch circuit? A. A detached carport with no doors, walls, or windows B. A detached garage at a dwelling occupancy C. A ground-mounted air conditioner D. A university dormitory

17.b. Which of the following is the best example of a building supplied by a single branch circuit? A. A detached carport with no doors, walls, or windows B. A detached garage at a dwelling occupancy C. A ground-mounted air conditioner D. A university dormitory

EBK ELECTRICAL WIRING RESIDENTIAL

19th Edition

ISBN:9781337516549

Author:Simmons

Publisher:Simmons

Chapter15: Dryer Outlet, Lighting, And Receptacle Circuits For The Laundry, Powder Room, Rear Entry Hall,and Attic

Section: Chapter Questions

Problem 18R: A residential air-conditioning unit is installed in the attic. a. Is a lighting outlet required?...

See similar textbooks

Related questions

Q: Q1: In a given application and when a box passes In front of photo type proximity switch, it is…

A: To design the system as per application given. Plc ladder diagram is used for the application

Q: What is the load for 100 15A/20A, 125v duplex receptacles in a non-dwelling occupancy after applying…

A: NEC Table 220.44 gives demand factor for Non Dwelling receptacle.

Q: A residential service entrance load calculation is required to correctly size which of the…

Q: Which of the following would be one of the first checks made by a technician when troubleshooting a…

A: Need to talk about troubleshooting of a small.residential condensing unit

Q: Does the NEC make suggestions about how to wire a house that will be occupied by handicapped…

A: The NEC is the electrical code that is accepted by everyone belongs to the electrical industry. NEC…

Q: 17. In an air compressor system, the distribution piping can be bonded using the A. equipment…

A: Dear student as per our guidelines we are supposed to solve only one question.kindly repost other…

Q: Which of the device number used to show the directional power relay in drawings of power system…

A: Directional power Relay operates when power in the circuit operates in the specific direction

Q: 13.A. Which of the following is effective when it comes to establishing a bonding connection between…

A: “Since you have asked multiple questions, we will solve the first question for you. If youwant any…

Q: 1-DO you need a repeater station if we used optical cable under the sea level? And why?

A: If we used optical cable under sea level then there is a chance that it lose or reduce its signal.…

Q: Identify the mistakes in the pictures. Explain.

A: Every electrical equipment and devices are represented by the symbols for easy to understandable and…

Q: draw a block diagram of the jumpers connected to the front panel of a computer system unit

Q: Airframe Electrical System Question: What things should be included in the identification stamp…

A: The things that should be included in the identification stamp found along the electrical wires…

Q: Attach the proper eve

Q: Which of the following would help avoid the choke effect in grounding electrode conductors? A.…

A: The correct option is B that us using an appropriate PVC(POLY VINY CHLORIDE) CONDUIT WILL AVOID…

Q: When the nameplate of HVAC equipment is marked “Maximum Size Fuse—50 Amperes,” is it permitted to…

A: The device that have the maximum size are generally air conditioner and the refrigerator have the…

Q: When installing ceiling-suspended (paddle) fans, per the requirements found in NEC 314.27(C) and NEC…

A: The National Electrical Code (NEC) is a regionally adoptable standard for the safe installation of…

Q: - The figure below shows the structure of which busbar? If CBF has occurred, please explain how many…

Q: draw a schematic diagram of the jumpers connected to the front panel of a computer system unit.

A: Jumpers allow the computer to shut down the electrical circuit, allowing electricity to flow to…

Q: An eighteen-unit multifamily dwelling contains the following appliances in each unit : a 1-kVA,…

A: Service neutral load contribution- The amount of power required by the combination of multiple…

Q: Which of the device number used to show the directional power relay in drawings of power system…

A: 32 - Directional Power Relay 21 - Distance Relay 59 - Overvoltage Relay 52 - AC Circuit Breaker

Q: Assume that you just got out of an aeroplane and you switched on your cell phone. If the closest BS…

A: Given data, The value of the distance is 5km.

Q: 14.a. Section 250.94 requires that an IBT be accessible for inspection and termination and have the…

A: 14.a. IBT stands for Intersystem Bonding Terminal. According to NEC Section 250.94 (B) An IBT be…

Q: mast-type service entrance

A: The service raceway according to NEC is defined as an enclosed channel specially designed to hold…

Q: A passenger arriving in a new town wishes to go from the station to a hotel located 10km away on a…

A: Given that Distance from station to hotel is 10 km Distance travelled is 23 km Time taken to…

Q: 11. Which of the following is the drawback for cordless telephones? a) Security b) Wireless…

A: The correct option along with the explanation is provided in the following section.

Q: В С 1 Station A Problems with electricity supplied Computer malfunction Malfunctioning electrical…

A: Solution

Q: In a residential air conditioning system,how are the outdoor fan and compressor wired with the…

Q: Which of the following is a term missing from the National Electrical Code but used by manufacturers…

A: ANSWER (1) Grounding Triad is the term which is missing in NATIONAL…

Q: Which of the following is not a control system? Select the correct answer below: A. Home PC B.…

A: Control system- A control system is basically the interconnection or arrangement of various devices…

Q: Connections from headers to cabinets and other enclosures, in cellular concrete floor raceways,…

A: To explain the means of connection made from header to cabinets and other enclosures, in cellular…

Q: 13.C. What is the most common grounding electrode used to connect utility service equipment to…

A: 13.C. What is the most common grounding electrode used to connect utility service equipment to…

Q: List the minimum service drop clearances required by the NEC in the following residential…

A: The minimum service drop clearance required by the NEC (120 V/240 V) for the following residential…

Q: Write down three situational questions and behavioral questions each to be asked while interviewing…

A: Write down three situational questions and behavioral questions each to be asked while…

Q: 1. A 208Y/120-volt feeder in a commercial building supplies lighting and receptacle loads as well as…

A: Here in this Q. the calculations of load of the motor in VA is to be done.

Q: How are occupants alerted to the presence of carbon monoxide and natural and propane gas

Q: 1. What motor is used in the washing machines? Explain in detail the construction and working of the…

A: Motor used in the washing machine is Universal motor. The universal motor is an…

Q: Answer the Following questions: 1- Draw wiring diagram of domestic refrigerator, showing the main…

A: We are authorized to answer one question at a time, since you have not mentioned which question you…

Q: Q1: In a given application and when a box passes In front of photo type proximity switch, it is…

A: For the given application, Electrical relay circuit or plc ladder diagram can be used

Q: 11.a. Which of the following is a point where a grounding electrode conductor connection must be…

A: Answer 11 (a) : According to national electrical code 250-(96), Grounding electrode conductor…

Q: Is it okay to use a cable tray for the horizontal path of telephone lines to their specific outlets?…

A: EMT conduit size (inch) Number of cable 1 4 1-1/4 6 1-1/2 8 2 14 2-1/2 17

Q: Can I use a distribution box on every floor to distribute telephone lines to their designated…

A: A message signal has to be transmitted from the sender end to the receiver end. They are transmitted…

Q: 18. How many electric meters are provided for this residence?

A: As per the bartleby rule you can ask only one question at a time so please ask other question…

Q: draw a pictorial/wiring diagram of the jumpers connected to the front panel of a computer system…

A: The Front Panel Connections, also known as the Front Panel Header or FPanel, are a collection of…

Q: Draw the block diagram of staircase ramp type digita oitmeter and explain the same.

A: consider the given question;

Concept explainers

Methods of Wiring

Electrical wiring is the way of integrating cables and wires to interconnected equipment such as fuses, switches, sockets, lights, fans, and so on to the main distribution board, which is a specific structure attached to the utility pole that ensures a constant power supply.

Question

17.b. Which of the following is the best example of a building supplied by a single branch circuit?
A. A detached carport with no doors, walls, or windows
B. A detached garage at a dwelling occupancy
C. A ground-mounted air conditioner
D. A university dormitory

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

17.a. How many system conductors are in a high-leg delta system?A. FourB. ThreeC. TwoD. One17.b. Which of the following is the best example of a building supplied by a single branch circuit?A. A detached carport with no doors, walls, or windowsB. A detached garage at a dwelling occupancyC. A ground-mounted air conditionerD. A university dormitory
grounding and bonding requirements 17. Which of the following is effective when it comes to establishing a bonding connection between a fitting or a raceway and an enclosure? A. Meter enclosures B. Bonded bushings C. Bonding wedge D. Threaded hubs 18. Which of the following is the first line of defense for a premises wiring system served by a grounded utility source? A. The system grounding connection B. The pad-mounted transformer C. The load side of the service point D. The service equipment enclosure
11.a. Which of the following is a point where a grounding electrode conductor connection must be made inthe communication system?A. The flexible nonmetallic power service racewayB. The grounding electrode conductor or metal enclosure for a grounding electrode conductorC. The space opposite the service equipment enclosureD. The grounded exterior metal water piping system within six feet of the point where it enters the building11.b. The equipment grounding conductor of a pump motor for a swimming pool must be grounded with asolid copper conductor that's no smaller thanA. AWG 8.B. AWG 12.C. AWG 10.D. AWG 6.
1 .Which one of the following component is the heart of the excitation system?. a. Resistor B. Voltage Transformer C. Current Transformer D. Voltage Regulator
Part 2: Analysis and selection of the Wind Turbine.The team decides at install a 30 MW wind farm. The turbine that has been selected by the local contractor is an Enercon wind turbine. The specifications of all the available Enercon wind turbine is shown in the attached datasheet. 1. What are the two closed loop control systems that are used generally in wind turbines? How do they work? 2. Calculate the power density of the input power from the wind when the wind is blowing at the rated wind speed at the turbine height. Clearly show your steps in details.
D.a. Which one of the following PM programs is usually the largest for a typical manufacturing facility?A. LubricationB. ElectronicC. ElectricalD. MechanicalD.b. The true purpose of uptime inspection PM is toA. keep the PM staff working during low maintenance periods.B. locate problems that occur on a random basis.C. supplement the lubrication PMs in looking for dry bearings and other lubrication problems.D. look for common recurring problems in equipment. D.c. When machines fail shortly after they’ve been built and installed, the failures are termedA. singularity failures.B. independent component failures.C. short-term failures.D. infant mortality failures.
19.a. The easiest place to install an ammeter into a stepper motor driver/motor circuit for system diagnosticsis toA. remove a fuse and place the meter leads across the fuse clips.B. connect the meter across the center tap and phase leads of the motor.C. attach the meter in series with the driver’s power supply lead.D. disconnect a motor lead and attach the meter in series with that lead.19.b. A servo system is oscillating at standstill. This is an indication thatA. the system gain is too high.B. a driver fuse is blown.C. the following error limit has been exceeded.D. a motor winding is open.
F.a-The best method of performing pneumatic system inspection is with a(n)A. ultrasonic listening device.B. vibration listening device.C. screwdriver to your ear.D. careful eye on system operation.F.b- What type of seal system is constructed of a hard brittle material and is often used in a pump to sealbetween the pump and the motor?A. SteelB. FiberglassC. CeramicD. GlassF.c- When a pneumatic solenoid fails, the failure is normally due to aA. weak pilot.B. bad spool.C. ripped seal.D. faulty coil.
10. You're going to connect a surge protection device to a separately derived electrical system. In thissituation, the surge protection device should be connected atA. the load side of the first overcurrent protection device.B. the first connected IT cabinet.C. the end of the shortest branch circuit.D. the input to the transformer's primary winding.
For motor Branch circuits, the maximum setting of a conventional inverse - time circuit breaker must not exceed____of the full- load current of the motor. a.100% b.125% c.200% d.250%
[Fill-in-the-blank] in dwelling units shall supply only loads within that dwelling unit or no loads associated only with that dwelling unit. Select one: a. None of these b. Ground-fault protection c. Service-entrance conductors d. Branch circuits
13.A. Which of the following is effective when it comes to establishing a bonding connection between a fittingor a raceway and an enclosure?A. Threaded hubsB. Bonded bushingsC. Meter enclosuresD. Bonding wedge13.B. The amount of fault current that bonding connections have to endure is related to which of thefollowing?A. The quality of the fittings that were chosen for the systemB. The amount of available fault current delivered by the system or utilityC. The type of equipment and the location in the systemD. The number of connections that are part of the listed assembly13.C. What is the most common grounding electrode used to connect utility service equipment to Earth?A. Ground rodB. PipeC. PlateD. Ground ring