Answered: 11. Find the magnetic flux density when…

11. Find the magnetic flux density when a flux is equal to 28 x 108 Maxwell is enclosed in an area of 15 cm². a. 18.6667 kWb m' b. 186.6667: kWb C. 1.8667. m kWb d. 0.1867 m² kWb m²

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: For the following magnetic circuit, the flux passing through the cast iron core is 0.45 mWb. If the…

Q: (6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 ΤΩ 4Ω ΜΕ 34 16Ω Figure 6 5Ω 12 V 10 Ω

A: In this question we will find output voltage using Norton theorem....

Q: . A load rated at 115V, 60Hz, 10A and 1150W. A coil is to be wound with a ratio of XL to R of 5,…

Q: Q2: A JFET has parameters of Vp6V and loss - 3mA. Plot the transconductance curve for the devic…

Q: A PV system uses 720 silicon PV cells connected in an array which supplies up to 120 V. .How many PV…

A: Given, A PV system uses N=720 silicon PV cells. Total supplied voltage, Vs=120 V One cell delivers,…

Q: The circuit below is operating in the sinusoidal steady state. Find the steady-state expression for…

A: Given data, vg(t)=60sin(8000t)VInductor (L)=3.125mHResistance (R)=50Ω

Q: The voltage range of the following potentiometer is R1 5 ΚΩ LE R2 10 ΚΩ 120 V (0-120) V (0-10) V O…

A: The circuit can draw as below Potentiometer will measure maximum voltage if jockey is connected at…

Q: Design a lattice-type balanced modulator.

A: A balanced modulator suppresses the carrier and outputs only the sum and difference frequencies.…

Q: A dc separate excited generator operate at speed = 1500 R.P.M at a certain excitation gives a…

A: Given data, A dc separate excited generator, Case1) Operated speed = 1500 R.P.M at a certain…

Q: Q1b) Application of Mesh Analysis - No simplification needed a) Write V, in terms of mesh currents…

A: using mesh analysis 4 sub part of question is solve as

Q: 9. Consider the circuit in Figure 4. (a) What type of circuit is this? (b) What is the total peak…

A: Since you have posted a question with multiple sub-parts, we will solve the first three sub-parts…

Q: Consider the circuit shown in the figure. A Q-point value for Ic between a minimum of 4 mA and a…

A: Given A transistor biasing circuit and it's range of operating point and collector current.we need…

Q: For the circuit of the following figure: Find the total admittance Y-T Find the voltages V ̅1 and V…

Q: A single phase 220/6 Volt, 50 Hz transformer has a rated primary current = 0.5 A. its maximum…

A: In this question we need to find a efficiency of the given transformer

Q: Me + 40 Ω 25 nF 80 με 60 Ω

Q: Q4) For the circuit in Fig. 4, use nodal analysis to obtain i₁, ₂ and i

A: In this questions, we need to calculate the given current by nodal analysis. The given circuit is

Q: For a FET will maximum current. 3 Iflows if Vgs Ov and Vds >= |Vp False O True

A: One of the most basic varieties of the field-effect transistor is the JFET or Junction Field Effect…

Q: The voltages developed across the 3 and 2 resistors shown in the Fig.2 are 6V and 2V respectively,…

Q: 5. Find the total impedance in rectangular form for the following three series impedances. 12 ohms…

Q: After plotting the Boolean function A(w,x,y,z) = A(w,x,y.x)=∑ m (0,1,3,4,5,6,7,8,9,10,11,13,14,15)…

Q: 2. Power calculation In the following circuit element, it is known that Vab-10V, lab=-5A. Does the…

A: Given:

Q: Assume a Thevenin equivalent circuit with E = 10V, Z = 5.1 K02-11.31, Find Inorton and Znorton…

A: Given a Thevenin equivalent circuit, Thevenin voltage, Eth=10 V Thevenin impedance, Zth=5.1∠-11.31…

Q: In the semiconductors materials, a ---narrow band gap is 2 ev O Less than 2eV O Large than 2ev O 3…

A: A type of electronic device components that designed, manufactured and developed known as a…

Q: 1- Give the transfer function of the system E₁ (s) 2- The close loop transfer function of the system…

A: Note : According to the student interest they are asking to solve only question number 3 hence we…

Q: (6) Apply Norton's theorem to find Vo in the circuit of Fig. 6 4Ω ΤΩ 3A Μ 16Ω Figure 6 5Ω 12 V 10 Ω

A: We need to find out norton equivalent circuit for given circuit then we need to find output voltage…

Q: 17. The representation of the inductive and capacitive reactance in a given AC circuit

Q: Q4: Answer the following, choose A or B A. For the following circuit, Determine the value of the…

Q: The peak inverse voltage in bridge rectifier of the diodes is reduced from 2Vm to Vm ODuring…

A: Diode: It is a semiconductor device and this is unidirectional because it flows the current when it…

Q: Q2) The switch opens at t = 0 after a very long time. Find v(t) for t> 0. Draw circuits clearly for…

A: given here a transient analysis circuit and asked to find the voltage across the capator.

Q: Q3) Define the return loss of a microwave circuit in terms of the reflection coefficient and the…

A: Given: Return Loss =18 dB Required: (A) The reflection coefficient Γ (B) The…

Q: 8. The maximum instantaneous voltage output is 300V while the current output is 20A.What is the…

A: The power can be calculated by converting the instantaneous value into RMS value and then use the…

Q: Correct any five of the following sentences using At star connection when neutral current isn't…

A: 1) ANSWER- At star connection when neutral current isn't equal to zero the system is Unbalanced.…

Q: Find the Fourier Series for the following common repetitive waveforms. a. Half-wave rectified sine…

A: Since you have posted multiple different question. we will solve the first question for you. To get…

Q: In the circuit shown in Fig.4. Find the value of voltage across the terminal ab.

A: Use KCL to find current I1 and current 2 ohms resistor. Now apply KVL in top right loop to find…

Q: The rotating magnetic field cannot be obtained from a single-phase source but rather from a…

A: Note: As per the policy we can solve only one question please re-upload the remaining question as a…

Q: Q1d) Find , and 4, in the circuit given. Use KCL and ohms law only to solve 0.54 3A

A: Kirchhoff’s Current Law- KCL, states that “The algebraic sum of all currents entering and exiting a…

Q: The dc motor has maximum current at start because: O The back emf is maximum. OThe back emf is zero.

A: here we have to find why the dc motor has maximum current at the start.

Q: 23. Determine the potential difference across a 4µF capacitor when charged with 5 mC. a. 1250 kV b.…

A: In this question we need to choose a correct option.

Q: ind the maximum power transferred to resistor R in the following circui

A: To solve above problem one should have idea about maximum power transfer theorem : Maximum power…

Q: The reading of the following voltmeter is

A: Since internal resistance of the voltmeter is very high. So no current will flow in the given…

Q: QUESTION 4 b) The magnitude plot of a transfer function G(s) = (1+s/8X1+bsX1+ s/36) K(1+0.55X1+as)…

A: For the given bode plot we need to calculate the values of all the unknowns from the given transfer…

Q: 10. At star connection unbalanced load system the neutral current is. c. less than zero b. greater…

A: For a balanced load system, the neutral current is zero. As the load system is unbalanced, the…

Q: 04: For the admittance locus diagram shown beside: 1. Draw the electric circuit. 2. Find the value…

Q: A series circuit consists of a 20-ohm resistance, a 150 mH inductance and an unknown capacitance.…

A: A series circuit consists of a 20-ohm resistance, a 150 mH inductance and an unknown capacitance.…

Q: Q2) For the network of Figure below, determine a. IBQ b. VCEQ c. VE, Vc and VB www 62 ΚΩ 16 V VB 1BQ…

A: In this question we will find unknown currents and voltages for given voltage divider configuration…

Q: The maximum efficiency for pure inductance load and iron-losses = cupper losses is zero. O True O…

A: Given data, For Pure inductive load , Resistance = 0. Given, iron losses = copper losses. For pure…

Q: For the network of Fig. 5.163, Determine Zi? 12 V VH B = 120 To = 40 ΚΩ Z₂ Select one: O a. Zi = 236…

A: It is given that:

Q: A d.c. circuit usually has .......... as the load Oresistance Oinductance Ocapacitance hoth…

A: We know that a simple DC circuit usually consists of a current source (Usually battery) and one or…

Q: Q2// Calculate the system response using:- a) Fourier Transform for the continuous signal shown in…

A: Given: Fourier transform of figure 1.

Q: A 3-phase 11kv generator feeds power to upf load of 100mw through 3-phase transmission line. The…

Question

11. Find the magnetic flux density when a flux is equal to 28 x 108 Maxwell is enclosed in an area of
15 cm².
kWb
a.
18.6667
m²
b. 186.6667
kWb
C.
1.8667
m2
kWb
d. 0.1867-
m²
kWb
m'

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step by step

Solved in 2 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

A coil of moving instrument is wound with 250 turns of wire. The flux density in the gap is 0.085 Tesla and the effective length of the coil side in the air gap is 5cm. Find the force doing acting on each coil side when carrying current of 60mA? In Dynes
F.) An iron core has a cross-sectional area of 10^(-3) square meter and mean circumference of 1 meter. The relative permeability of the material is 500 and the number of turns is 200. Determine the current required to set up a flux of 0.001 weber. a. 7.54 A b. 7.96 A c. 8.19 A d. 8.47 A
A magnetic coil produces 100,000 maxwell with 2000 turns and with a current of a 2A. The current is cut-off and the flux collapse in 0.01 sec. What is the average voltage that will appear across the coil?
Biot-Savart law expresses the magnetic flux intensity produced by a dc electrical current Select one: O a. True b. None of the above O c. False
Consider an iron ring of 10 cmdiameter is uniformly wounded with 3000 turns of wire. The coil current is 0.25 A and a flux density of 0.6 T is set in the ring. Determine the relative permeability of the iron and magnetic field strength.
A magnetic coil produces 100,000 maxwells with 2,000 turns and with a current of 2amperes. The current is cut off and flux collapses in 10ms. Determine the voltage acrossthe coil. Ans. 200V
A cylinder contains a polnt charge q at its center. If the electric flux through one of its caps is q/5Eo, What is the flux through the lateral surface of the cylinder? O a. 3q/5Eo O b. q/5E, Oc. zero O d. q/10E0 O e. 2q/5E0
A coil with 150 turns is wound over a 200 cm a cylinder iron core whose relative permeability is 250. If a current of 2 A is pass through the coil, determine the flux density in the core. a. 0.04 T b. 0.07 T c. 0.12 T d. 0.10 T
A rectangular coil of wire has a length of 3 cm and a width of 4 cm. It is in a 0.004 T magnetic field. What is the magnetic flux through the coil if the face of the coil is parallel to the B-field lines? What is the flux if the angle between the face of the coil and the magnetic field is 75°?
A magnetic flux density of 2.5 sin314t Tesla from the core with a cross section of 40 cm2 wandering. Accordingly, in 200 sipir and 45 sipir coils wrapped on the core Find the voltage that will occur.
PLEASE ANSWER IT ASAP FOR AN UPVOTE. THANK YOU. Round off your answer into four decimal places .Box your final answer .Use SI unit. A magnetic circuit consist of silicon having a cross section of 1.5 sq. m and 0.1 m length and an air gap of the same cross section and pf 0.02 m length. what is the field intensity at the air gap if 0.5 A current flows through the 5000-turns coil? Assume the permeability of silicon steel is 3000.
A coil of 250 turns is wound on a closed iron ring whose cross-sectional area is 20 cm² and mean length of 100 cm. Determine the energy stored in the magnetic field if a current of 2 A is passed through it. Assume the permeability if iron is 900. a. 2.83 J b. 3.12 J c. 2.03 J d. 1.88 J